PGS975BEM/WEM
GE Profile™ 30" Slide-In Gas Range
Dimensions and Installation Information (in inches)
Accessory
Backguard
You must use the rear filler strip kit shipped with
the range or the optional accessory backguard
when installing these ranges
Shave Raised Edge To Clear
31-1/8 Wide Control Panel
30" Min.
B
9/16
A*
24
31-1/4
Note: Cabinets installed adjacent to slide-in
ranges must have an adhesion spec of at least
194° temperature rating.
2-7/8"
To Front
2"
30" Min. to
Surface Of
Countertop
unprotected
cabinet from
countertop
(Grates)
23-3/16
13" Max.
18" Min.
Optional Kits for Slide-In Gas Ranges:
(Available at additional cost)
Max. depth of
cord, plug,
36
20-5/8"
25
Lower/Side Trim Kits
JXS56WW - Lower Trim Kit (White)
JXS56BB - Lower Trim Kit (Black)
Door Clearance
From Front
Surface of
Countertop
receptacle box
& gas hookup
3-1/2" to prevent
interference
Acceptable
Gas Line &
Electrical
35-7/8"–38"
from floor to
countertop
with drawer
Outlet Area
3
Accessory Backguards
7
JXS32BB - Black Accessory Backguard
JXS37BB - Black Glass Accessory Backguard
JXS32WW - White Accessory Backguard
JXS37WW - White Glass Accessory Backguard
15
12
29-15/16" Min.
30-1/16" Max.
27-1/2**
(excluding handle)
*A – JXS37 is 5-1/4" and JXS32 is 4"
B is 9-1/2" from walls on either side for P2S975, PGS975
and PGS908 and 6” for PGS968
**Total depth from wall to
front of closed oven door
including handle is 30-1/2.
44-3/4
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Counter Cutout Dimensions (in inches)
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
25
23-3/16
30
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
30
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Revised 5/07
230142
|