Sony Speaker SRS D211 User Manual

2-593-588-11(1)  
Installing the satellite speakers  
(See fig. A)  
The satellite speaker can be used either placed on a desk  
or attached to a wall.  
Using the headphones/  
earphones  
Connect the headphones/earphones to the PHONES  
jack on the controller.  
C
PC, CD or MD  
Walkman, etc.  
Note  
When you use the satellite speaker on a desk  
(See fig. A-A)  
By attaching the stand to the satellite speaker, it can be  
placed on a desk.  
Turn off the MEGA BASS or BASS BOOST (Walkman,  
etc.) function as it may cause audible distortion.  
Active Speaker System  
POWER  
ON  
OFF  
VOLUME  
MIN  
MAX  
MAX  
BASS  
MIN  
PHONES  
Troubleshooting  
Should you encounter a problem with your speaker  
system, check the following list and take the indicated  
measures. If the problem persists, consult your nearest  
Sony dealer.  
1
2
Slide the stand into the slot at the  
Operating Instructions  
Mode d’emploi  
Manual de instrucciones  
bottom of the satellite speaker.  
The stand allows you to adjust the satellite  
speaker to the desired angle.  
Ensure the stands are locked.  
Push the stand into the slot until a “click” sound is  
heard.  
There is no sound from the speaker system.  
• Make sure all the connections have been correctly  
made.  
• Make sure the VOLUME dial and the each speaker’s  
volume dial on the controller have been turned up  
properly.  
SRS-D211  
Note  
Do not put your finger into the slot of the satellite  
speaker when you lock the stand. It may cause an  
injury to your finger.  
Subwoofer  
Controller  
• Make sure the connected component has been turned  
up properly.  
Front speaker (Left)  
2005 Sony Corporation  
Printed in Malaysia  
• Check if the headphones are connected. If they are,  
disconnect them.  
Front speaker (Right)  
The sound is distorted.  
• Turn down the volume level on the connected  
component. Or, if the connected component has a  
BASS BOOST function, set it to off.  
• Rotate BASS on this unit to reduce the bass volume.  
• Turn VOLUME on this unit down to reduce the  
volume.  
Printed on 100 % recycled paper using VOC  
(Volatile Organic Compound)-free vegetable oil based ink.  
D
POWER  
ON  
There is hum or noise in the speaker output.  
• Make sure all the connections have been correctly  
made.  
• Make sure none of the audio components are  
positioned too close to the TV set.  
POWER  
Package Contents  
OFF  
When you use the satellite speaker attached  
to a wall (See fig. A-B)  
The satellite speaker can be attached to a wall. Follow  
the Notes (below) to install safely. Improper installation  
may result in the speaker falling and causing bodily  
injury or damage to the speaker or other object.  
VOLUME  
MIN  
MIN  
MAX  
MAX  
VOLUME  
PHONES  
BASS  
The sound has suddenly stopped.  
Make sure all the connections have been correctly  
made.  
PHONES  
1
Secure the hollow wall anchor in the wall  
— refer to the illustration.  
The brightness of the POWER indicator is  
unstable.  
The brightness of the POWER indicator may become  
unstable when the volume is turned up. This is not a  
malfunction.  
Notes  
• Confirm wall thickness is sufficient. A  
minimum thickness of 9.5 mm is recommended  
for plasterboard.  
Controller  
Subwoofer with wired controller (1)  
• Use the specified clamp (hollow wall anchor,  
not supplied) when attaching to plasterboard.  
• Refer to the supplied operating instructions  
using a hollow wall anchor.  
VOLUME: Controls total volume level.  
BASS: Adjusts bass level (Subwoofer).  
Specifications  
PHONES: Connect the headphones for personal listening.  
Speaker section  
Satellite speaker  
Speaker system  
Speaker units  
Enclosure type  
Impedance  
• Use wall anchors of at least 20 kg hanging  
capacity.  
• Refer to the instruction supplied with hollow  
wall anchor.  
• Requires ø 4 mm hollow wall anchor.  
• Set up the head of a hollow wall anchor 5 mm  
from the wall.  
• Apply a bond (anaerobic threadlocking  
material) to the hollow wall anchor to prevent  
the screw loosening.  
Full range, magnetically shielded  
Satellite speaker (2)  
Stand (2)  
5.7 cm, cone type  
Closed type  
4 Ω  
On operation  
• Do not drive the speaker system with a continuous  
wattage exceeding the maximum input power of the  
system.  
