Failure to follow these wa
instructions could result i
Highchair
OWNER’S
MANUAL
Model No. _______
Serial No. ________
Dear Customer,
Please fill in the
model and serial
numbers above
from the label on
the back of the
footrest of your
new highchair.
Prevent serious injury or death from
falls or sliding out. Always secure
child in the restraint.
Models 3835, 3845, 3848, 3855,
and 3865
Congratulations on your purchase of a
Graco® highchair!
Graco is the recognized leader in the
design and manufacture of quality baby
products. We believe your new Graco®
highchair is a wise choice, promising many
hours of enjoyment for your baby.
Before using your highchair, please take a
few minutes to read this Owner’s Manual.
The short time you spend reading these
instructions will help you use your
highchair properly.
Never leave child unattended.
Always keep your child in view.
Please save your Owner’s Manual
for future use.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
FOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY.
If you experience any difficulties, please contact the
Customer Service Department.
Customer Satisfaction
Our goal is to make every product the best it can
be! We are also committed to supporting our
products after purchase. If you would like to speak
to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109.
Our knowledgeable staff will be ready to answer
any questions you may have concerning parts, use,
or maintenance. When you call, please have the
model and serial numbers ready so your call may
be processed quickly and efficiently.
THIS HIGHCHAIR IS DESIGNED TO BE USED by a child
up to 3 years old. Maximum weight 37 pounds (17 kg).
DO NOT FORCE TRAY against child. Use only the five
adjustment positions. Be sure all adjustment fingers are in
armrest slots.
DISCONTINUE USING YOUR HIGHCHAIR should it
become damaged or broken.
© 1998 Graco 225-12-98 IS3850
2
Step 5.
To Assemble Highchair
Set chair frame into upright
position. Slide the seat assem-
bly onto the frame. Press the
red latches, located on the
plastic leg tubes, to allow seat
to slide onto frame.
Step 1.
IMPORTANT: BEFORE attaching feet to highchair,
frame MUST be folded exactly as in the drawing below.
Lay highchair frame on floor so it looks like the
drawing before attaching feet.
Lowest
latching
position
NOT
resting
on legs
NOTE: Lowest seat position
should NOT rest on top of legs.
Pull seat up to lowest latching
position.
To Attach Seat Pad
Place a foot top and foot bottom at each corner of the
chair frame tube. Insert a screw into the foot bottom,
through the hole in the chair frame, and into the foot
top. Tighten screws securely, but do not overtighten.
Your highchair seat pad will either have 4 attachment tabs
or a pocket on the back. Follow the appropriate instructions
below:
Hex wrench
Step 2.
SEAT PAD WITH FOUR TABS:
Unfold the chair frame
as shown. Insert one
bolt and one T-nut into
each leg brace and
Seat
back
T-nuts
through the holes in
the legs. Tighten them
securely with a screw-
driver and the enclosed
hex wrench.
Seat
bottom
Step 1.
Step 3.
Place seat pad in seat. Large
part of pad goes on seat back
as shown. Pull the seat belt
through the hole in the middle
of the seat pad.
Snap end caps into ends of
right and left plastic leg tubes.
Step 4.
Right
Turn the seat upside down
plastic
Step 2.
as shown. Match up the
Push the four tabs on the seat
cover into the slots at the top
and bottom of the seat.
Left
leg
“L” or “R” on the plastic
leg tubes with the letters
molded on the seat back.
Slide the leg tubes into the
“collars” on the seat back.
plastic
leg tube
Collars
tube
Step 3.
Slide the crossbrace tube
through the slots under
the seat. Then insert the
ends of the crossbrace
tube into the holes in the
leg tubes. (This may be
more easily done if the
crossbrace tube is held at
an angle as shown.)
From the rear of the seat, pull
the four tabs over the plastic
anchors near them.
Crossbrace
tube
Anchor
225-12-98 IS3850
5
6
SEAT PAD WITH POCKET:
HARNESS MODELS:
Your highchair will have either a seat belt or a 5-point
harness. Follow the proper instructions below.
Place the crotch strap between your child’s legs and
insert the harness buckles into the center buckle
housing. Adjust shoulder straps as needed (pull adjust-
ment buckles down to loosen harness, push them up
to tighten harness) to get a snug fit around your child.
Check that belt is tightly threaded through retainers
behind seat.
Step 1.
SEAT BELT MODELS:
Position seat pad over highchair.
Pull the seat belt through the
hole in the middle of the seat pad.
Tighten
Slack
length
adjustment
buckle
Loosen
5-POINT HARNESS MODELS:
Straps must first be removed
from seat before pad can be
attached. Behind the seat back,
locate four small plastic retainers
on the shoulder straps. Push
them through the slots in seat
to the front. Set straps aside.
Position seat pad over highchair.
Push each plastic retainer through
proper hole in seat pad and back
into slot it was removed from, as
shown. (The strap length adjust-
ment buckles will be near the
To release, squeeze buckle at right
and left sides of center housing.
Prevent serious
injury or death from falls or sliding
out. Always secure your child in
the restraint. Do not depend on the
tray alone to hold your child.
shoulders.) Avoid twisting straps.
