Fusion Car Amplifier CP AW1120 User Manual

ACTIVE WEDGE  
CP-AW1120, CP-AW2120  
SPECIFICATIONS  
CP-AW1120  
CP-AW2120  
900  
Peak Power (Watts)  
Rated Power (Watts)  
Frequency Response  
Low Pass Filter (Variable)  
Tuning  
750  
250  
300  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
12”  
32Hz - 250Hz  
40Hz - 250Hz  
Bass Reflex  
Dual 12”  
Woofer Size  
Fuse  
25A  
30A  
Dimensions (mm)  
567(l) x 415(w) x 384(h)  
22-5/16 x 16-11/32 x 15-3/32” 32-29/32 x 16-11/32 x 15-3/32”  
836(l) x 415(w) x 384(h)  
DISCLAIMER  
Always ensure the Active Wedge is securely attached, to avoid movement. FUSION accepts no responsibility for damage or injury in relation  
to inappropriate securing of this product.  
CONTROL DESCRIPTIONS  
WIRING  
• Connect the ground wire to the vehicle first (clean dirt and paint  
to bare metal).  
• Connect the remote on (blue wire).  
• Connect the RCA cables if applicable, OR  
• Connect the speaker level wire by splicing into the headunits  
speaker wires. See Note 1 on reverse.  
LEVEL  
This allows the adjustment of the amplifier level of the subwoofer.  
Turn clockwise to increase the level. If the sound becomes distorted  
reduce the level.  
LOW PASS FILTER (LPF)  
• Connect the remote level controller with the supplied lead.  
• Connect the 12 volt (red wire) to the positive battery terminal.  
• Check all connections.  
This allows the adjustment of the highest frequency the Active  
Wedge will produce. This should be adjusted to blend with your main  
speakers. Typically, this will be set to around 100Hz (approximately  
the central position of the control knob).  
REMOTE LEVEL CONTROLLER  
When connected, this allows further control over the level from a  
remote location, using the supplied lead.  
INSTALLATION  
Make sure the Active Wedge is firmly fixed in your vehicle. Check  
before drilling or cutting holes. DO NOT work near gas tanks, fuel  
lines, hydraulic lines or electrical wiring.  
DO NOT mount the Active Wedge in such a way as to pinch or  
damage the wires.  
Make sure everything is firmly connected, before attaching the  
+12V wire. Ensure the +12V wire is fused as close as possible to the  
battery. Always use a fuse with the recommended rating.  
 

Eclipse Fujitsu Ten Automobile Electronics BEC105 User Manual
Fellowes Paper Shredder P50CM User Manual
Fender Stereo Amplifier Twin Amplifier User Manual
Fisher Price Baby Toy H0675 User Manual
Fisher Price Battery Charger H7455 User Manual
Fostex DVD Recorder PD204 User Manual
Frigidaire Ventilation Hood PL36PC50EC User Manual
Fundex Games Board Games Chuck O Pro User Manual
Fundex Games Board Games Shake User Manual
Furuno TV Converter Box AD 10S User Manual