Sound ‘n Lights Monitor
Model Number 71565
Please read these instructions and keep them for future reference.
Includes two AC adaptors to power the transmitter and receiver.
The receiver also runs on battery power (9v alkaline – not included).
®
Fisher-Price
Your Sound ’n Lights Monitor
C
16
6
3
11
17
2
4
19
10
13
14
N
O
F
F
O
OFF ON
POWER
9
POWER
5
B
A
B
A
CHANNEL
CHANNEL
12
®
ce
-Pri
er
ish
F
®
Fis
he
r-P
ri
ce
15
7
18
1
8
1
2
Transmitter . . . . . . . . . . . . . . .Sends (transmits) sounds to the receiver.
On/Off Switch . . . . . . . . . . . . .Turns the transmitter power“ON”or“OFF”.
Power Indicator . . . . . . . . . . .Lights up to let you know the transmitter is“ON”.
Microphone . . . . . . . . . . . . . . .For clear audio pick-up.
3
4
5
6
2-Position Channel Switch . . . .Allows you to change channels if interference occurs.
Flexible Antenna . . . . . . . . . . .Aids in sound transmission.
7 AC Adaptor Socket (on side). . .For use with the provided AC adaptor.
8
Receiver . . . . . . . . . . . . . . . . .Receives signal from the transmitter to hear sound.
9 Volume Dial . . . . . . . . . . . . . . .Controls the volume of sound.
10 Power Indicator . . . . . . . . . . . .Lights up to let you know the receiver is“ON”.
11 Moving Lights Display . . . . . . .Shows sounds are being transmitted.
12
Speaker . . . . . . . . . . . . . . . . . .Allows you to hear baby’s sounds.
13 2-Position Channel Switch . . . .Allows you to change channels if interference occurs.
14
AC Adaptor Socket (on side). . .For use with the provided AC adaptor.
15
Battery Compartment Door . . .For easy access to battery compartment.
16 Flexible Antenna . . . . . . . . . . .Aids in sound reception.
17
Belt Clip (on back) . . . . . . . . . .For added portability when moving from room to room.
18 AC Adaptors (2 included) . . . .Both the transmitter and receiver operate on standard household current
(120v AC outlet) with either of these AC adaptors.
19
On/Off Switch . . . . . . . . . . . . .Turns the receiver power“ON”or“OFF”.
3
• If a removeable rechargeable battery is used, it is only to
be charged under adult supervision.
• A rechargeable battery is to be removed from the
product before it is charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
Battery Installation
D
The receiver operates either with the AC adaptor
included with your Sound ’n Lights Monitor
or with a 9 volt alkaline battery.
9V
(LR6)
Set-Up and Use
E
Shown Actual Size
IMPORTANT NOTE! To prevent entanglement, never
place the transmitter in a crib or playpen. Place the
transmitter, receiver and AC adaptor cord(s) out of
baby’s reach.
Battery Compartment Door
Antenna
On/Off Switch
Channel Switch
Power
Indicator
AC Adaptor Jack
ON
OFF
ER
W
PO
B
A
L
NE
AN
CH
Finger
Tab
®
e
ic
r
r-P
e
h
is
F
• Locate the battery compartment door on the bottom of
the receiver.
• Push the finger tab on the battery compartment door to
open the battery compartment door.
Socket
AC Adaptor
Plug
• Snap the terminals of a fresh 9v alkaline battery into the
connectors.
Transmitter
• Close the battery compartment.
Please Note:
• Remove the battery during long periods of non-use.
Always remove an exhausted battery from the product.
Battery leakage and corrosion can damage the product.
• Never short circuit the battery terminals.
• A non-rechargable battery is not to be recharged.
• Place the transmitter in the same room with your child.
For best sound pick-up, point the microphone directly
toward the crib or play area. Make sure the antenna
points upward for best transmission.
• For best transmission, unwrap and fully extend the
AC adaptor cord. Insert the AC adaptor jack into the
transmitter socket.
• Insert the plug into a standard wall outlet.
• Set the transmitter channel switch to the same channel
as the receiver.
• Only a battery of the same or equivalent type as
recommended in the“Battery Installation”instructions is
to be used.
• Slide the on/off switch on the front of the transmitter to
the“ON”position.The power indicator will light.
4
• If you will be using the AC adaptor to power the
receiver, unwrap and fully extend the AC adaptor cord
for best reception. Insert the AC adaptor jack into the
side of the receiver.
Antenna
• Insert the plug into a standard wall outlet.
• Check to be sure the channel switch on the receiver is
set to the same channel as the transmitter.
