LED Gooseneck Map Light
Installation Instructions
Warning: Please read all instructions and warnings prior to installation of the LED Gooseneck Map Light.
TOOLS REQUIRED:
Phillips Screw Driver
Wire Cutter/Stripper
HARDWARE: (Supplied in Kit)
Qty. Description
Qty.
Description
2
2
#6 Machine Screw
#6 Thread Forming Screw
2
2
#6 Split Lock Washer
#6 Flat Washer
INSTALLATION:
1. Mounting:
• A drill template is provided on the back of this instruction sheet. Detach the
template, position it on the desired location for installation, and mark drill locations.
Caution: Before drilling holes, ensure that the mounting surfaces are clear and that the
screws will not damage the internal parts of the console or vehicle.
Caution: Ensure that the Gooseneck Map Light is installed in areas recommended by the
vehicle manufacturer—outside of the airbag zone.
• Drill the mounting holes.
• Remove the template prior to installing the fixture. Secure the base of the fixture in
position using the supplied machine screws and washers.
•
The supplied super clip may be used to secure the gooseneck in position if desired.
Caution: Thread forming screws are supplied for alternate installations requiring the fixture to
be mounted from above. If the fixture needs to be disassembled for such installation, please
note that this will void your warranty.
2. Wiring:
• Connect the black lead to negative (ground.)
• Connect the red lead to hot (power.)
Note: It is recommended to install an in-line fuse holder and 1 Amp fuse on the red (hot) lead.
• Test the light for proper operation.
|