V1643
Actual product may vary from the photos.
Please keep this instruction sheet for future reference,
as it contains important information.
Requires six "AA" (LR6) alkaline batteries
(not included) for car operation.
Adult assembly is required.
Tool required for battery installation:
Phillips screwdriver (not included).
This product is not recommended for use
on loose dirt or wet surfaces.
Assembly
Each track piece has a number on the bottom. Simply match the numbers
and fit the pieces together! For best performance, we suggest assembling the track on a hard, flat surface.
Fit the barrels into the sockets
on the start track.
Fit the billboard posts into the
sockets in the track.
Fit the tunnel onto the bridge track.
Fit the flags into the small sockets and
the sign into the large sockets in the
top of the tunnel.
Fit the billboard posts into the sockets
in the track.
2
3
Battery Installation
Battery Safety
Information
1,5V x 6
"AA" (LR6)
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
•Locate the battery compartment door
on the bottom of each car.
•Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
•
Insert three "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
•Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
•If the toy begins to operate erratically,
you may need to reset the electronics.
Slide the power switch off and then
back on.
•When sounds or motions from the car
become faint or stop, it’s time for an
adult to change the batteries!
•Protect the environment by not
disposing of this product with
household waste (2002/96/
EC). Check your local authority
for recycling advice and facilities
(Europe only).
5
Race to Win!
1
3
• Slide the power switch on the bottom of
• Lift the both starting gates on the track.
• Set the cars on the arrows behind the
starting line.
each car ON
.
•When both cars are ready, press the
pedal and you're off.
Hint: After shaking a car, place it
anywhere on the track and watch it go.
Fun sound effects and lights add
to the excitement!
•When your car stops, pick it up, shake it
and set it down again to rejoin the race.
•When you're finished playing, slide the
power switch on each car OFF
.
Hint: You can also race your cars on any
smooth, flat surface. Shake the car, set it
down and let it go.
2
• Shake a car to start the "engine" and
the sound effects.
Hint: For maximum distance, shake the
car 7 or 8 times. Shaking more than this
does not increase the distance
it will travel.
6
|