Harbor Freight Tools Landscape Lighting 95797 User Manual

SOLAR CANDLE  
GARDEN LANTERN  
95797  
ASSEmbLy AND OpERATiON iNSTRuCTiONS  
Due to continuing improvements, actual product may differ slightly from the product described herein.  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
TO pREVENT SERiOuS iNjuRy, READ AND uNDERSTAND  
ALL wARNiNGS AND iNSTRuCTiONS bEfORE uSE.  
©
®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Tools.  
for technical questions or replacement parts, please call 1-800-444-3353.  
 
intended function. Any broken parts or mounting fixture that may affect proper operation  
should be properly repaired or replaced by a qualified technician.  
10.  
11.  
properly disponse of any used batteries. Dispose of the used batteries properly  
according to the solid Waste disposal regulations in your community.  
warning: The warnings, cautions, and instructions discussed in this instruction  
manual cannot cover all possible conditions and situations that may occur. It must  
be understood by the operator that common sense and caution are factors which cannot  
be built into this product, but must be supplied by the operator.  
uNpACKiNG  
When unpacking, check to make sure that the item is intact and undamaged. If any  
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of  
this manual as soon as possible.  
OpERATiNG iNSTRuCTiONS  
NOTE: For additional information regarding the parts listed in the following pages,  
refer to the Assembly Diagram on page 7.  
1.  
Before using, you need to charge the batteries. You can do this by placing the Solar  
Lantern in the sunlight.The Lantern will take approximately 8 hours of sunlight to charge.  
Be sure the four Solar Panels (2) are in full sunlight.  
Solar Panels (2)  
Top Assembly  
Plastic Ring (11)  
FIGURE 1  
2.  
After the Batteries (8) are charged, remove theTop Assembly (See Figure 1) by twisting  
counterclockwise off the Plastic Ring (11) and lifting it off the Lantern.  
Page 3  
SKU 95797  
for technical questions, please call 1-800-444-3353  
 
Plastic Ring (11)  
Battery (8)  
Power  
Switch (18)  
FIGURE 2  
3.  
4.  
The Power Switch (10) is on the underside of the Top Assembly. To have the light turn  
on at night, locate the Power Switch (18) and switch to the ON position. You can turn  
the Solar Candle Garden Lantern Power Switch (18) OFF if you do not want the light  
to turn on at night. See Figure 2.  
Replace the Top Assembly by connecting it to the Lantern, matching up the notches  
and twisting clockwise for closure.  
Small Loop (1)  
“S” Steel Tube (19)  
Middle Steel Tube (22)  
Lower Steel Tube (23)  
Ground  
Stake (16)  
FIGURE 3  
5.  
The Shepherd’s Hook is screwed together with three threaded shafts (19, 22 and 23).  
Hook inserts into the top of the Ground Stake (16) and the Lantern hangs from the  
Page 4  
SKU 95797  
for technical questions, please call 1-800-444-3353  
 
hook by a Small Loop (1) at the top of the light. See Figure 3 and Assembly Drawing  
on page 7.  
6.  
7.  
Choose the location for the Solar Candle Garden Lantern and stick the Shepherd’s  
Hook and Ground Stake (16) into the ground, avoiding any underground wiring or  
plumbing. Be sure to choose a location that gets plenty of sunshine during the day  
and is not near a porch or street light at night. See Figure 3.  
If the Solar Candle Garden Lantern stops working or is not holding a charge for a long  
enough period, replace the batteries with identical rechargeable NiCd “AA” batteries.  
See directions below for battery replacement.  
Small Loop (1)  
FIGURE 4  
Note: The Solar Candle Garden Lantern can be removed from the Shepherd’s Hook  
and Stake and used as a table Lantern. See Figure 4.  
bATTERy REpLACEmENT  
1.  
Turn the Top Assembly of the Solar Candle Garden Lantern slightly  
counterclockwise. Remove the assembly from the top of the Solar Candle Garden  
Lantern.  
See Figure 1 on page 3.  
2.  
3.  
Take assembly off the Lantern, being careful not to disturb the wires and the internal  
components. See Figure 2 on page 4.  
Remove the used Batteries (8) and dispose of them properly according to the Solid  
Waste Disposal regulations in your community. Replace with new Rechargeable  
Page 5  
SKU 95797  
for technical questions, please call 1-800-444-3353  
 
NiCd Batteries (8). The polarity of the batteries is marked inside the Battery Case  
(10). Be careful of the internal components and do not disturb the wires.  
4.  
Once the batteries are in place, match up the notches and return the Top Assembly.  
Twist clockwise onto the Plastic Ring (11). Then tighten.  
Note: Test that the Top Assembly and Lantern are secure before hanging on the  
Shepherd’s Hook.  
mAiNTENANCE  
1.  
2.  
wARNiNG! Make sure the Power Switch (18) of the Solar Candle Garden Lantern  
is in its “OFF” position before performing any inspection, maintenance, or cleaning  
procedures.  
bEfORE EACH uSE, inspect the general condition of the Solar Candle Garden  
Lantern. Check for loose screws, cracked or broken parts, damaged electrical  
wiring, and any other condition that may affect its safe operation. Do not use  
damaged equipment.  
3.  
Clean the outside of the Solar Candle Garden Lantern with a clean and damp  
cloth. Never use abrasive cleaners; they will damage the unit. You may use a mild  
detergent. Never submerge the Solar Candle Garden Lantern in water or any other  
liquid.  
pLEASE READ THE fOLLOwiNG CAREfuLLy  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY  
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR  
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT  
HE OR SHE IS qUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS  
qUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR  
DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE  
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER  
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL  
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION  
OF REPLACEMENT PARTS THERETO.  
Page 6  
SKU 95797  
for technical questions, please call 1-800-444-3353  
 
pARTS LiST  
part  
1
Description  
Small Loop  
Q’ty  
1
part  
13  
14  
15  
16  
17  
18  
19  
20  
21  
22  
23  
Description  
Transparent Hood  
Q’ty  
1
4
1
1
2
1
3
1
1
1
1
2
Solar Panel  
Top Cover  
4
Plastic Sheet  
Base  
3
1
4
Top Ring  
1
Ground Stake  
Connector  
5
Circuit Board  
Battery Board  
Screw  
1
6
1
Power Switch  
“S” Steel Tube  
Stopper  
7
10  
2
8
Battery  
9
Spring Sheet  
Battery Case  
Plastic Ring  
Plastic Candle  
4
Sensor  
10  
11  
12  
2
Middle Steel Tube  
Lower Steel Tube  
1
1
ASSEmbLy DiAGRAm  
2
4
3
6
7
5
8
9
1
10  
7
11  
12  
13  
21  
15  
14  
20  
7
18  
7
19  
17  
16  
22  
23  
Note: Some parts are listed and shown for illustration purposes only and are not  
available individually as replacement parts.  
Page 7  
SKU 95797  
for technical questions, please call 1-800-444-3353  
 

Graco Car Seat 8481 User Manual
HANNspree Flat Panel Television ST38 15A1 User Manual
Harbor Freight Tools Laminator 92499 User Manual
Harbor Freight Tools Log Splitter 94837 User Manual
Hotpoint Double Oven UE89X User Manual
Hotpoint Washer Dryer AQXXF 149 PI User Manual
HP Hewlett Packard Scanner L2737ABGJ User Manual
HP Hewlett Packard Switch 1700 24 User Manual
HP Hewlett Packard Ventilation Hood HP 83006A User Manual
HTC Cell Phone OXYG100 User Manual