• Before connecting, turn off the speaker system, the  
PC and audio component to avoid damaging the  
speaker system.  
English  
Cord length  
2 m  
A
Before operating the unit, please read this manual  
thoroughly and retain it for future reference.  
Subwoofer  
Speaker system  
Speaker units  
Enclosure type  
Impedance  
Woofer  
12 cm, cone type  
Bass reflex  
8 Ω  
• The volume level should not be turned up to the  
point of distortion.  
• Although this system is magnetically shielded, do not  
leave recorded tapes, watches, personal credit cards  
or floppy disks using magnetic coding in front of the  
system for an extended period of time.  
A
WARNING  
To prevent fire or shock hazard, do not expose the  
unit to rain or moisture.  
2
Attach the satellite speaker to the wall.  
Insert the wall anchor in the anchor hole of the  
satellite speaker.  
Amplifier section  
Rated output  
5 W (10% T.H.D., 1 kHz, 4 )  
(Satellite speaker)  
To avoid electrical shock, do not open the cabinet. Refer  
servicing to qualified personnel only.  
To prevent fire, do not cover the ventilation of the  
apparatus with news papers, table-cloths, curtains, etc.  
Do not place lighted candles on the apparatus.  
To prevent fire or shock hazard, do not place objects  
filled with liquids, such as vases, on the apparatus.  
,
25 W (10% T.H.D., 100 Hz, 8 )  
Notes  
(Subwoofer)  
Connecting cord with stereo mini  
plug (2m) × 1  
Stereo mini jack × 1 (INPUT 2)  
4.7 k(at 1 kHz)  
Stereo mini jack × 1 (PHONES)  
• Detach the stand from the satellite speaker  
before attaching to the wall.  
Input  
If the TV picture or monitor display is  
magnetically distorted  
Reverse the stand to  
change the speaker  
angle.  
• Ensure that the satellite speaker is securely  
attached to the wall before use.  
Input impedance  
Output  
Although this system is magnetically shielded, there may  
be cases that the picture on some TV sets/personal  
computers may become magnetically distorted. In such a  
case, turn off the power of the TV set/personal computer  
once, and after 15 to 30 minutes turn it on again. In the  
case of a personal computer, take appropriate measures,  
such as data storage, before turning it off.  
Satellite speaker  
Stand  
Do not install the appliance in a confined space,  
such as a bookcase or built-in cabinet.  
General  
This warranty is valid only in the United States.  
Dimensions (w/h/d) Approx. 50 × 140 × 99 mm  
Hooking up the system  
(See fig. B)  
(2 × 5 5  
Approx. 98 × 124 × 84 mm  
(3 7 × 5 × 3 3  
in.) (Satellite speaker,  
on a desk)  
Approx. 98 × 98 × 83 mm  
(3 7  
in.) (Satellite  
/
8
× 4 in.) (Controller)  
Anchor hole  
CAUTION  
You are cautioned that any changes or modification not  
expressly approved in this manual could void your  
authority to operate this equipment.  
/
8
/
8
B
When there seems to be no improvement, locate the  
system farther away from the TV set/personal  
computer. Furthermore, be sure not to place objects in  
which magnets are attached or used near the TV set/  
personal computer, such as audio racks, TV stands, toys  
etc. These may cause magnetic distortion to the picture  
due to their interaction with the system.  
Hollow wall anchor  
(ø 4 mm, not supplied)  
1
2
Connect the satellite speakers to the  
/
8
× 3 7  
/
8
× 3 3  
/
8
subwoofer.  
Confirm the location of the satellite speakers, and  
then connect to their respective jacks.  
speaker, attached to a wall)  
NOTICE FOR THE CUSTOMERS IN THE USA  
Approx. 163 × 267 × 301 mm  
(6 1  
/
2
× 10 5  
/
8
× 11 7  
/8  
in.) (Subwoofer)  
Mass  
Approx. 134 g (5 oz.) (Controller)  
Approx. 294 g (10 oz.)  
(Satellite speaker)  
Connect the controller to the source  
equipment.  
– PC, etc.:  
Connect the controller and the LINE OUT or  
headphones jack of a PC, etc. with the connecting  
cord (connected with the controller). For details,  
refer to the operating instructions of the PC.  
Approx. 4.2 kg (9 lb. 4 oz.)  
(Subwoofer)  
2 m (Controller to subwoofer)  
2 m (Power cord)  
On placement  
,
• Do not set the speakers in an inclined position.  
