ISOLATOR
TECHNOLOGY
Home Cinema Surge Protector
with Isolator Technology
User Manual
F9A1033-12
F9A833-10
Installation of the PureAV Isolator
1) Turn OFF all of your electronic equipment and ensure that the PureAV
Isolator is also switched OFF.
2) Plug your electronic devices into the Isolator’s AC outlets.
Note: DO NOT USE two-wire extension cords or adapters with this
product. Using any extension cord in conjunction with the Belkin
PureAV Isolator will void all Belkin Corporation warranties. All
connected equipment should be plugged directly into your Belkin
PureAV Isolator.
3) Satellite Components: Connect the coaxial cable line from the satellite
source to the Isolator’s satellite connector marked “IN”. Use a second
coaxial cable to connect the Isolator’s cable connector marked “OUT” to
the appropriate input on your satellite device.
4) Coaxial/Antenna: Connect the coaxial cable line from the cable/antenna
source to the Isolator’s cable/antenna connector marked “IN”. Use a
second coaxial cable to connect the Isolator’s cable/antenna marked
“OUT” to the appropriate input on your cable or antenna device.
5) Phone/Fax/Modem Data Connections: Connect a modular phone cord
from the wall jack to the Isolator’s phone jack marked “IN”. Use a
second modular phone cord to connect to the phone line jack marked
“IN” on the phone to the Isolator’s phone jack marked “OUT”.
[Each PureAV Isolator model comes with solid-state, phone/fax/modem,
Internet-ready (RJ11 jack) surge protection with a built-in phone line splitter.]
If desired, use a third modular phone cord and connect your computer
modem data line jack marked “IN” with the Isolator’s other phone jack
marked “OUT”. Or you can connect a second data line device of your
choice (fax, etc.).
Note: If you fail to connect the phone/fax/modem protection, the
Connected Equipment Warranty will not cover your connected
equipment with telecom ports. Most modem damage can be prevented
if you take the time to connect the phone/fax/modem protection.
6) Your PureAv Isolator should be plugged into a grounded wall outlet
(3-conductor, 120V AC/60Hz) only.
2
Features
The PureAV Isolator comes with three Diagnostic Indicators, plus an Amber
Master Switch light. When you plug the unit into a live, 120V AC/60Hz
outlet, these lights let you know that protection is activated and warn of a
power problem before you connect your equipment.
Protection (Yellow)
indicates your surge protection is functioning properly.
Line OK (Green)
indicates line integrity.
Line Fault (Red)
indicates wall outlet in use has existing ground fault, or is
improperly wired.
Protection (Yellow): This light should come on when the unit’s power
switch is turned to the “ON” position. If this light goes out at any time, it
means that your surge protector has “sacrificed itself” to protect your
equipment and should be replaced. Please contact Belkin Corporation for a
free surge protector replacement.
Line OK (Green): This light should also come on when the power switch is
turned on. It shows that 120V AC power is present with no wiring faults
and it is safe to plug and use connected equipment.
Line Fault (Red): If on, this light indicates that a wiring fault has been
detected. This may be the result of a lack of grounding or reversed phases,
among other problems. A qualified electrician should be notified so that
the problem can be corrected before plugging in devices.
Master (Amber): This on/off switch provides a built-in, automatic
shutdown, 15-Amp circuit breaker. The light should come on when the unit
is plugged into a 120V AC/60Hz outlet and switched to the “ON” position.
Important: If the current draw exceeds 15 Amps for an elongated period of
time, the circuit breaker will shut down the surge protector power to
prevent damage. Allow a brief time for the Isolator to cool before resetting
the circuit breaker switch. (To reset, simply press the switch.)
Isolator Technology: As mentioned earlier, this design prevents devices
that are plugged into a given receptacle bank from transferring
contamination to a device plugged into another receptacle bank. Each pair
of receptacle banks is isolated from the other pairs within the PureAV
Isolator. (The 10-outlet PureAV Isolator has five pairs of PFT receptacle banks.)
