Introduction
Thank you for purchasing this unit. This product is designed to provide high quality wireless
sound for your iPad, iPhone, iPod, computer, PDA or other Bluetooth audio device.
Along with the included Quick Bluetooth Connection Guide,this instruction booklet explains the
basic operation and care of the unit. Please read them carefully and keep for future reference.
Maintenance
• Place the unit on a level surface away from sources of direct sunlight or excessive heat.
• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth
or other protective material should be placed between it and the furniture.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning
agents, such as Benzene, thinner or similar materials can damage the surface of the unit.
Table of Contents
Meet Your Unit...................................................................................................1-2
Charging the Unit................................................................................................. 3
Using Bluetooth:Pairing Your Device......................................................................... 4
Playing Audio Via Bluetooth.................................................................................... 5
Using the Speakerphone........................................................................................ 5
Playing Audio Via Aux/ Troubleshooting .................................................................. 6
Consumer Product Safety Guide.............................................................................. 7
FCC Information
FCC ID:EMOIDM14 IC:986B-IDM14
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This Device complies with RSS-210 of the IC Rules; Operation is subject to the following two conditions:
(1) This device may not cause interference and
(2) This device must accept any interference received, including interference that may cause undesired
operation
This device complies with Part 15 of the FCC Rules, operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits
provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate
interference you can try one or more of the following corrective measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the radio or TV.
Use outlets on different electrical circuits for the equipment and the radio or TV.
Consult your dealer or an experienced radio/television technician if the problem still exists.
Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s
warranty and void your FCC authorization to operate it.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Internal Rechargeable Lithium-ion Battery
This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you
suspect your battery may be dead, try charging it several times. If the battery does not recharge, please contact
us for repair information.
WARNING/DISPOSAL OF UNIT
Please do NOT attempt to change the battery yourself. If the battery has died and you do not want us to replace your
battery, you should follow the disposal instructions below:
• Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.
• Always dispose of used batteries/electronics in accordance with the prevailing community regulations that apply
to the disposal of batteries/electronics. If there are no local regulations concerning battery/electronics disposal,
please dispose of the device in a waste bin for electronic devices.
• Many electronics retailers now recycle batteries and other electronic components at no charge. Check to see
which ones in your area do so.
CAUTION
The battery used in this device may present a risk of fire, explosion or chemical burn if
mistreated
• Never use or charge the battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
• Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other
electrolytic substance.
• Always confirm that the temperature is 5°C – 35° C (41° - 95° Fahrenheit) before you charge the battery.
Leakage or deterioration of the battery may occur if this warning is not heeded.
• Never expose the battery to any liquid.
• Never expose the battery to excessive heat such as direct sunlight or fire. Never use the battery pack in an
unventilated vehicle where excessive internal temperatures may be encountered.
• Always keep the battery out of the reach of infants and small children.
Meet Your Unit
Top/Front
Right Speaker
Volume Down Button
Power Button
Pairing Indicator Light
Bluetooth/Speakerphone/Play
/Pause Button
Power/Charging
Indicator Light
Built-in Microphone
(behind speaker grill)
Volume Up Button
Left Speaker
Rear of Speakers
Right Speaker
Micro USB
Charging/
Audio in Port
Line-in from
Right Speaker
Travel Lock/Aux/
Bluetooth Switch
Line-out to
Left Speaker
1
Meet Your Unit
Included
• iDM14 system (2 x speakers)
• 24 inch micro USB to USB/3.5 mm charging
and aux. audio cable
• 24 inch 3.5 mm stereo connection cable
Travel Lock:
a. Move the Travel Lock switch on the back of the right
speaker to the
position to temporarily disable the
unit and prevent accidental button activation during
travel that might drain the battery. Move switch to
Bluetooth or Aux position for normal operation.
2
Power/Charging
Charging the Unit
Indicator Light
1. Connect the micro USB plug to the micro
USB charging port on the back of the Right
speaker.
2. Connect the standard USB plug end of the
cable to a power USB port on a computer
or other USB charging device. For first
time use, charge unit for about 8 hours.
3. A blue light pulses slowly through the
button while the unit is charging
and glows steadily once unit is fully
charged.
NOTE: When unit is ON and not
connected to power source, flashing red
light indicates battery needs charging.
3
Using Bluetooth: Pairing Your Device
NOTE: See the iDM14 Bluetooth Connection Guide for complete pairing details.