• Do not leave the system in a location near heat  
sources, or in a place subject to direct sunlight,  
excessive dust, moisture, rain or mechanical shock.  
• Do not install the satellite speaker anywhere other  
than on a wall.  
Cord length  
Power consumptions  
18 W  
Optional accessories  
– CD/MD Walkman, etc.:  
5 mm  
Connecting cord RK-G136, RK-G138  
Plug adaptor PC-236MS  
This symbol is intended to alert the user to  
the presence of uninsulated “dangerous  
voltage” within the product’s enclosure  
that may be of sufficient magnitude to  
constitute a risk of electric shock to persons.  
Connect the INPUT 2 jack of the controller and the  
LINE OUT or headphones jack of a CD/MD  
Walkman, etc. The connecting cord is not supplied  
with this system.  
• Do not hang anything on the satellite speaker.  
Note  
Note  
Do not hang anything on the  
satellite speaker.  
First, be sure to apply a bond  
(anaerobic threadlocking material)  
to the hollow wall anchor to  
prevent the screw loosening.  
ø 7 mm  
Design and specifications are subject to change without  
notice.  
On cleaning  
Do not use alcohol, benzene, or thinner to clean the  
cabinet.  
Note  
ø 4 mm  
Turn on either of the connected equipment to  
listen to its sound.  
This symbol is intended to alert the user to  
the presence of important operating and  
maintenance (servicing) instructions in the  
literature accompanying the appliance.  
If you have any questions or problems concerning your  
speaker system, please consult your nearest Sony  
dealer.  
3
4
Connect the subwoofer to the wall  
outlet.  
9.5 mm or more  
Position the speakers. (See fig. C)  
Precautions  
On safety  
The nameplate indicating operating voltage, power  
consumption, etc., is located on the rear exterior.  
• Before operating the system, be sure that the  
operating voltage of the system is identical with that  
of your local power supply.  
Listening to the sound (See fig. D)  
B
First, turn down the volume on the controller. The  
volume should be set to minimum before you begin  
playing the programme source.  
Satellite speaker  
(rear)  
to LINE OUT or  
Where purchased  
U.S.A./Canada  
Operating voltage  
120 V AC, 60 Hz  
headphones jack  
(stereo mini-jack)  
1
Set the POWER switch to ON on the  
controller.  
The POWER indicator lights up.  
European countries 220 – 230 V AC, 50 Hz  
Other countries  
• 120 V AC, 60 Hz  
• 220 – 230 V AC, 50 Hz  
CD/MD Walkman*, etc.  
2
Turn on the desired equipment  
connected to the controller.  
• The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the wall  
outlet, even if the unit itself has been turned off.  
• Unplug the system from the wall outlet if it is not to  
be used for an extended period of time. To disconnect  
the cord, pull the cord by grasping the plug. Never  
pull the cord itself.  
• Should any liquid or solid object fall into the system,  
unplug the system’s power cord and have the system  
checked by qualified personnel before operating it  
any further.  
• The AC power cord should be changed only at a  
qualified service shop.  
• For efficient heat dissipation, ensure there is sufficient  
space to the rear of the subwoofer. Also, avoid  
placing objects on the unit.  
to INPUT 2  
jack  
to FRONT L jack  
to FRONT R jack  
Connecting cord  
(not supplied)  
Note  
Do not turn on both connected equipments as it  
may cause double sound.  
Connecting cord  
(connected with controller)  
3
Adjust the VOLUME control on the  
Controller (rear)  
controller.  
You can adjust the volume of the subwoofer and  
each satellite speaker.  
Subwoofer (rear)  
When connecting to the headphone output, also  
adjust the volume of the connected component.  
After listening, set the POWER switch to OFF.  
The POWER indicator goes off.  
to LINE OUT or  
headphones jack  
PC, etc.  
• Do not insert your hand or any objects into the hole  
of the subwoofer.  
to wall outlet  
*
“WALKMAN” is a registered  
trademark of Sony Corporation to  
represent Headphone Stereo products.  
 

Sharp Flat Panel Television LQ201U1LW01 User Manual
Sharp Satellite TV System LC 22AA1M User Manual
Singer Sewing Machine U843A User Manual
Soho Network Card NCB100 User Manual
Sony Headphones MDR IF130K User Manual
Sony Stereo Receiver 4 184 692 111 User Manual
Sony Video Games 22026 User Manual
Stanley Black Decker Crib Toy CT04 User Manual
Suunto Scuba Diving Equipment SS005502000 User Manual
Tanaka Brush Cutter SUM 321 User Manual