HOT AIR
HAIR STYLER
HS 4020
____________________________________________________________________
SAFETY
7
Please note the following instructions when
using the appliance:
If the power cord is damaged, it must be
replaced by the manufacturer, its service cen-
tre or a similarly qualified person to prevent
danger arising.
7
This appliance is intended for domestic use
only.
7
7
Keep the appliance out of the reach of
children.
7
Never use the appliance in the bath, shower
or over a wash basin filled with water; nor
should it be operated with wet hands.
The appliance may not be used by the
following people, including children: persons
with limited physical, sensory or mental
capabilities and also those with a lack of
experience and knowledge. This does not
apply to the latter if they were instructed in the
use of the appliance or if they use it under the
super-vision of a person responsible for their
safety. Children should always be supervised
to ensure that they do not play with the
appliance.
7
Do not immerse the appliance in water or let
it come into contact with water, even during
cleaning.
7
Do not use the appliance near water in bath-
tubs, wash basins or other vessels.
7
7
Do not open the appliance under any circum-
stances. No warranty claims are accepted for
damage caused by improper handling.
7
If the appliance is used in the bathroom, it is
essential that the power plug is pulled out
after use, as water close to the appliance can
still pose a hazard, even if the appliance is
switched off.
A very warm flow of air is required to achieve
a perfect result.
Please note that a metallised brush can
become extremely hot during prolonged or
intensive use.
To avoid injury, adjust the usage time of the
appliance to the accessory being used.
7
If not already in use, for additional protection
it is recommend to install a residual-current-
operated protective device (RCD) with a
rated residual operating current not exceed-
ing 30 mA in the electrical circuit of your
bathroom.
Ask your plumber for advice.
7
Never place the appliance on soft cushions
or blankets during operation.
7
Ensure the air intake and outlet openings are
not covered during operation.
7
The appliance is equipped with an overheat-
ing protection system.
7
Pull out the power plug after use. Do not dis-
connect the plug by pulling on the cable.
7
Never use the appliance if it or the power
cord is visibly damaged.
ENGLISH
3
__________________________________________________
OVERVIEW
Dear customer,
Control elements
A
Congratulations on the purchase of your
HS 4020 professional Hair Styler.
Detachable hot air brush (styling attachment)
B
Catch for detaching the styling attachment
Please read the following instructions carefully
to allow you to enjoy your quality product from
Grundig for many years to come.
C
Switches the device on and off.
Controller for two temperature and blower
levels and cold air setting
D
E
F
Swivelling power cord
Air inlet grille
Handle
Special features
The hot air brushes of your Hair Styler have
ceramic coatings so that they are especially
gentle on your hair.
7
The size of curls depends on the diameter of
the styling attachment in use.
Accessories
1
Ceramic-coated heated brush, medium,
ø 38 mm
7
The ø 25 mm styling attachment is suitable for
smaller curls and waves.
2
Ceramic-coated heated brush, small,
ø 25 mm
7
The ø 38 mm styling attachment is suitable for
softly cascading hair styles such as larger
curls and waves.
A responsible approach!
GRUNDIG focuses on contractually
agreed social working conditions
with fair wages for both internal
employees and suppliers, as well as
on the efficient use of raw materials with conti-
nual waste reduction of several tonnes of plastic
each year – and availability of at least 5 years
for all accessories.
For a future worth living.
For a good reason. Grundig.
4
ENGLISH
___________________________________________________________
OPERATION
Settings
Operation
Your appliance has the following setting
options:
Check if the mains voltage on the type plate (on
the handle of the appliance) corresponds to
your local mains supply.
C
Temperature level/blower level
– 0 : off
1 Towel dry your hair thoroughly after washing.
– 1 : gentle air flow and moderate temperature
D
2 Plug the power cord
into the wall socket.
for gentle drying and styling
C
3 Turn on the appliance with the switch
set the temperature/blower level.
and
– 2 : stronger airflow and high temperature for
fast drying and styling
4 If required you can interrupt the hot air sup-
C
Cold air setting
C
ply when drying by turning the switch
to
– ꢀ : interrupts the hot air supply and provides
»ꢀ« (cold air setting).
cold air for fixing a hairstyles
Note
7
The cold air setting interrupts the hot air oper-
ation and provides a cool air flow. This
allows you to fix your hairstyle better and
more lastingly.
Changing the styling attachments
B
1 Remove the styling attachment currently
place by pressing the catch and pulling off
the heated brush.
in
C
5 After use, switch off the appliance with the
2 Place on a different styling attachment and
allow to latch in place. The two markings (
must be opposite each other.
D
button and pull out power cord
the wall socket.
from
.
)
Caution
Notes:
7
Never wind the power cord around the appli-
ance, as this can result in damage.
Check the power cord and the appliance
regularly for visible damage.
7
7
The size of curls depends on the diameter of
the styling attachment in use.
The styling attachment with a diameter of
25 mm creates small and medium curls and is
especially suitable for short hair.
Cleaning and care
Pull the plug out before cleaning.
7
The styling attachment with a diameter of
38 mm can be used to attain greater volume
with longer hair.
Never submerge the appliance in water.
Use a soft dry cloth for cleaning the housing.
E
Remember to clean the air inlet grille
occa-
sionally with a soft brush to remove any hairs
and dust.
ENGLISH
5
______________________________________________________
INFORMATION
Environmental note
This product has been made from high-quality
parts and materials which can be re-used and
recycled.
Therefore, do not throw the product away with
normal household waste at the end of its service
life. It should be taken to a collection point for
recycling electrical and electronic devices. This
is indicated by this symbol on the product, in the
operating manual and on the packaging.
Please find out about collection points operated
by your local authority.
Help protect the environment by recycling used
products.
Technical data
This product conforms to the
European directives
2004/108/EC, 2006/95/EC and
2009/125/EC.
Power supply
230 – 240 V , 50 – 60 Hz
~
Power
750 – 800 W
Technical and design modifications are
reserved.
6
ENGLISH
|