1 Million Candle-Power
reChargeable sPot light
66691
oPerating and MaintenanCe instruCtions
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
saVe this Manual.
©
®
Copyright 2009 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Manual Revised 10d
goes out, the Spot Light is ready for
use. Unplug the Adaptor.
sPeCiFiCations
4V DC 2AH Sealed
Rechargeable Battery Lead Acid (Included, Not
Replaceable).
Charging with 12V Cigarette lighter
adaptor: Plug into any 12V DC outlet in a
Automobile, boat or RV, and then into the
Adaptor Plug Inlet located on the back of
the Spot Light. See Figure 1.
25W Halogen (H3 4V
25W)
Bulb
Input: 120VAC 60 Hz
AC/DC Adaptor
(Included)
Adaptor Prongs
2-Prong, Non-Polorized
Figure 1
Cigarette Lighter
Adaptor
12V DC, Fuse: 2A 250V
(Included)
adaptor Plug inlet
Light Output
1 Million Candle Power
Please Note: Spotlight will NOT operate
during charging.
unP aCking
Pistol
grip
When unpaing, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
Charge light
indicator
4. The Charge Light Indicator will light
up. When the Charge Light Indicator
goes out, the Spot Light is ready for
use. Unplug the Adaptor.
oPerating instruCtions
read the entire iMPortant
saFety inForMation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
5. A fully charged Spot Light will give
bright light for approximately 20 min-
utes.
6. note: spotlight will not operate
during charging.
Charging with aC/dC adaptor:
1. Plug AC/DC Adaptor (21) into a 120V
outlet.
using the rechargeable spot light:
1. Hold the Spot Light using the Pistol
Grip (4).
2. Attach the end of the Adaptor cord to
the Adaptor Cord Inlet, located on the
back of the Spot Light. See Figure 1.
2. Squeeze the Switch (6) located on
the Trigger (8). If you want the Spot
Light to stay on, push the Switch
3. The Charge Light Indicator will light
up. When the Charge Light Indicator
Lock (5) in while squeezing the Trig-
Rev 10d
SKU 66691
For technical questions, please call 1-800-444-3353.
Page 3
ger (8), then release the Trigger (8)
and the Spot Light will stay on.
removing and recycling the 4V dC
battery:
3. When finished using the Spot Light,
squeeze the Trigger to turn the Spot
Light off. Let the Bulb (14) cool for
at least 30 minutes before storing.
Keep Spotlight indoors away from
children.
note: the battery for this product is
rechargeable and long lasting.
When finally it is worn beyond any
further use, it should be removed
and recycled and the spot light
should be disposed of with normal
refuse. DO NOT dispose of the
Spot Light with Battery inclosed in
it’s Housing.
replacing the 4V halogen bulb:
1. Remove the Ring Cover (12) from the
Housing (2) by un-threading with a
counterclockwise motion.
Figure 2
2. Lift out Ring (11), Lens (10), and
Reflective Bowl (9). The Bulb (14) is
installed into base of Reflective Bowl.
3. Remove the Metal Spring Clip (22)
holding the Bulb Holder in place by
squeezing and lifting the Spring Clip
up through the “T” slot.
4. note: to prevent hand-oil contam-
ination, do not touch the halogen
bulb (14) with bare hands. use a
lint free, soft, clean rag to handle
the bulb. Remove the Bulb from the
Bulb Holder by twisting it counter-
clockwise and lifting.
seven screws
hold housing
together
1. To remove the Battery from the Hous-
ing (2), follow these steps:
5. Replace with new, identical Bulb
(25W Halogen H3 4V).
a. Remove seven Screws from the
Housing. See Figure 2.
b. Pull the Housing (2) apart and re-
move the wires connected to the
Battery.
6. Place Bulb Holder into the Reflective
Bowl (9). Slide the closed end of the
Metal Spring Clip (22) over the tab at-
tached to the side of the Bulb Holder,
and squeeze the Spring Clip together
while sliding it into the “T” slot.
c. Remove the Battery from the Hous-
ing (2).
warning! do not dispose of the
4V lead acid battery with normal
refuse. always recycle in ac-
cordance with all local, state and
federal rules and regulations.
