KhaKi automatic
Frogman
instruction manual
Englishꢀ
Françaisꢀ
Deutschꢀ
Italianoꢀ
Españolꢀ
Portuguêsꢀ
Nederlandsꢀ
Svenskaꢀ
Türkçeꢀ
Ελληνικάꢀ
Русскийꢀ
Českyꢀ
ꢀ
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32
ꢀ
ꢀ
ꢀ
ꢀꢀ
35
© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
1
Hamilton is delighted that you have chosen a timepiece from its collection. You have acquired a small
technological marvel that will serve you faithfully for many years. The most advanced technologies were
used throughout its manufacture and it underwent stringent controls before it was released for sale.
Recommendations
Like all micro-mechanical precision instruments, your Hamilton watch should be checked at least once every two
years. Entrust your watch only to an authorized Hamilton agent. To keep your watch water-resistant, make sure
that its sealing features are tested at every check-up.
The water-resistance of your watch is 20 ATM = 200 meters = 660 feet.
Fiveꢀbasicꢀrulesꢀforꢀmaintainingꢀtheꢀwater-resistanceꢀofꢀyourꢀwatchꢀ
1. Have your watch checked regularly.
2. Do not move the crown when you are in water.
3. Rinse off your watch after immersion in water.
4. Dry your watch whenever it gets wet.
5. Have your watch checked for water-resistance by an authorized
Hamilton agent each time the case is opened.
Your watch is fitted with an automatic movement. The mechanism of the watch includes an oscillating rotor that
winds the mainspring via the motion of your wrist. The running reserve is approximately 42 hours. If necessary,
the watch may be rewound manually. The beauty of the inner working of the watch movement can be admired
through the transparent case back.
2
© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
Features
Measuringꢀaꢀsingleꢀtimeꢀwithꢀtheꢀ
Start-Stopꢀfunction
A) Crown protector
B) Start-Stop button
C) Reset-to-zero button
D) Crown protector
E) Crown for adjustment of time and date
1) 60-second counter
2) 30-minute counter
3) 12-hour counter
1. Unscrew the crown protector (A) to
access the chronograph buttons.
2. Press button (B): the chronograph starts.
3. Press button (B): the chronograph stops.
4. Press button (C): reset to zero.
5. After use, make sure to screw down
the crown protector (A).
4) Date
NB: before starting a time measurement, the hands
should be reset to zero. If necessary, push button (C).
Adjustingꢀtheꢀtime
1. Unscrew the crown protector (D).
2. Pull out the crown (E) fully to position (p2).
Addꢀfunction
For measuring successive times
(each time is added to the previous total).
3. Adjust the time by turning the
crown in the desired direction.
1. Unscrew the crown protector (A) to
access the chronograph buttons.
4. Push the crown fully back in and screw
down the crown protector (D).
2. Press button (B): the chronograph starts.
3. Press button (B) again: the chronograph stops.
Adjustingꢀtheꢀdate
1. Unscrew the crown protector (D).
4. Repeat steps 2 and 3 for as many time
measurements as desired. At the end of
the final step, the chronograph displays the
total time, i.e. the cumulated time of all the
measurements. Press button (C) to reset to zero.
2. Pull out the crown (E) to the
intermediate position (p1).
3. Turn the crown clockwise until the desired date
is displayed. Avoid performing this operation
between 8 p.m. and 2 a.m. (2000 and 0200).
5. After use, make sure to screw down
the crown protector (A).
4. Push the crown fully back in and screw
down the crown protector (D).
© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
3
26
© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
27
w w w. h a m i l t o n w a t c h . c o m
|