Freestyle Watch Shark Classic MID User Manual

home time (TIME), home time alarm  
(ALM1), stopwatch (STW) and  
countdown timer (TMR).  
2
3
Press the S1 button once to start  
the stopwatch. The watch will start  
counting from 00'00''00 if the  
watch is cleared. Otherwise, it will  
pick up from where it last left off.  
The watch will count up to 59  
minutes and 59.99 seconds before  
starting from zero again.  
HOW TO DISPLAY THE DATE  
LIMITED LIFETIME WARRANTY  
Freestyle U.S.A. warrants, to the  
original purchaser, that its watches  
are free from defects in materials  
and workmanship for the lifetime  
of the watch (under normal use)  
from date of original purchase.  
The following are not covered under  
warranty: battery, strap/bracelet/  
band and crystal.  
To display the date, press S1 when the  
time is displayed. Press the button  
again to go back to time display. The  
watch will also do so automatically  
after six seconds.  
FOLLOW THESE 8 TIPS TO GET THE  
MOST OUT OF YOUR NEW WATCH!  
To change from one display mode to  
another, press the S3 button once. The  
mode description will appear for two  
seconds before activating the selected  
mode.  
1. Never Pull out the crown or operate  
the pushers/buttons under water.  
HOW TO SET THE DAILY ALARMS  
SHARK  
CLASSIC MID  
To stop counting, press the S1  
button once. Press the button  
again to resume from where it left  
off. To clear the stopwatch, press  
the S1 button to stop counting and  
then press the S2 button.  
1
2
3
Select alarm function using the S3  
button.  
HOME AND FOREIGN DISPLAY  
To display the foreign time, press S2  
2. Make sure your crown is returned  
to the original position before you  
expose your watch to water.  
Accidental breakage or damage  
due to normal wear or misuse of  
the product, including but not limited  
to the mathematical accuracy of  
the product, is not covered under  
this warranty. Some states do not  
allow limitations on how long an  
implied warranty lasts, or the  
exclusions of or limitations on  
consequential damages, so the  
above limitation may not apply to  
you. This warranty gives you  
Select home and foreign time alarm  
using the S2 button.  
when the home time is displayed. The  
mode description (TM-2) will appear  
shortly before the foreign time is  
displayed. To change back to the home  
time, press S2.  
FEATURES:  
3. If your watch is exposed to  
saltwater it is very important to  
wash it thoroughly under tap water  
and wipe dry with a soft cloth.  
Keep it clean!  
Hold the S2 button for two seconds.  
The SET message will appear. The  
minute digits will blink.  
• CURRENT TIME  
• DAY/MONTH/DATE  
• TWO DAILY ALARM  
• HOURLY CHIME  
• STOPWATCH  
• OPTIONAL 24-HR. TIME  
• WATER RESISTANT TO  
300FT/100M  
• NIGHT VISION™  
BACK LIGHT  
The stopwatch is equipped with a split  
function for you to keep track of  
individual lap time. To use the function,  
4
5
Use the S1 button to set the  
minutes.  
To display the daily alarm for foreign  
time, press S2 when the daily alarm  
for home time is displayed. The mode  
description (ALM 2) will appear shortly  
before the foreign time alarm is  
displayed.  
1
While the stopwatch is running,  
press the S2 button once whenever  
you want to register a lap. The  
stopwatch is still running in the  
background. To display the  
currently accumulated time, press  
the S2 button.  
4. Sever impacts or drops may affect  
your watches water resistance  
and performance.  
Press the S3 button. The hour digits  
will blink.  
specific legal rights, and you may  
have other rights, which vary from  
state to state.  
6
7
Use the S1 button to set the hours.  
5. Avoid exposing your Freestyle  
watch to extreme temperatures  
such as in a hot shower, Jacuzzi,  
sauna or hot tub. The combination  
of extreme heat and water may  
cause your watch to lose some of  
its water resistance.  
Press the S2 button to confirm and  
exit.  
KEY TO SYMBOLS  
Under this warranty FREESTYLE  
will make any necessary repairs, if  
applicable, at no cost to you the  
consumer. Any repair needed that  
is not under warranty will be at the  
cost of you the consumer. Proof  
of purchase and / or original receipt  
it needed to validate your warranty.  
HOW TO SET THE TIME AND  
DATE  
2
3
Repeat the last step until you have  
registered all the laps.  
HOW TO USE THE DAILY ALARMS  
AND HOURLY CHIMES  
To display the alarm time, select ALM  
1 or ALM 2 mode using the S2 button  
in alarm mode.  
1
2
3
Select time display using the S3  
button.  
Press S1 to stop counting. Press  
the button again to resume or  
press the S2 button to clear.  
