Dual Electronic Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
WARNING!
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
Tools Supplied:
1 Allen Wrench
1 Phillips Screwdriver
1 Wrench 7/16
1 Wrench5/16
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO PROPERTY.
Tools Needed:
4 "D" Cell Batteries
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
1
11/03
P/N 211483E
© COPYRIGHT 2000 by HUFFY SPORTS
Get to know the basic parts of your basketball system.....
FRONT
BACKBOARD
RIMS
TARP
SUPPORT
POLES
3
11/03
P/N 211483E
PARTS LIST - (See Hardware Identifier)
Item Qty
1
P/N Description
200745 Net Hanger Tubes
2
2
2
1
1
2
2
2
1
2
2
2
1
1
1
2
2
1
2
4
1
2
6
8
8
2
3
4
5
6
7
8
9
200746 Board Mounting Vertical Support Tube
200747 Vertical Support Tube
200748 Horizontal Cross Tube
200749 Horizontal Cross Brace
200750 90 degree corner Back Leg Support Tube
200752 Floor Mounting Support Tube, Short
200753 Angle Corner, Front Leg Support Tube
200754 Horizontal Front-Ramp Support Tube
200755 Front Ramp Support Tube
200756 Ramp Support Tube, Long
200757 Back Ramp Support Tube
Wood Backboard
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
Ball Ramp With Side Netting
200760 Electronic Score Keeper
200761 Switch And Paddle Assm
200762 12" Tubular Rims
200763 Red Plastic Display Lens
200764 Nylon Net
7" Rubber Ball
200766 AC Adapter
200767 Metal Back Plate
200768 Plastic Tube Caps
200770 #10 x 1 Phillips Head Bolt
200771 #10 Hex Nut
16 200772 Black Plastic Net Clips
8
6
8
8
200773 ¼ x 3 ½ Socket Head Screws
200774 ¼ x 2 ½ Socket Head Screws
200775 ¼ x 3/8 Socket Head Screws
200776 ¼ x 1.0 Socket Head Screws
32 200777 ¼" Flat Washer
20 200778 ¼" Flange Nut
10 200779 Washer, M5
1
12 201936 Caps Screw
200780 Allen Wrench
1
1
200972 Phillips Screwdriver
203358 Air Pump and Needle
4
P/N 211483E 11/03
Attach rims (17) to backboard (13)
with bolts (30), back plates (22),
and nuts (32) as shown.
Attach score keeper (15) to backboard with bolts (24),
washers (33) and nuts (25). Attach lens (18) to front of
score keeper (15) as shown.
1.
2.
Repeat for opposite side.
25
32
13
15
22
17
24
30
18
33
Attach scoring paddles (16) onto backboard
below rims (17) with bolts (24) washers (33) and
nuts (25). Plug wires from paddles into scoring
unit as shown.
Attach nets (19) with net clips (26) as
shown. NET SHOULD REST IN SLOT
ON CLIP AS SHOWN FIG. B.
3.
4.
DO NOT ENTANGLE WIRES FROM PADDLE IN NET
17
26
24
16
25
33
33
19
FIG B.
33
16
25
24
33
5
11/03
P/N 211483E
Assemble upper framework (1, 2, 23).Secure ball ramp (14) to outer framework as shown Fig. A.
Insert tube (5) through top of ball ramp(14) and attach backboard assembly to tubes 1,2 and 5
with hardware as shown. Repeat for opposite side. Insert horizontal front ramp tube (9) through
bottom of ball ramp (14) as shown.
5.
Fig. A
5
35
1
32
31
1
23
2
2
14
31
28
4
3
28
9
6
P/N 211483E 11/03
Assemble lower framework (6, 7, 8) using bolts (29) and washers (31). Attach to upper framework
as shown. Repeat for opposite side.
6.
3
29
9
31
6
7
8
Assemble side rails (10, 11, 12) using bolt (29) and
washer (31). Install tube caps (23) as shown.
7.
Attach side rails using bolt (27) washer (31),
nut (32) and screw caps (35) as shown.
Repeat for opposite side.
12
29
31
27
23
10
11
35
31
32
23
IMPORTANT!:
35
Connect side rails
so that bolt heads
face inward.
32
31
27
7
11/03
P/N 211483E
8.
Fasten elastic straps in locations shown.
9.
Operation.
BACK VIEW OF SCORING UNIT
DC BATTERY
COMPARTMENT
AC
ADAPTER
ON/OFF
VOLUME
CONTROL
1
PADDLE CONNECTIONS
AC POWER: REMOVE AC ADAPTER FROM BOX. INSERT AC PLUG INTO SLOT ON SCORING UNIT. INSERT AC
ADAPTER INTO 110 VOLT WALL OUTLET. TURN SCORING UNIT “ON”.
DISCONNECT AC POWER WHEN USING DC BATTERY POWER
DC BATTERY POWER: REMOVE BATTERY COVER FROM SCORING UNIT. INSERT 4 “D” CELL BATTERIES INTO
COMPARTMENT. REPLACE BATTERY COVER. TURN SCORING UNIT “ON”.
8
P/N 211483E 11/03
Electronic Game Scoring
1. As a player steps up and sinks a basket, a musical tune will play to signal
the start of a game. After the tune stops and a beep is heard a 00 display
will show.
2. The score keeper will reset the display to 30 seconds and begin counting
baskets.
3. A beep is made for every basket made, a different pitch beep for each
player.
4. Two (2) points per basket made for first 20 seconds of game play.
5. After 20 seconds, a musical tone will play, signaling the start of 3 points per
basket.
6. As time displays 00, a buzzer will sound. The score is retained in memory for
each player.
7. If 30 points or more is scored a "CHARGE" tune will play, earning a 15
second bonus round for each player with each basket made scoring 3 points
8. If 60 points or more is scored, an additional 10 seconds is awarded for each
player. Each basket made scores 3 points
9. As the game is finished a 6 second delay will clear both scores and reset.
10. The highest score made is displayed and retained in memory. The high score
resets to 00 if game is not played after 30 minutes.
11. If an AC power adapter is used, the high score will be retained in memory
unless power is disconnected.
9
11/03
P/N 211483E
|