recHarGeaBle/cordless
sHaVer
66342
InstructIons and precautIons
®
distributed exclusively by Harbor Freight tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
saVe tHese InstructIons. read all
precautIons and InstructIons.
©
®
Copyright 2008 by Harbor Freight Tools . All rights reserved. No portion of this document or any artwork contained
herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this document may not be drawn proportionally. Due to continuing improvements, actual product
may differ slightly from the product described herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
5.
6.
7.
If necessary, use Brush (6) to clean hair trim-
mings from exposed Shaver cutting heads.
parts lIst & dIaGram
description
Shaver
Foils
Foil Holder
Cover
Charger
Brush
Carrying Sleeve
Power Switch
part
Qty.
If necessary, slide old Foil from out of Foil
Holder and rinse trimmings off Foil.
1
2
3
4
5
6
7
8
1
2
1
1
1
1
1
1
If Foil must be replaced, slide the new Foil
into Foil Holder so that small hole in the
center of the Foil slides over small tab in the
middle of the Foil Holder cross bar. This will
hold Foil in place.
8.
9.
Slide the Shaver housing into the Foil Holder
until it snaps into place.
record serial number Here:
Slide the Cover onto Shaver head until ready
to use.
note: If product has no serial number, record month and
year of purchase instead.
note: Some parts are listed and shown for illustration
purposes only, and are not available individually
as replacement parts.
10. Recharge if necessary.
remoVInG tHe BatterY
1.
2.
3.
4.
5.
By law, the Ni-Cd battery must be removed
from housing before Shaver disposal.
please read tHe FolloWInG careFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED
THE PARTS LIST AND ASSEMBLy DIAGRAM IN THIS DOCUMENT
AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANy REPRESENTATION OR WARRANTy
OF ANy KIND TO THE BUyER THAT HE OR SHE IS qUALIFIED TO
MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIFIED TO REPLACE ANy PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLy STATES THAT ALL
REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN By
CERTIFIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER.
THE BUyER ASSUMES ALL RISK AND LIABILITy ARISING OUT OF HIS
OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
Use a screwdriver to unscrew the Shaver
head from the top of the housing.
Pry off the label from the housing bottom and
unscrew bottom from housing.
Pry front panel off Power Switch and remove
screw from front panel.
Slide battery holder out of housing. Remove
and properly dispose of Ni-Cd battery.
4
6
3
2
7
8
1
Please note: Charger (5) is not shown.
SKU 66342
For technical questions, please call 1-800-444-3353.
Page 3
|