Two levels of shoulder holes are provided. Choose the
level that is at or slightly above your child’s shoulders.
The position of the shoulder straps can be adjusted
for the size of your child. Locate the small retainers
behind the seat back, push them through to the
front and move them to the higher or lower position
as needed.
Pull crotch strap and buckle through center opening in
seat pad.
Step 2.
If it becomes necessary to remove the seat belt, follow
these instructions:
Attach seat pad by sliding pocket
over the back of the seat as
shown.
SEAT BELT MODELS:
NOTE: On certain models with a
cloth pad, pad is reversible. Turn
pocket inside out to reverse.
Step 1.
Unthread both ends of seat belt
through the buckles as shown.
To Use Restraint
Step 2.
SEAT BELT MODELS:
Pull one end of the seat belt
through the belt retainer as
shown.
Place crotch strap between
child’s legs and snap both side
buckles to the center buckle.
Adjust belt as needed to get a
snug fit around your child.
Step 3.
To rethread buckle, reverse the above steps. CHECK
that the belt is threaded correctly by pulling on the seat
belt. The belt should not slip through the buckle.
Push in on front of buckle to
release.
HARNESS MODELS:
Remove seat pad. Follow directions given under “To
Attach Seat Pad” to remove harness straps from seat.
7
8
To Use Small Tray
To Adjust Height
Highchair can be used with
small tray alone, or with large
tray attached on top of small
tray.
DO NOT adjust
the highchair with your child
in it.
Tab
Latches
Place foot on base of rear legs.
Lift seat slightly by the handles
at rear of chair and press both
red latches. Slide the seat up or
down until it latches.
Insert the tabs on the small
tray into the slots at the front
of the armrests. Push down on
the rear of the tray until both
latches at the sides snap onto
seat.
There are six possible height
settings. The highchair can be
used as a toddler chair by
adjusting to the lowest height
setting (which does NOT rest
on top of legs).
Tab
CHECK that small tray is
securely attached by pulling
up on the tray.
Tray may be removed from
highchair by pulling out the
side latches and lifting off tray.
CHECK that both sides of
chair are latched at the same
height setting.
To Use Large Tray
To Adjust Recline
(on certain models)
Small tray
must be attached securely
to highchair before using
the large tray.
DO NOT adjust
recline with your child in the
highchair.
Place the large tray on the
armrests of the small tray. Pull
out the side handles under the
large tray. Put the tray in one
of the five adjustment posi-
tions, and release the side
handles.
Flip up the red lock under the
seat. Lift the seat slightly, and
recline it to one of the three
settings.
Be sure that lock is flipped
back down after changing
recline. It is recommended
that the highchair be used in
the upright position only by
children capable of sitting
upright unassisted.
CHECK that tray is securely
attached by pulling forward
on the tray.
Push on
front button
Use either the side handles
or the front button to adjust
the position of the large tray.
Do not use large tray when
seat is in a recline position.
DO NOT
force the tray against
your child. Keep your
child’s hands and fingers
away from the tray when
adjusting the tray.
To Fold Highchair
Lay the highchair on the
floor as shown. Press in
the tabs on both leg
crossbraces as shown.
Then push the rear legs
down to fold the highchair.
Push
tabs in
Push
rear
legs
down
Tray may be removed from
highchair by using the side
handles.
225-12-98 IS3851
9
10
Replacement Parts
Instructions for ordering highchair parts:
Complete form below. Your highchair model number
MUST be included on the form to ensure proper
replacement parts. Your model number can be found
on a sticker on the back of the footrest. Payment
must accompany your order.
Parts List:
Price:**
Large tray ..................................... $18.00
Small tray ..................................... $14.00
Seat .............................................. $22.00
Vinyl seat pad with tabs* .............. $12.00
Vinyl seat pad with pocket* .......... $15.00
Cloth seat pad (not reversible)* ... $18.00
Cloth seat pad (reversible)* ......... $22.00
Plastic tube (L or R) ..................... $ 8.00 (each)
Crossbrace tube ........................... $ 7.00
Foot top ........................................ $ 5.00 (each)
Foot bottom .................................. $ 5.00 (each)
Seat belt ....................................... $ 5.00
Hardware ...................................... $ 5.00
* Only on certain models.
** Prices subject to change without
notice.
IF YOU NEED HELP
If you have any questions, please call toll-free:
1-800-345-4109
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
Model Number SHIP TO:
(Must be filled in)
Name
Large tray
Small tray
Seat
Address
Vinyl pad with tabs
Vinyl pad with pocket
Cloth pad (not reversible)
Cloth pad (reversible)
Plastic tube (L or R)
Crossbrace tube
Foot top
Foot bottom
Seat belt
Hardware
City, State, Zip
(
)
Telephone
Check enclosed
(payable to Graco Children’s
Products Inc.)
Charge to credit card:
Visa
MasterCard
Discover
Total:
Shipping
& handling:
$5.00 Account #:
6% sales tax
(PA only):
Expiration date:
Signature:
Total amount
due:
11
|