Fisher Price Baby Gym 71970 User Manual

71970  
Instructions  
Baby's Gym  
Toddler's First Piano  
.
Sparkling SymphonyGym  
 
Battery Replacement  
Arch  
Battery Compartment Door  
For best performance, we recommend  
replacing the batteries that came with  
this toy with three, new alkaline “AA”  
(LR6) batteries.  
• Locate the battery compartment on the arch.  
• Loosen the screws in the battery compartment door  
with a Phillips screwdriver and remove the door.  
• Insert three, new “C” (LR14) alkaline batteries.  
Hint: We recommend using alkaline batteries for  
longer battery life.  
• Replace the battery compartment door and  
tighten the screws with a Phillips screwdriver.  
Do not over-tighten.  
• When sounds or lights from this toy become  
faint or stop, it's time for an adult to change  
the batteries!  
3
 
Battery Safety Information  
1.5V x 3  
“C” (LR14)  
SHOWN ACTUAL SIZE  
Batteries may leak fluids that can cause a  
chemical burn injury or ruin your toy. To avoid  
battery leakage:  
• Do not mix old and new batteries or batteries of  
different types: alkaline, standard (carbon-zinc)  
or rechargeable (nickel-cadmium).  
• Insert batteries as indicated inside the battery  
compartment.  
• Remove batteries during long periods of non-  
use. Always remove exhausted batteries from  
the toy. Dispose of batteries safely. Do not  
dispose of batteries in a fire. The batteries may  
explode or leak.  
• Never short-circuit the battery terminals.  
• Use only batteries of the same or equivalent  
type, as recommended.  
• Do not charge non-rechargeable batteries.  
• Remove rechargeable batteries from the toy  
before charging.  
• If removable, rechargeable batteries are used,  
they are only to be charged under  
adult supervision.  
4
 
Baby Gym  
1
Threaded Knob  
Joint  
Hole  
Opening  
Leg  
Button  
One-time Assembly  
• Position one of the joints front side up.  
• Position a threaded knob with the peg side down.  
• Insert and snap the threaded knob into the upper  
hole in the joint.  
• Insert a right and left leg (marked R or L on each  
leg) into the slots on the joint. Make sure the  
buttons on the legs fit into the circular openings  
in the joints.  
• Repeat this procedure to attach the other threaded  
knob and two legs to the remaining joint.  
5
 
Baby Gym  
2
Threaded Knob  
Keys  
Arch  
Leg Assembly  
• Position the arch so that the keys are facing you.  
• Fit one end of the arch to the threaded knob on  
a leg assembly.  
Turn the threaded knob clockwise to attach the  
leg assembly to the arch. Make sure the  
knob is fully tightened.  
• Repeat this procedure to attach the other leg  
assembly to the arch.  
6
 
Baby Gym  
3
Upper  
Groove  
Hanger  
Groove  
Lower  
Groove  
• Rotate the hanger on the  
back of the arch down.  
• Fit the T-end of one of the  
hanging toys (star, sun  
T-End  
or moon) into a groove in  
the front side of the hanger.  
Pull the hanging toy down  
to “snap” it into place.  
Hint: The hanging toys can be attached to the  
hanger at two different levels! Select the appro-  
priate groove so that your baby can reach and  
activate sounds and lights!  
• Repeat this procedure to attach the other two  
hanging toys to the hanger.  
7
 
Baby Gym  
Power Switch  
4
Magic Star  
Volume Switch  
Volume Switch  
Star  
Ring  
Stars  
• Attach the stars to the bottom of the sun.  
• Attach the star ring to the bottom of the moon.  
• Slide the power switch to  
. Baby will enjoy  
••  
approximately 10 minutes of music and  
dancing lights when one of the toys is tapped.  
• Adjust the volume to a comfortable listening  
level. Slide the switch to  
for high volume.  
for low volume and  
• Slide the power switch to . Baby enjoys one  
song and twinkling lights when any one of the  
toys is tapped.  
• Press the magic star to hear a magical sound!  
• Slide the power switch to to turn off sound  
and lights.  
Note: To re-assemble this toy for use as a piano,  
simply turn the knobs on the leg assemblies  
counter-clockwise and remove the arch. Follow  
the instructions beginning on page 9, step 2.  
8
 
Toddler Piano  
Threaded Knob  
Joint  
1
Hole  
Opening  
Leg  
Button  
One-time Assembly  
• Position one of the joints front side up.  
• Position a threaded knob with the peg side down.  
• Insert and snap the threaded knob into the upper  
hole in the joint.  
• Insert a right and left leg (marked R or L on each  
leg) into the slots on the joint. Make sure the  
buttons on the legs fit into the circular openings  
in the joints.  
• Repeat this procedure to attach the other threaded  
knob and two legs to the remaining joint.  
Arch  
2
Hanger  
• Remove the hanging toys from the hanger.  
• Rotate the hanger up and "snap" it to the arch.  
9
 