LIGHT  
S3  
S1  
S2  
Select home time or foreign time  
using the S2 button.  
6. Avoid exposing your watch to  
chemicals, soaps or solvents as  
they deteriorate the water resist  
seals in your watch.  
Note: You can leave the stopwatch  
running while switching over to other  
operating modes. The STW indicator  
will light up as a reminder.  
Use the S1 button to set the status of  
the alarm and chime functions of the  
chosen alarm. Press the button once  
to activate the daily alarm. Press the  
button again to activate the hourly  
chime. Press the button a third time  
to activate both functions. To deactivate  
both, press the S1 button a fourth time.  
Hold the S2 button for two seconds.  
The SET message will appear  
momentarily. The second digits  
will blink.  
Your warranty is voided by any  
servicing out by a non-authorized  
agent. Any other form of guarantee  
to you by the retailer is his / her  
responsibility. This warranty applies  
to watches purchased in the United  
States. For watches purchased  
outside the United States, please  
contact you authorized  
7. Never try to remove the caseback,  
leave this to a certified watch repair  
technician or Freestyle service  
center. This will help in preventing  
water leakage from improper  
battery replacement.  
HOW TO USE THE TIMER  
To set the count down time,  
1
4
5
6
Press the S1 button to reset the  
second digits to 00.  
Select timer mode using the S3  
button. The last selected timer  
setting will be displayed.  
INTRODUCTION  
Press the S3 button. The minute  
digits will blink.  
Congratulations on your purchasing  
the Easy-Set Watch II. Designed for  
easy operation, the watch  
automatically tells you which button  
to use in a setting procedure. The  
watch has the following functions:  
The chime and alarm indicators will  
appear when their respective functions  
are active.  
FREESTYLE dealer for warranty  
information.  
8. It is advisable to have your watch  
pressure tested annually and to  
re-furbish your watch every 2-3  
years to extend the life of the watch.  
Use the S1 button to set the  
minutes. Press the button once to  
increase the digits by one unit or  
speed up the process by holding  
down the button.  
2
Use the S2 button to alter the  
setting. You can select among 1,  
3, 5, 10, 15, 20, 25, 30, 45 and 60  
minutes.  
WHEN AN ALARM OR HOURLY  
CHIME GOES OFF  
To start a countdown, press the S1  
button. Press the button again to stop  
the countdown or a third time to  
resume from where it left off.  
Real-time calendar clock for home  
time  
7
Press the S3 button. The hour  
digits will blink.  
A tune will go off by the hour if the  
hourly chime function is activated and  
a 20-second alarm tune will be emitted  
at the designated time when the alarm  
is active. To stop either tune, press any  
button.  
Second calendar clock for foreign  
time  
8
9
Use the S1 button to set the hours.  
Follow the same pattern to set the  
day-of-the-month,month, day-of-  
the-week, hour format and date  
format.For the hour format, you  
can choose 12-hour display with  
P indicator or 24-hour display. As  
for the date format, you can choose  
M-D (month-day) or D-M (day-  
month). The chosen formats will  
apply to both home and foreign  
settings.  
After reaching zero on a countdown,  
a 20-second beep will go off. To stop  
the beeping, press any button. The  
timer will reload automatically.  
Dual daily alarms and hourly  
chimes  
Stopwatch with split function  
10 preset countdown timers  
To disable the functions, select ALM 1  
or ALM 2 and use S1 button to turn off  
the indicator of the function as desired.  
BATTERY INFORMATION  
The watch uses a 3.0V lithium button  
cell battery, which in normal  
circumstances will be good for 1-2  
years. However, the battery life will  
vary due to shelf time and the manner  
the watch is used.  
The watch is also equipped with an EL  
back light to facilitate time reading at  
night or in dim light.  
HOW TO USE THE STOPWATCH  
For a straight forward count-up,  
HOW TO USE THE BACK LIGHT  
Press the LIGHT button once to turn  
on the back light for three seconds.  
1
Select stopwatch mode using the  
S3 button. The last recorded time  
of the stopwatch will be  
10 Press the S2 button to confirm the  
settings and return to current time  
display.  
displayed.Press the S2 button to  
clear the old record.  
DISPLAY MODES  
The watch has four display modes:  
TRIM  
 

Dyson Vacuum Cleaner DC 19 T2 User Manual
Echo Trimmer SRM 266 User Manual
EVGA Computer Hardware 730I User Manual
Fisher Price Baby Furniture T2518 User Manual
Fujioh Ventilation Hood BUF 08W User Manual
FUNAI CRT Television WF 1901 User Manual
Gamber Johnson Laptop Docking Station 7160 0486 User Manual
GenTran Power Supply R1020 User Manual
GE Range 49 8255 User Manual
Global Upholstery Co Computer Hardware 2801330 User Manual