Instructions - Parts List
309322D
Frame, Roller
ENG
3600 psi (24.8 MPa, 248 bar) Maximum Working Pressure
*The best operating pressure is the lowest pressure that provides an even paint
supply to the roller and typically does not exceed 300 psi (2.1 MPa, 21 bar).
Model 244271, Series C
•
•
9 in. (22.9 cm) length
7/8 in. inlet with 1/2 in. roller cover
Model 244623, Series C
•
•
9 in. (22.9 cm) length
1/8 in. inlet with 1/2 in. roller cover
IMPORTANT SAFETY INSTRUCTIONS.
Read all warnings and instructions in this manual.
Save these instructions.
WARNING
To help prevent injection injuries, follow this
procedure whenever you stop painting.
ti1538a
1. Engage gun trigger safety.
2. Shut off power to pump.
3. Turn prime/spray valve to PRIME position to
relieve pressure in system.
4. Disengage gun trigger safety and trigger gun
to relieve any pressure in hose.
5. Engage gun trigger safety and keep prime/spray
valve in PRIME position until you paint again.
If you suspect that the frame or hose is completely
clogged or that pressure has not been fully relieved
after following the steps above, VERY SLOWLY
loosen the tip retaining nut or hose end coupling and
relieve pressure gradually, then loosen completely.
Then clear the frame or hose obstruction.
Parts
Parts
3
2
1
5
13
4
12
10
14
15
16
Ref. Part
Description
Qty.
1
FRAME, roller
245999 CAP, end
15B065 DIFFUSER, roller
246277 CAP, end (includes seal, retainer and
o-ring)
1
1
2
1
2
3
4
5
197106 CLIP, roller
1
1
1
1
1
1
1
10
12
13
14
15
16
111612 ADAPTER, tube (Model 244623 only)
115524 GASKET (Model 244623 only)
198804 LABEL, instruction
197117 NUT, retaining (Model 244271 only)
115524 GASKET (Model 244271 only)
197118 FITTING, swivel (Model 244271 only)
Wetted Parts: FKM, nylon, plated steel, POM,
polyethylene, stainless steel
Roller Covers:
107589 9 in. x 3/8 in.
107590 9 in. x 1/2 in.
107591 9 in. x 3/4 in.
107592 9 in. x 1-1/4 in.
309322D
3
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 309322
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2010, Graco Inc. is registered to ISO 9001
Revised 2010
|