Toddler Piano  
Keys  
3
Threaded Knob  
Arch  
Leg Assembly  
• Position the arch so that the keys are upright.  
• Fit one end of the arch to the threaded knob  
on a leg assembly.  
Turn the threaded knob clockwise to attach the  
leg assembly to the arch. Make sure the  
knob is fully tightened.  
• Repeat this procedure to attach the other leg  
assembly to the arch.  
10  
 
Toddler Piano  
Leg  
Assembly  
4
Grooves  
T-End  
Moon  
• Fit the T-end of a hanging toy into either groove  
in either leg assembly.  
• Pull the hanging toy down to "snap" it into place.  
5
Leg  
Assembly  
Star  
Star  
Star Ring  
• Attach the stars to the leg assembly as shown.  
• Attach the star ring to either leg assembly.  
11  
 
Toddler Piano  
6
Keys  
Magic  
Star  
Volume Switch  
Power Switch  
Volume Switch  
• Slide the power switch to  
. Press any of the  
••  
keys to hear a part of a song and see a twinkling  
light. After the music stops, press another key to  
hear the next part of the song and see more  
lights.  
• Adjust the volume to a comfortable listening  
level. Slide the switch to  
for high volume.  
for low volume and  
• Slide the power switch to . Press any key to  
hear a musical note and see a twinkling light.  
• Press the magic star to hear a magical sound!  
• Slide the power switch to to turn off sound  
and lights.  
Note: To re-assemble this toy for use as a gym,  
simply turn the knobs on the leg assemblies  
counter-clockwise and remove the arch. Follow  
the instructions beginning on page 6, step 2.  
12  
 
Care  
• Wipe all parts of this toy with a clean cloth  
dampened with a mild soap and water solution.  
Never immerse this toy.  
• Keep this toy away from direct sunlight and  
other sources of heat.  
• This toy has no consumer serviceable parts.  
Do not take this toy apart.  
13  
 
Consumer Information  
Questions? We'd like to hear from you!  
Call Fisher-Price® Consumer Relations, toll-free at  
1-800-432-KIDS (5437), 8 AM - 6 PM EST  
Monday through Friday. Hearing-impaired  
consumers using TTY/TDD equipment, please call  
1-800-382-7470. Or, write to: Fisher-Price®  
Consumer Relations, 636 Girard Avenue, East  
Aurora, New York 14052.  
For countries outside the United States:  
CANADA: Questions? 1-800-567-7724. Mattel Canada Inc.,  
6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.  
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park,  
Maidenhead SL6 4UB. Helpline: 01628 500302.  
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street,  
Locked Bag #870, Richmond, Victoria 3121 Australia.  
Consumer Advisory Service 1300 135 312.  
NEW ZEALAND: 16-18 William Pickering Drive,  
Albany 1331, Auckland.  
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance  
Centre, Harbour City, Tsimshatsui, HK, China.  
14  
 
FCC Note (United States Only)  
Note: This equipment has been tested and  
found to comply with the limits for a Class B  
digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide rea-  
sonable protection against harmful interference  
in a residential installation. This equipment gen-  
erates, uses and can radiate radio frequency  
energy and, if not installed and used in accor-  
dance with the instructions, may cause harmful  
interference to radio communications. However,  
there is no guarantee that interference will not  
occur in a particular installation. If this equipment  
does cause harmful interference to radio or tele-  
vision reception, which can be determined by  
turning the equipment off and on, the user is  
encouraged to try to correct the interference by  
one or more of the following measures:  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment  
and receiver.  
• Consult the dealer or an experienced radio/TV  
technician for help.  
Note: Changes or modifications not expressly  
approved by the manufacturer responsible for  
compliance could void the users authority to  
operate the equipment.  
15  
 
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.  
©2004 Mattel, Inc. All Rights Reserved. ® and ™ designate  
U.S. trademarks of Mattel, Inc.  
 

EFJohnson Two Way Radio High Tier User Manual
Electrolux Range 316471400 User Manual
ETI Sound Systems INC Stereo Amplifier AT 212 User Manual
Extron electronic Power Supply P S 150 User Manual
EZQuest DVD Player DVD Duplication User Manual
Fagor America Dishwasher LFA 75IT User Manual
Fostex Portable Speaker FE167E User Manual
Fundex Games Games Timber Tumble User Manual
Fusion Car Amplifier CP AW1120 User Manual
Garmin All in One Printer PRO 4900 User Manual