1. Move the Travel Lock/Aux/Bluetooth Switch on the back of the right speaker to the
Bluetooth position (right).
2. Press and hold the Button to turn on the unit (release when light appears blue).
3. Turn on Bluetooth capability on your device and make it discoverable (see your device’s
instructions to add or setup a Bluetooth device).
4. Press and hold the Bluetooth/Speakerphone Button on the unit until a blue light flashes
on the button and the unit beeps twice to indicate pairing attempt. The blue light will flash
while the unit attempts to pair. If your device asks for a password, enter 1234 on the
keyboard of your device.If no device is paired within 2 minutes, the
red for 2 seconds and the unit will power off. If this occurs, retry steps 2-4.
5. Once paired with a device, the blue light will glow steadily. There should be an
Button will glow
indication on your device that pairing is complete. On some devices, you must then select
“use as a stereo audio device” or similiar on the device’s Bluetooth menu. Once paired,
your device should link to the iDM14 whenever within range.
4
Playing Audio Via Bluetooth
1. Move the Travel Lock/Aux/Bluetooth Switch to the Bluetooth position to listen to audio
streamed wirelessly from your paired iPad, iPhone, iPod or other Bluetooth device.
2. Connect the Left and Right speakers using the 3.5 mm stereo connection cable.
3. Press and release the
Button to turn on the unit. The blue
light will flash as the unit
searches for a previously paired device, and then turn solid blue when a previously paired
device is detected.
4. Press and release the
Button to play or pause audio from your Bluetooth device.
NOTE: Play/Pause only works in Bluetooth mode. It does not control aux line-in devices.
5. Use the Volume +/- Buttons to adjust volume.
6. When done listening, press the Button to turn the unit off.
Using the Speakerphone
1. Move the Travel Lock/Aux/Bluetooth Switch to the Bluetooth position to use the speakers as a
speakerphone for a linked Bluetooth-capable phone during an incoming or active call. The right speaker
(which contains the speakerphone mic) is muted during a speakerphone call; only the left speaker emits
audio.
2. Connect the Left and Right speakers using the 3.5 mm stereo connection cable.
Speakerphone cannot operate unless both speakers are connected together.
3. Press and hold the
Button to turn on the unit (release when blue light appears).
4. Use the Volume +/- Buttons to adjust volume. You may wish to adjust the volume on your audio device,
too.
5. When a call is received, playing music is muted to hear the ring tone. Press the green
answer the call, or press the red Button to ignore it.
Button or
Button to
6. When the call is completed, press the
function.
Button to end the call and resume previous
5
Playing Audio via Aux
1. Move the Travel Lock/Aux/Bluetooth Switch to the Aux position to listen to audio via aux line-in.
2. Connect the Left and Right speakers using the 3.5 mm stereo connection cable.
3. Connect the micro USB plug to the micro USB charging port on the back of the right speaker and
connect the 3.5 mm audio plug to the headphone or line-out jack on your audio device.
4. Press and hold the
Button to turn on the unit (release when blue light appears).
5. Use the Volume +/- Buttons to adjust volume. You may wish to adjust the volume on your audio
device, too.
6. When done listening, press and release the
your audio device, too.
Button to turn the unit off. Remember to turn off
Troubleshooting
Unit doesn’t respond (no power)
• Make sure unit is completely charged. Check that all connections are correct and properly plugged
in. Make sure your device is properly paired with the iDM14.
• Make sure the Travel Lock/Aux/Bluetooth Switch is not in the
position, as this will disable
operation.
Trouble pairing device/computer with iDM14
Bluetooth implementation varies depending on your computer’s hardware and operating system. Please
see our website for updates on pairing.
• Make sure you have the latest firmware for your iPad, iPhone or iPod (update via iTunes if needed).
• Make sure your device is working properly. Check your device’s manual for details on Bluetooth
pairing and linking.
For further information and to see the latest instructions, visit
6
Limited 90 Day Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from
defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period,
SDI Technologies will repair or, at its discretion, replace this product without charge (except for a $15.00 charge for handling,
packing, return UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this
product to the Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee
for service without proof of purchase is $40.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective
batteries are the most common cause of problems encountered.
If service is still required:
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period.
3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $15.00 ($40.00 without proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which
have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized
persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape
cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original
purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members
or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or
punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these
restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually
binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI Technologies
product.
© 2011 SDI Technologies, Inc. All rights reserved
iDM14-071211-A
Printed in China
|