A
B
C
Operating Instructions
Mode d’emploi
Modo de empleo
Model/ Modèle/ Modelo:
GXL 125
For Use With Hot Pouches
Operation
1. Before turning power switch on, verify that the
Foam Board\Pouch Selector is positioned correctly
in the “Pouch” location.
2. Turn power on by positioning On/Off switch in the
“Heat Only” location. This will allow the machine
to pre-heat without engaging the laminating
rollers.
A key feature and added benefit of the GXL 125
allows you the versatility of laminating both Foam
Boards and Hot Pouches.
To Start
• Place the laminator on a sturdy, flat work surface.
Allow ample clearance behind the laminator for
laminated items to exit completely.
NOTE: During first usage, a small white puff of smoke
may appear which is common to a new laminator.
• Plug the laminator into a power source that
matches the laminator’s rate of voltage.
NOTE: Fluctuating voltage may cause inconsistent
lamination or mechanical problems with the laminator.
If you suspect voltage problems, use a voltage
stabilizer.
3. Adjust the temperature control to correspond with
pouch thickness.
4. Wait 2-3 minutes for green ready light to
illuminate. This indicates laminator is ready for
use.
5. Place item to be laminated into a Fellowes’
laminating pouch. Center the item for an even
border; a border of approximately 1/8" to 1/4" is
recommended.
6. Place pouch into carrier. (Optional, but
recommended)
7. Insert the carrier, sealed edge first, slowly into the
front loading area of the laminator until it
engages with the machine.
8. The finished laminated item will automatically exit
at the rear of the machine. After the carrier has
stopped moving, place it on a flat surface and
allow to cool for one minute.
9. Remove laminated item from carrier.
10. Turn the laminator off and unplug after
completion of usage.
For Use With Foam Boards
1. Before turning power switch on, verify that the
Foam Board\Pouch Selector is positioned correctly
in the “Foam Board” location.
2. Turn power on by positioning On/Off switch in the
“Heat Only” location. This will allow the machine
to pre-heat without engaging the laminating
rollers.
NOTE: During first usage, a small white puff of smoke
may appear which is common to a new laminator.
3. Adjust temperature control to the foam board
setting.
4. Wait 2-3 minutes for green ready light to
illuminate. This indicates laminator is ready for
use.
5. Place item to be laminated onto a Fellowes’ foam
board by raising laminate cover sheet and
inserting document. Center the item for an even
border; a border of approximately 1/8" to 1/4"
is recommended.
6. Initiate laminating rollers by moving selector to
“Heat and Rollers” setting.
7. Insert the foam board, sealed edge first, slowly
into the front loading area of the laminator until it
engages with the machine.
NOTE: Heat source located on top of machine. For best
results, feed foam board with item to be laminated
facing top.
A
B
C
8. The finished laminated item will automatically exit
at the rear of the machine. After the foam board
has stopped moving, place it on a flat surface and
allow to cool for one minute.
9. Mount easel or hang tab to back of foam board, if
desired.
10. Turn the laminator off and unplug after
completion of usage.
3
Specifications
GXL 125
Electrical:
120V
Machine Dimensions :
H x W x D
Machine Weight:
Maximum Foam Board/Pouch Thickness
Maximum Foam Board/Pouch Width:
Maximum Pouch Thickness:
Maximum Pouch/Document Thickness:
Warm-Up Time:
5-1/8" x 22-3/4" x 10-1/4"
(130mm x 578mm x 260mm)
12 lbs. (5.5 kg)
(5mm)
12" (305mm)
10 mil
5/64" (2mm)
2-3 minutes
Carrier:
Optional for hot pouches
but recommended.
Not required for foam boards
Limited Warranty
Fellowes Manufacturing Company warrants all Laminating Machines to be free from defects in material and
workmanship for a period of one year from the date of purchase by the original consumer. The exception to this
are the rollers which are subject to wear. If any part is found to be defective during the warrant period, your
sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling or unauthorized repair. ANY IMPLIED WARRANTY,
INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN
DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for
any consequential or incidental damages attributable to this product. This warranty gives you specific legal
rights. You may have other legal rights which vary from state to state. To obtain service under this warranty on
machines purchased in the USA, return the machine prepaid to the address below. Please allow two weeks for
processing.
A
B
C
Return with machine:
• Copy of original sales receipt.
• A card stating your name, address, daytime telephone number, machine model and serial number, plus a brief
description of the problem.
For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact
the appropriate location listed below.
Warrantor: Fellowes Manufacturing Company
4
Contact For Service
Vos Contacts Fellowes
Sus Contactos Fellowes
United States
Australia
1-800-955-0959
(In Melbourne) (03) 9330-3211
(Outside Melbourne) 1-800-331-177
1-800-665-4339
Canada
United Kingdom
Japan
01302-885 331
+81-3-5496-2401
Benelux
Italia
+31-(0)347-377988
+39-071730041
Deutschland
France
+49-5131-49770
+33-(0)4-72-08-25-45
1789 Norwood Avenue, Itasca, Illinois 60143-1095 630-893-1600 Customer Service 1-800-945-4545 http://www.fellowes.com
Australia
Benelux Canada
France
France
Deutschland Italia
Japan United Kingdom
Tullamarine, Vic. Vianen, NL Markham, Ont. Montanay Rennes, I-L Garbsen, Han. Camerano, AN Tokyo Doncaster, S. Yorks.
Part No. 70987
© 2000 Fellowes Printed in China
|