HWM80-35
Single-tub Washing Machine with Pump
Contents
Before using
Names of the parts........... the 2nd cover
Safety precautions ...........................
1
Installation and adjustment ..................3
Using process
Preparation before washing .............. 5
Put in the laundries ............................ 6
Put in the detergent ............................ 7
Select the wash selector...................... 7
Select the wash time .......................... 7
Close the top cover ............................. 8
Finish washing .................................... 8
Disposal after washing .........................8
Trouble shooting.................................9
Packing list...........................................9
Specification................the back cover
Please read thismanual carefully beforeusing.
Retain it forfuture reference
Please check if the power receptacle has good earthing
condition before using to guarantee your safety.
The manufacturer willnot bear theresponsibility for
those risks occurredfrom not obeyingthis manual.
Before Using
Safety precautions
Please insert the power cord into special
When the machine is normally using, please
put the power plug at the location easily to
be inserted and extracted by hand. Be sure
to pull the plug off when there'spower failure,
or the machine is being moved, cleaned or
when it is idle.
receptacle with rated voltage.Be sure to
use single-phase three pins receptacle.
The earthing terminal of the receptacle
must be earthed reliably.If possible,please
adopt electric leakage protector.
Earth
If the power cord is bad, to avoid risk it is required to replace it by the technicians of
our special shop or the after-sale service department. Keep the pin of the power
plug clean.
Do not use water hotter than 50 C .
In case the washing machine is installed
on ground with carpet , do not block the
ventilation hole with carpet.
Ventilation hole at
the bottom of the
washing machine
Do not put the machine at damp place Do not wash water-proof laundries such
like the bathroom . Never wash it with
water. Do not place wet laundries on the
control panel.
as the raincoat, bicycle shelter etc. To
avoid abnormal vibration during spinning.
Do not share one receptacle with other
electric appliances. Do not use it in
case that the power plug is damaged
or the inserting into the receptacle is
loose.
Before Using
Safety precautions
Do not decompose, repair or alter the
machine by yourself.
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.
Do not put any hot or heavy items
( such as the kettle with hot water )
on the washing machine.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.).
r
Petrol
nne
Thi
Handicapped or children without care
shall not use the machine.
Keep the machine away from direct
sunlight and heat source like the
heater.
To protect your laundries and washing
machine, please take out all of the coins,
buttons, sand, hairpin and other foreign
materials before washing.
Please check if the water faucet is open, and if
the connection of the water inlet pipe is proper.
It is suggested to use foamless washing powder.
Before Using
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.Put the drain hose up to suitable position
<1.2m
2.Do not step on or press the drain hose
Install the lint filter
After opening the package,please take out the lint filter
from the document bag,install it to the filter cap of the
cabinet.See to the figure
Filter cap
Lint filter
Before Using
Adjust the installation position
The largest permittedslope of thebearing surface ofthe washing machineis 2.
Slanting or unevenground will causeunstable operation ofthe machine. Please
check with followingmethods:
Hang a becketwith weight toconfirm if thewashing machine ishorizontal.
Install the water inlet hose ; Select the water level
Water inlet hose
Water level
indicator
Insert the water inlet hose into the water-inlet
on the control panel directly. ( pull it out to
dismantle it)
Water inlet
MAX
Maximum
about 83L
Fill the water to the water level selected
according to the quantity of the laundries.
MED
Medium
about 68L
Minimum
about 49L
MIN
Attention:
Do not exceed the " Maximum" water
level , otherwise the water may
overflow out of the machine.
MA
MED
MIN
Use the quick water inlet
Insert the water-filling jointer into water inlet hose,
then push the water-filling jointer into the water
inlet on the control panel. (To dismantle the water
inlet hose, just push the control handle as
indicated in the figure and pull it out)
Water-filling jointer
Water inlet hose
Fill water into the wash tub directly through
quick water inlet. It can reduce the humidity
inside the control panel significantly and
prolong the operating life of the components.
Push
Control handle
Quick water inlet
Using process
1 Preparation before washing
Preparation before washing
1.Connect the water inlet hose.
2.Confirm that the washing machine is
earthed reliably . Then insert the power
plug into the receptacle. Do not connect
the earth terminal to the gas pipe and
tap water pipe.
3.Hang the drain hose up.
Pay attention to followings before washing the laundries
Check
if C l e a r t h e Tie the long The quantity of
When the pulsator
the laundries pocket. Take strips; fasten the laundries is running , the
has special out the coins, the buttons; shall not be too buttons of the
requirement sand, hairpins close zippers. large. Stretch laundries may
on washing etc.
and loosen the cause noise. For
laundries before t h e s a k e o f
putting them in discretion, please
the tub.
put the laundries
with buttons into
other laundries.
a. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust.
For the parts with heavy soil, please apply detergent on them in advance, which
can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn it over before
putting in.
f. Do not put those laundries polluted by chemicals into the washing machine directly.
