Ultra mobile SATA
Spinpoint N1C
Capacity
Model
80GB
120GB
HS08XJF
HS122JF
FEATURES
• MAX.60GB Formatted Capacity Per Disk
• SATA S.M.A.R.T Compliant
• SATA 48-bit Address Feature Set
• Multi-Burst On-The-Fly Error Correction
• SilentSeek™
• High Speed Digital Signal Processor Based Architecture
• Low Power HDC
• Advanced Power Management Control
• Fluid Dynamic Bearing Spindle Motor Technology
• Free Fall Sensor (optional)
DRIVE CONFIGURATION
ENVIRONMENTAL SPECIFICATIONS
Temperature
Capacity
80 / 120 GB
SATA 1.5Gbps
5400 RPM class
8 MB
Interface
Operating
5 ~ 60 ℃
Rotational Speed
Buffer DRAM Size
Byte per Sector
Non-operating
-40 ~ 85 ℃
Humidity (non-condensing)
Operating
512
8 ~ 90 ％
Non-operating
8 ~ 90 ％
PERFORMANCE SPECIFICATION
Average Seek time (typical)
Media Transfer Rate (Max.)
Interface Transfer Rate (Max.)
Drive Ready Time (typical)
Linear Shock (1/2 sine pulse)
Operating, 2ms
14.0 ms
550 Mb/s
1.5 Gbps
4.0 sec
600 G
Non-operating, 1ms
Vibration
1500 G
Operating
0.67 Grms
Altitude (relative to sea level)
Operating
RELIABILITY SPECIFICATION
Non-recoverable Read Error
Controlled Ramp Load/Unload
-300 to 3.000 m
-400 to 15,000 m
1 sector in 10^13 bits
600,000
Non-operating
PHYSICAL DIMENSION
Height
ACOUSTICS
Idle
8.0 mm
78.5 mm
54.0 mm
62 g
2.4 Bel
2.6 Bel
Width
Performance Seek
Length
Weight (Max.)
POWER REQUIREMENTS
Voltage
+3.3V ±5%
540 mA
1.30 W
Spin-up Current (Max.)
Seek (typical)
* Note : Design and specifications are subject to change without prior notice.
1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
Read/Write (typical)
Idle (typical)
1.60 W
0.40 W
* Accessible capacity may vary as some OS uses binary numbering system for
reported capacity.
Standby (typical)
Sleep (typical)
0.12 W
0.10 W
* A small portion of the (8MB) buffer memory is reserved for firmware use.
1.8" N1C SATA product specification Rev.08
Match with 1.8" N1C SATA product manual Rev.07
|