7. Replace the Reflective Bowl (9), the
Lens (10), and the Ring (11). Hold
these in place while threading the
Ring Cover (12) onto the Spot Light
with a clockwise motion.
SKU 66691
For technical questions, please call 1-800-444-3353.
Page 4
Parts list
Parts list
Part
description
Q’ty
Part
description
Q’ty
1
2
3
4
5
6
7
8
9
Circuit Board
Housing
1
1
1
1
1
1
1
1
1
1
1
12 Ring Cover
1
2
1
7
1
2
1
1
1
1
1
13 Screw
Pistol Grip Holder
Pistol Grip
Switch Lock
Switch
Trigger Spring
Trigger
Reflective Bowl
14 Halogen Bulb (25W H3 4V)
15 Screw (Housing)
16 Battery
17 Screw
18 Circuit Board
19 Wrist Wrap
20 Auto, Boat, RV, 12V DC Adaptor
21 AC/DC Adaptor (120V)
22 Metal Spring Clip
10 Lense
11 Ring
asseMbly diagraM
22
record Product’s serial number here:
note: If product has no serial number, record month and year of purchase instead.
note: Some parts are listed and shown for illustration purposes only, and are not available
individually as replacement parts.
SKU 66691
For technical questions, please call 1-800-444-3353.
Page 5
liMited 90 day warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high
quality and durability standards, and warrants to the original purchaser that this product
is free from defects in materials and workmanship for the period of 90 days from the date
of purchase. This warranty does not apply to damage due directly or indirectly, to misuse,
abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity,
improper installation, normal wear and tear, or to lack of maintenance. We shall in no event
be liable for death, injuries to persons or property, or for incidental, contingent, special
or consequential damages arising from the use of our product. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation
of exclusion may not apply to you. THIS WARRANTy IS exPReSSLy IN LIeU OF ALL
OTHeR WARRANTIeS, exPReSS OR IMPLIeD, INCLUDING THe WARRANTIeS OF
MeRCHANTABILITy AND FITNeSS.
To take advantage of this warranty, the product or part must be returned to us with
transportation charges prepaid. Proof of purchase date and an explanation of the complaint
must accompany the merchandise. If our inspection verifies the defect, we will either
repair or replace the product at our election or we may elect to refund the purchase price
if we cannot readily and quickly provide you with a replacement. We will return repaired
products at our expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost of returning
the product.
This warranty gives you specific legal rights and you may also have other rights which
vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353
Please read the Following CareFully
THe MANUFACTUReR AND/OR DISTRIBUTOR HAS PROVIDeD THe PARTS LIST AND ASSeMBLy
DIAGRAM IN THIS MANUAL AS A ReFeReNCe TOOL ONLy. NeITHeR THe MANUFACTUReR OR
DISTRIBUTOR MAKeS ANy RePReSeNTATION OR WARRANTy OF ANy KIND TO THe BUyeR THAT
He OR SHe IS qUALIFIeD TO MAKe ANy RePAIRS TO THe PRODUCT, OR THAT He OR SHe IS
qUALIFIeD TO RePLACe ANy PARTS OF THe PRODUCT. IN FACT, THe MANUFACTUReR AND/OR
DISTRIBUTOR exPReSSLy STATeS THAT ALL RePAIRS AND PARTS RePLACeMeNTS SHOULD Be
UNDeRTAKeN By CeRTIFIeDAND LICeNSeD TeCHNICIANS, AND NOT By THe BUyeR. THe BUyeR
ASSUMeS ALL RISK AND LIABILITy ARISING OUT OF HIS OR HeR RePAIRS TO THe ORIGINAL
PRODUCT OR RePLACeMeNT PARTS THeReTO, OR ARISING OUT OF HIS OR HeR INSTALLATION
OF RePLACeMeNT PARTS THeReTO.
SKU 66691
For technical questions, please call 1-800-444-3353.
Page 6
|