Using process
2 Put in the laundries
The capacity of washing of the machine
refer to the largest weight of the standard
laundries under dry condition that can be
washed in one time. Laundries quantity
in one washing cycle shall be lower
than the rated capacity.
The thickness ,size , type of the cloth will
influence the actual washing capacity. It
is suitable to put in reasonable amount of
laundries and the laundries can be turned
round in washing for one time washing.
Do not select " Maximum " water level
for laundries less than 2.4kg, so as to
avoid splashing of water.
Reference weight of the laundries:
working suit up,down
cotton,about 1120g
jeans about 800g
blanket
cotton,about 900g
blending coat
about 800g
pajamas
jacket
cotton,about
800g
shirt
cotton,about
300g
single bed sheet
cotton,about 600g
undershirt
cotton,about 180g
socking
blending,about 50g
underpants
cotton,about 70g
Using process
3 Put in the detergent
How to use the whitener
Fill water to decided level. Dilute the whitener with container. Pour it slowly into the
washing tub.
Avoid using whitener on laundries with color or pattern as they are prone to lose color.
The whitener shall not touch the laundries directly.
Refer to the user's manual for the usage and quantity of the whitener.
For powder whitener,please dissolve it before using.
How to use the washing powder
Direct dissolved in the machine:
1.Fill small quantity of water.
2.Add the powder . Run for 30 seconds to
dissolve it completely.
3.Put it in the laundries. Select suitable
water level.
The powder is more prone to pollute the
laundries than the detergent. Therefore
please use it with proper quantity.
It is suggested not to use high sudsing
detergent.
The instant dissolving of the washing powder:
1.Prepare warm water of 30 C and a container.
2.Add the powder while stirring to fully
dissolve it.
Dosage of different washing powder is
different. Please refer to the instruction
of the washing powder for the detail
dosage.
Selection of the quantity of the washing powder
Standard dosage
Water level
Concentrated washing
powder
Common washing
powder
Water quantity
Maximum (about83L)
Medium (about68L)
Minimum (about49L)
About
About
About
About
83g
75g
61g
43g
About
68g
About
49g
4 select the wash selector
STANDARD
Please select water current according to the laundries.
GENTLE
DRAIN
WASH SELECTOR
5 select the wash time
Please select wash time according to the laundries.
Laundries
Wash time minutes
About2~4
Silk(thin laundries)
Knitwear/chemical fiber
Bed sheet
About3~6
About7~13
About8~10
Cotton,blending,linen
Very dirty and thick laundries
About10~13
Using process
6 Close the top lid
7 Finish washing
STANDARD
GENTLE
The pulsator stops rotating set the "WASH
SELECTOR" at "DRAIN".
DRAIN
WASH SELECTOR
8 Disposal after washing
After using, please clean the lint and foreign materials of the lint filter and lint frame in time.
Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
Cleaning the lint filter
The lint filter must be used during washing.
It must be cleaned in time after each using.
1. Take off the lint filter
Put hand at the indicated position.
Push down to take it off. (See to
Figure 1)
Figure 1
2. Clean the lint
Put it in water and clean while it is still
wet.(See to Figure 2)
3. Install the lint filter
After cleaning, insert the bottom of
the lint filter (marked with "down side")
Figure 2
into the filter frame, then push the
upper part of the filter in (marked with
"up side"). (See to Figure 3)
Figure 3
Attention: be sure not to confuse the direction.
After washing, dismount the water inlet hose.
Pull off the power plug and hang up the
power cord.
Do not store water in the tub for long period.
Discharge the water immediately after each
using.
Wipe the complete unit with soft cloth
twisted dry.
Wipe with neutral detergent if too dirty.
Do not wash it directly by water.
Wipe off the water drops on the surface and
inside the tub with clean soft cloth. Open the
cover of the wash tub for some time (about
one hour), then close it.
Thinner
Petrol
Alcohol
Hang up the drain hose.
Trouble-shooting
The following phenomena are not breakdowns sometimes. Please confirm again before
sending it to repair.
Phenomena
How to check
The washing machine
does not act
Is there power failure?
Is the power plug inserted tightly?
There's abnormal sound
inside the machine.
Is the machine slanting?
Is there metal item inside the tub?
Is the drain hose frozen?
Is the front end of the drain hose blocked?
The drainage does not work.
Packing list
User's manual
1 piece
1 piece
Water inlet hose
Water-filling jointer
Lint filter
1 piece
1 piece
1 set
Washing machine
Specification
Type
Single-tub washing machine with pump
Model
HWM80-35
Rated voltage Frequency
Water level Water quantity about
220V~ 50Hz
Maximum/83L Medium/68L Minimum/49L
Rated input power for washing
Rated input power for draining
Dimensions(mm)
W
W
320
35
L520 W490 H916
17
Weight kg
Injection pressure
0.02MPa~0.2MPa
|