The PureAV Isolator provides increasing levels of protection and filtration
from surges, spikes, lightning strikes, and EMI/RFI. When AC power travels
from the wall outlet and throughout each successive pair of receptacle
banks, each power filter or “graduating filtration” level increases the
isolation, filtration, and protection for your most sensitive devices. The
higher receptacle banks (farthest from the power switch) will provide a
greater amount of surge and line-noise protection than the first receptacle
bank or the bank labeled “High Current Filter”. The “High Current Filter” is
designed to deliver the maximum current with the minimal filtration
required by amplifiers and powered subwoofers.
3
Features
Note: LEVEL 1 is capable of protecting any sensitive electronic device,
but you may wish to use it for devices that require high current power
and low filtration, like stereo amplifiers. Simply choose what devices
you desire to use and plug into the protection you need.
Cord Management: The power cord wraps around the surge unit and
snaps into the grooves along the sides for clutter-free cord management.
Wall Mounting: The Isolator is mountable using a No. 8-type screw size.
Simply measure and align the keyhole slots on the bottom of the unit over
the No. 8 screws and push into place. (Screws are not included.)
Belkin Connected Equipment Warranty
Belkin Corporation warrants to the original purchaser of any Belkin Surge
Protector for the life of the product, that the Surge Protector shall be free
of defects in design, assembly, material, or workmanship, and will repair or
replace, at its option, any defective product free of charge.
Belkin Corporation will repair or replace, at its option, any equipment that
is damaged by a transient voltage surge/spike or lightning strike, (an
“Occurrence”),
while properly connected through a Belkin Surge Protector to a properly
wired AC
power line with protective ground. (For models F9A833-10 and F9A1033-12,
the telephone line and the coaxial cable line must be properly connected
and installed, as determined by Belkin at its sole discretion.)
Important: If you are using an AC Surge Protector only that does not have
phone, network, or coaxial protection, the warranty is null and void if a
power disturbance damages your equipment through the phone, network,
or coaxial lines. You are only covered if the disturbance entered through
the AC lines.
This Connected Equipment Warranty is a Limited Warranty, subject to the
limitations and exclusions set forth herein. Belkin Corporation will spend,
to repair or replace the damaged connected equipment, at Belkin’s option,
an amount equal to the fair market value of the damaged equipment or
the original purchase price of the equipment, whichever is less, up to the
maximum amount set forth below:
All PureAV Isolators offer a $300,000 Connected Equipment Warranty.
The fair market value of the equipment shall be the current value of the
equipment specified in the most recent edition of the Orion Blue Book by
Orion Research Corporation, Roger Rohrs Publisher.
4
Belkin Connected Equipment Warranty
Belkin Corporation reserves the right to review the damaged Belkin Surge
Protector, the damaged equipment, and the site where the damage
occurred. All costs of shipping the Belkin Surge Protector and the
damaged equipment to Belkin Corporation for inspection shall be borne
solely by the purchaser. Belkin reserves the right to negotiate the cost of
repairs. If Belkin determines, in its sole discretion, that it is impractical to
ship the damaged equipment to Belkin Corporation, Belkin may designate,
in its sole discretion, an equipment repair facility to inspect and estimate
the cost to repair such equipment. The cost, if any, of shipping the
equipment to and from such repair facility and of such estimate shall be
borne solely by the purchaser. Damaged equipment must remain available
for inspection until the claim is finalized. Whenever claims are settled,
Belkin Corporation reserves the right to be subrogated under any existing
insurance policies the claimant may have.
