MOUNTING
WIRING
• E6 (side mount) and V6 (flange mount): #6
screws (#8 available on certain listings). E6
enclosures meet NEMA 1; V6 enclosures meet
NEMA 1 and 3*.
• BZG/H; #10 screws. Enclosures meet NEMA 1,
3*, 4*, 13*.
Connect grounding screw or lug.
Solderless connections:
1.Use only insulated connectors.
2.Position connectors to provide as much spacing
as possible.
• Side and bottom mounting available. Side mount
from either side.
NOTICE
1.Do not drill or machine housing.
2.Do not lubricate any internal part of switch.
3.Do not allow internal conduit condensation to
drain into switch.
1.Mount switches on flat, rigid surface.
2.Sealed, side mounted: Use sealing washers
under screw heads on one side; between switch
and mounting surface on other side.
3.Unsealed, side mounted: Use lockwashers
under screw heads on one side; under nut on
other side.
4.Do not enlarge mounting holes.
CONDUIT SEALING PACKETS
Packet Listing
2PA6
Cable O.D. In. (mm)
4.Connect conduit to complete seal.
*Except Q plungers.
.400 - .435 (10,2 - 11,1)
.435 - .470 (11,1 - 12,0)
.530 - .570 (13,5 - 14,5)
2PA16
2PA1
REPLACEMENT PARTS
Basic switch: order according to catalog listing on
basic switch being replaced. Replacement packet
includes basic switch, mounting hardware, seal
boot and bands where required.
Actuators or Accessories
Part
Listing
6PA2
N2 actuator (roller lever)
Q2 actuator (roller lever)
N28 actuator (one-way roller lever)
Q28 actuator (one-way roller lever)
N62 Actuators (rod lever)
Q62 Actuators (rod lever)
N4 Actuators (manual button)
Q4 Actuators (manual button)
N18 Actuators (spring)
6PA1
6PA16
6PA41
6PA140-E6
6PA62
6PA9
LIQUID TIGHT CONDUIT FITTING
2PA17
.170 - .470 (4,3 - 12,0) 1/2 NPT
6PA7
6PA195
6PA187-E6
2PA1
N18 Actuators (spring and bushing)
Conduit Seal
2PA6
6PA187-E6 ACTUATOR PACKET
2PA16
10PA2
10PA1
3PA13-E6
3PA14-V6
15LT1
Seal Boot (black elastomer)
Seal Boot (orange silicon)
Bottom Cover E6
Bottom Cover V6
Pilot Light for BZG/H
MICRO SWITCH Sensing and Control
|