Kambrook 461 Plummer Street, Port Melbourne 3207, Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513
JaguarVacuum
Cleaner
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/06
KVC30
Issue 1/06
To retract the cord push down on the
‘cord rewind’ pedal.
The dust bag indicator window will
gradually turn red as the bag fills up and
when the dust bag indicator displays ‘red’
it is time to change the dust bag.
When vacuuming fine dust particles, the
fine dust particles can clog the pores of
the dust bag and the dust bag indicator
will indicate full. If this happens the bag
could appear relatively empty, however
the bag will still need to be changed to
avoid strain on the motor.
UsingYour Kambrook Jaguar
Vacuum Cleaner
Remove all packaging from the unit, hose
and other accessories; ensure that you
have removed all of the accessories before
discarding the packaging.
IMPORTANT: HOLD THE PLUG END
WHEN RETRACTING THE CORD TO
PREVENT IT FROM STRIKINGYOU OR
THEVACUUM.
Always switch appliance off, then switch
off at the power outlet and unplug the
appliance prior to replacing dust bags or
filters.
ALWAYS ENSURETHATTHE
DUST BAG ANDTHE MOTOR
PROTECTION FILTER ARE
CORRECTLY FITTED. NEVER
OPERATE WITHOUTTHE DUST
BAG AND FILTERS IN PLACE.
Ensure that the dust bag and filters are
correctly fitted.
NOTE:The bag compartment lid may not close if
the bag is not correctly fitted.
To remove the dust bag, ensure the unit is
down on its wheels, remove the crush
proof hose and push the ‘Dust bag
compartment lid release lever’ underneath
the handle. Once the lid has released, pull
the top cover back.
Locate the crush proof hose and push the
connection point into the hose inlet
connection on the top of the unit, until a
“click” sound is heard.
IMPORTANT: DO NOT USE THE
UNIT WITHOUT A DUST BAG IN
PLACE
Replacing filters
Variable Power Control
Connect the wide end of the metal wand
to the hose end, and push together firmly.
Filters must be cleaned from time to time
to remove the fine dust particles that have
been collected.This can be done by
shaking them; however after
approximately 5 dustbag changes the
filters should be replaced.
The variable power control slide switch is
located on the top of the vacuum cleaner.
Slide the control to the rear for maximum
power for vacuuming hard floor and
carpet surfaces. Slide the control to the
To remove the bag, grasp the top of dust
bag and pull out. If you are using the cloth
bag dispose the dust in a rubbish bin. If
you are using a paper dust bag you can
dispose the bag with its contents in the
rubbish bin.
Fit the floor tool to the narrow end of
the wand/s and push together firmly.
Fully extend the power cord by pulling
the power plug (situated at the rear of the front at the minimum power level when
unit) out from the unit, until the yellow
tape on the cord is shown.
using the crevice and brush tools.
Motor protection filter
The motor protection filter must always
be in place when operating the vacuum
otherwise damage to the motor may
occur
Crevice and brush tool accessories
To place a new dust bag, take a fresh dust
bag and with the arrow (printed on the
material section of the dust bag) pointing
down slide the material down into the
dust bag holder, until it comes in contact
with the bottom of the holder.
The crevice tool is ideal for vacuuming
ENSURETHATYOU DO NOT
OVER EXTENDTHE POWER
CORD – DO NOT EXTEND PAST
THE RED WARNINGTAPE ON
THE CORD
hard to reach places such as the edges
along skirting boards.
The brush tools can be used to vacuum
delicate surfaces and areas such as shelves
and venetian blinds.
To replace the motor protection filter –
Remove the dustbag or pull the bag
forward.The motor protection filter is
located at the rear, right hand side of this
inner chamber. Pull the plastic filter holder
upward to remove.
Plug into a 230/240v power point and
switch the power on.
Set the variable speed control between
minimum and medium power when using
the tool accessories.
To commence vacuuming push down on
the on/off foot pedal, at the top, rear of
the unit.
Filter holder
Turn off the vacuum cleaner when
changing any attachments.
Dust bag holder
When vacuuming is complete, push down
on the ‘on/off’ pedal to switch off.Turn
the power off at the outlet and then
remove the power cord from the power
outlet (when removing plug from the
power outlet grasp the plug not the cord).
Dust bag indicator and changing the
dust bag
You have the option of using a Cloth bag
or a paper dust bag.
Filter holder
Removable filter
HINT: once the bag is inserted ‘puff-out’ the bag as
much as possible to ensure the full capacity of the
bag can be taken up.
The dust bag should be changed when full.
4
5
KAMBROOK
2YEAR REPAIR
WARRANTY
Care and Maintenance
Always switch appliance off, then switch
off at the power outlet and then unplug
the appliance prior cleaning or replacing
either filter.
KAMBROOK warrants the purchaser
against defects in workmanship and material, accessories only the defective accessory
If the product includes one or a number of
for a period of 2 years from the date
of purchase (3 months commercial use).
or product will be replaced.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practices Act 1974
and State Territory legislation.
Guarantee and purchase receipt for this
product are to be retained as proof
of purchase and must be presented
if making a claim under the terms of the
KAMBROOK guarantee.
Check and replace both the motor
protection and dust filters on a regular
basis.
For service, spare parts or product
information in Australia, please call
KAMBROOK on the customer Service
Line (free call) 1800 800 634.
KAMBROOK reserves the right to repair
the appliance within the warranty period.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions. Items subject to wear and
tear, such as filters, bags, accessories and
drive belts, are not covered by this
warranty.The guarantee excludes
For service, spare parts or product
information in New Zealand,
please call KAMBROOK New Zealand,
Greenmount, Auckland Phone 09 271 3980
Fax 0800 288 513. For spare parts phone
09 271 3980.
If claiming under this guarantee the product
must be returned to freight prepaid.
breakages and consumables.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
YOUR PURCHASE RECORD (Please complete)
Attach a copy of
purchase receipt here.
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ___________________________
6
|