*All above warranties are null and void if: the Belkin Surge Protector in use
during the Occurrence is not provided to Belkin Corporation for inspection
upon Belkin’s request at the sole expense of the purchaser, Belkin
Corporation determines that the Belkin Surge Protector has been
improperly installed, altered in any way or tampered with, Belkin
Corporation determines that the damage did not result from the
Occurrence or that no Occurrence in fact took place, the repair or
replacement of the damaged equipment is covered under a manufacturer’s
warranty, or Belkin Corporation determines that the connected equipment
was not used under normal operating conditions or in accordance with any
labels or instructions. All Belkin Surge Protectors must be plugged directly
into the power source and must not be “daisy-chained” together in serial
fashion with other power strips, UPSes, other surge protectors or
extension cords. A three- to two-prong adapter may not be used. Any such
installation voids the warranty. The Belkin Connected Equipment Warranty
only protects against damage to properly connected equipment where
Belkin Corporation has determined, in its sole discretion, that the damage
resulted from an Occurrence, and does not protect against acts of nature
(other than lightning) such as flood, earthquake, war, vandalism, theft,
normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage
due to low voltage disturbances (i.e. brownouts or sags), non-authorized
program, or system equipment modification or alteration. If you are using
an AC surge protector only that does not have phone, network, or coaxial
protection, the warranty is null and void if a power disturbance damages
your equipment through the phone, network, or coaxial lines. You are only
covered if the disturbance entered through the AC lines.
*Please note: This product is not for use with aquariums and all other
water-related products. Use only indoors and in dry locations.
This warranty contains the sole warranty of Belkin Corporation, there are
no other warranties, expressed or, except as required by law, implied,
including the implied warranty or condition of quality, merchantability or
fitness for a particular purpose, and such implied warranties, if any, are
limited in duration to the term of this warranty. Some states do not allow
limitations on how long an implied warranty lasts, so the
above limitations may not apply to you.
5
Belkin Connected Equipment Warranty
In no event shall Belkin Corporation be liable for incidental, special, direct,
indirect, consequential or multiple damages such as, but not limited to, lost
business or profits arising out of the sale or use of any Belkin Surge
Protector, even if advised of the possibility of such damages. This warranty
gives you specific legal rights, and you may also have other rights, which
may vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damage, so the above limitations
may not apply to you.
This warranty is valid only for the original purchaser of the product. All
damage claims against the product must be made within 15 days from the
date of the Occurrence and must be accompanied by a receipt for the
damaged equipment or the warranty is void. Warranty is valid in USA,
Canada, Puerto Rico, and Bermuda.
To file a claim against the Belkin Connected Equipment Warranty, you must
our claim form or write to us at Belkin Corporation, 501 W. Walnut St.,
Compton CA 90220 Attn: Technical Support, or call 310-898-1100,
extension 2263, within 15 days of the Occurrence. Be prepared to provide
the following information:
A. The part number of the Belkin Surge Protector.
B. The equipment that was connected to the Surge Protector at the time
of the Occurrence.
C. The equipment that was damaged during the Occurrence and the
extent of the damage.
D. The date of the Occurrence.
E. Where you purchased the Surge Protector.
F. When you purchased the Surge Protector.
G. Copy of original receipt.
Your Belkin Customer Service Representative will then instruct you on how
to forward your equipment, receipt, Belkin Surge Protector in use during
the “Occurrence” and how to proceed with your claim.
You may conveniently register your Belkin PureAV Surge Protector online
included with your PureAV purchase.
6
belkin.com
Belkin Corporation
Belkin Components, Ltd.
501 West Walnut Street
Compton • CA • 90220 • USA
Tel: 310.898.1100
Express Business Park • Shipton Way
Rushden • NN10 6GL • United Kingdom
Tel: +44 (0) 1933 35 2000
Fax: 310.898.1111
Fax: +44 (0) 1933 31 2000
Belkin Components B.V.
Belkin Ltd.
Starparc Building • Boeing Avenue 333 7 Bowen Crescent • West Gosford
1119 PH Schiphol-Rijk • The Netherlands NSW 2250 • Australia
Tel: +31 (0) 20 654 7300
Fax: +31 (0) 20 654 7349
Tel: +61 (0) 2 4372 8600
Fax: +61 (0) 2 4372 8603
© 2004 Belkin Corporation. All rights reserved. All trade names are
registered trademarks of respective manufacturers listed.
P74432-B
|