RocketFish Camera Accessories RF TRP65C User Guide

RF-TRP65C I Rocketfish 65" Carbon Fiber Tripod  
Quick Setup Guide  
One-year limited warranty  
Important safety instructions  
Package contents  
• Tripod with pan head  
• Mounting plate  
Note: mounting plate is  
on pan head.  
Make sure that all levers, handles, knobs, and leg locks  
are correctly tightened, and that all three legs are fully  
opened before use.  
Do not carry or transport the tripod with camera  
equipment attached (for example, over your shoulder  
or cradled in your arms).  
• Wrenches (2)  
• Handles (2)  
Do not store or expose your tripod to excessive heat or • Two center column end caps  
cold, or use near any flame or fire.  
Note: one is already attached  
Do not oil or grease any part of the tripod.  
to the center column.  
Do not use any solvents or thinners to clean your tripod. • Quick Setup Guide  
Use only a mild detergent and wipe dry with only a soft,  
lint-free cloth.  
Do not exceed the load limit of this product. Load limit  
is 17.6 lbs. (8 kg).  
Using your tripod  
To set up your tripod:  
1 Open the flip-lever leg locks on each leg (two per leg, for  
a total of six) and extend the legs to the desired length.  
2 Close the flip-lever leg locks to lock the legs at the  
selected length.  
Caution: Incorrectly securing a leg lock can cause the tripod  
leg to retract unexpectedly and could result in damage to  
the tripod or to the attached camera or camcorder.  
3 Press the variable leg angle release at the top of each  
tripod leg to spread the legs to the first preset angle.  
When each leg has been locked into the first preset  
angle, set the tripod on a firm surface.  
4 Adjust the center column by releasing the center  
column locking knob, raising the center column  
to the desired height, then tightening the center  
column’s quick-release clamp knob.  
5 To remove the mounting plate, press down on  
the quick-release clamp knob, then press the  
safety lock pin and lift the plate away from the head.  
6 Secure your camera to the mounting plate with the  
1/4" screw on the bottom of the plate. Tighten the  
screw firmly to avoid unintended lateral movement of your device.  
© 2009 Best Buy Enterprise Services, Inc. All rights reserved. ROCKETFISH is a trademark  
of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and  
brand names are trademarks of their respective owners.  
ENGLISH 09-0441  
 

Radio Shack Answering Machine TAD 1003 User Guide
Reebok Fitness Treadmill RBTL19990 User Guide
ResMed Oxygen Equipment Stellar 100 User Guide
RotoZip Saw DR1 User Guide
Runco Flat Panel Television CW 42HD User Guide
Samsung Projection Television ST 42W5P User Guide
Samsung Tablet GT P5113 User Guide
Sanyo Air Conditioner 42TH72R User Guide
Sanyo Vacuum Cleaner SC B550 User Guide
SATO Printer XL4xxe User Guide