Tips for Successful Vacuum Packaging Tips for Successful Vacuum Packaging
QuickStart
For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at www.foodsaver.com.
(continued)
V875
Sealing a Bag
GeneralTips
Make sure you’ve placed the bag in the proper
place. When making a bag from a roll, make sure end
of cut piece is on Sealing Strip (K), not over rubber
gasket (L) or in Vacuum Channel (I).
3 inches between paper towel and end of bag so that
bag seals properly with paper towel inside.
1. Vacuum packaging is NOT a substitute for the
heat process of canning. Perishables still need to
be refrigerated or frozen.
5. Do not create your own side seams for a
FoodSaver Bag. These bags are manufactured
with a special side seam, which is sealed all the
way to the outer edge.
Features of Your FoodSaver Appliance
Make sure the Seal Control Switch (E) is set to
Vacuum and Seal.
2. For best results, use FoodSaver Bags, Canisters
Instant Seal Button
Cancel Button
A
B
C
D
E
Prevent moisture or liquid from being pulled into
theVacuum Channel or trapped in the seal. Either
pre-freeze moist foods such as raw meat for 1-2
hours before vacuum packaging, or place a folded
paper towel between food and end of bag to
absorb excess liquids. Just be sure to leave at least
and Accessories.
6. To prevent wrinkles in seal when vacuum
packaging bulky items, gently stretch bag flat
along Sealing Strip before you close lid.
Make sure you give appliance time to cool down.
Wait at least 20 seconds between seals. Under very
heavy usage, appliance will shut off automatically to
prevent overheating. If it does, wait 20 minutes to
allow appliance to cool off.
3. During the vacuum packaging process, small
amounts of liquids, crumbs or food particles can
be inadvertently pulled into Vacuum Channel,
clogging the pump and damaging your appliance.
To prevent this, follow these tips:
7. If you are unsure your bag was sealed properly,
Accessory Port
Indicator Light
1
simply reseal bag about ⁄4 inch above first seal.
8. When you are vacuum packaging items with sharp
edges (dry spaghetti, silverware, etc.), protect
bag from punctures by wrapping item in soft
cushioning material, such as a paper towel. You
may want to use a canister or Mason jar instead
of a bag.
a. For moist and juicy foods such as raw meats:
Freeze first and avoid overfilling bags. You can
also place a folded paper towel inside top of bag,
but below seal area, before vacuum packaging.
b. For soups, sauces and liquids: Freeze first and
avoid overfilling bags. Or, use a canister in
refrigerator.
c. For powdery or fine-grained foods: Avoid
overfilling bags or use a canister. You can also
place a coffee filter or paper towel inside
before vacuum packaging.
Seal Control Switch
(3-Position)
Removing Air from a Bag
Make sure you’ve placed the bag in the proper
place. When vacuuming and sealing a bag, make
sure open end of bag is inside Vacuum Channel.
If motor runs for more than 30 seconds without
stopping, you may need to adjust bag and try again.
If you are making the initial seal on a piece of bag
material with two open ends, make sure bag is placed
on Sealing Strip, not on black rubber gasket. If you
are vacuum packaging with a bag, make sure open
end is placed down inside Vacuum Channel and make
sure Accessory Hose is not attached. If you are
vacuum packaging with an accessory, check Accessory
Hose in appliance lid and in accessory to ensure a
tight fit. Also make sure Seal Control Switch (E) is set
to Vacuum and Seal or Vacuum and Extended Seal.
Bag Cutter
F
9. When using accessories, remember to leave one
inch of space at top of canister or container.
Check for wrinkles in the bag along the Sealing
Strip. Wrinkles in seal may cause leakage and allow
air to come back into bag. Check for wrinkles in
bag along Sealing Strip before closing lid and vacuum
packaging. If you find wrinkles after sealing bag,
simply cut bag open and vacuum package again.
10.Pre-freeze fruits and blanch vegetables before
vacuum packaging for best results. See pages 2-3
of FoodSaver Reference Guide for more information.
d. If your appliance features a Drip Tray, empty it
after each use.
Accessory Hose
G
H
4. To avoid overfilling, always leave at least 3 inches
of bag material between bag contents and top of
bag. Then leave at least one additional inch of bag
material for each time you plan to reuse bag.
Roll Storage
Compartment
Vacuum Channel
DripTray
I
J
Sealing Strip
Rubber Gasket
K
L
Copyright © 2006 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc.
FoodSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int’l, Inc. in the United States and other countries. All other trademarks are
property of their respective owners. Tilia, Inc. and Tilia Int’l, Inc. are Jarden companies.This product is protected by one or more of the following Patents:
U.S. 4,660,355; 4,941,310; 5,655,357; 6,058,998; 6,256,968; Canada 1,315,746; and their equivalent international patents.
For important safety information and helpful tips, please refer to the FoodSaver Reference
(U.S.) or 1-877-804-5383 (Canada), Mon-Fri 8am-8pm, Sat 9am-6pm EST. Get tips on vacuum
packaging and order FoodSaver accessories.
Item # TXX-XXXX
(XX/06)
|