• Slide the on/off switch on the front of the receiver to
the“ON”position. The power indicator will light.
• Adjust the volume by turning the volume dial to a
comfortable level.
Moving Light Display
Power Indicator
On/Off Switch
Channel Switch
AC Adaptor Jack
OFF ON
POWER
A
B
CHANNEL
Volume Dial
• The moving light display will light when sound is
received by the receiver.
• If all five bars in the moving light display light:
®
e
ric
r-P
he
Fis
– The receiver power is“ON”and the transmitter power
is“OFF”. (Turn the transmitter power“ON”.)
Plug
AC Adaptor
– The receiver is out of range of the transmitter. (Move
the receiver closer to the transmitter.)
– The receiver and the transmitter are not on the same
channel. (Set the channel switches on the transmitter
and receiver to the same channel.)
Receiver
AC Adaptor Use
– Loud sounds are transmitting.
Please Note:The moving light display will not light if the
battery is weak, even though you may still hear sounds.
Replace the battery with a fresh, 9v alkaline battery.
Antenna
• To protect your privacy, be sure to turn the transmitter
and receiver“OFF”when not in use.
Moving Light Display
On/Off Switch
Channel Switch
Power Indicator
Volume Dial
OFF ON
POWER
A
B
CHANNEL
®
Fis
he
r-P
ric
e
Receiver
Battery Use
• Decide whether you will use the AC adaptor or a
9v alkaline battery to power the receiver. If you will be
using the receiver near an outlet, we recommend using
the AC adaptor.
• Place the receiver where you can hear/see it. Or, wear
the receiver using the convenient belt clip. Make sure
the antenna points upward for best reception.
5
One (1) Year
Sound Reception
F
I
Limited Warranty
It is very important to test the sound
reception of the Sound ’n Lights Monitor before
first-time use and whenever you change the
location of the transmitter.
Fisher-Price, Inc., 636 Girard Avenue, East Aurora,
New York 14052, warrants that the Sound ’n Lights
Monitor is free from all defects in material and workman-
ship when used under normal conditions for a period of
one (1) year from the date of purchase.
• Test the Sound ’n Lights Monitor transmission and
reception. In the room you intend to use the transmit-
ter, have an adult speak into the transmitter. (If an adult
is not available,use a ticking clock or radio.) Place the
receiver in the room in which you intend to use the
receiver. Adjust the receiver location or volume dial
until you hear sounds clearly.
• If you experience interference (buzzing, static, etc.)
while using one channel setting, switch both units to
the other channel. Selecting a channel is usually a
one-time adjustment.
Should the product fail to perform properly, we will
repair or replace it, free of charge. Purchaser is respon-
sible for shipping the product to the address indicated
above and for all associated freight and/or insurance cost.
Fisher-Price, Inc. will bear the cost of shipping the
repaired or replaced item to you.This warranty is void if
the owner repairs or modifies the product.This warranty
excludes any other liability other than the above
mentioned, including but not limited to any incidental
or consequential damages.
• If interference occurs on both channels or if further
problems develop, please refer to the“Problems and
Solutions Guide”beginning on page 7.
SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLU-
SION MAY NOT APPLY TO YOU.
Care
THIS WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS
WHICH VARY FROM STATE TO STATE.
G
• Keep the Sound ’n Lights Monitor free from dust.
Important Note:The electronic components in the
Sound’n Lights Monitor are not designed for consumer
repair. Evidence of any attempt at consumer repair will
void the warranty. Return the AC adaptors, transmitter and
receiver (please remove the battery from the receiver
before sending to Fisher-Price, Inc. for service).
• The outer surface of the transmitter and receiver can be
cleaned with a cloth lightly dampened with a mild
cleaning solution.
• Do not immerse any part of the Sound ’n Lights Monitor.
FCC Note
H
(United States only)
Sound ’n Lights Monitor
Model Number: 1565
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Fisher-Price, Inc.
Consumer Affairs Department
636 Girard Avenue
East Aurora, New York 14052
6
Problems and Solutions Guide
J
IMPORTANT! If you have a problem with the Sound ’n Lights Monitor, first check the Problems and
Solutions Guide below. If you still experience a problem with the Sound ’n Lights Monitor, call Fisher-Price
Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment,
®
®
please call 1-800-382-7470. Or, write to: Fisher-Price Consumer Affairs,
636 Girard Avenue, East Aurora, New York 14052.
PROBLEM
PROBABLE CAUSE
Transmitter not turned“ON”
Power is turned“OFF”
SOLUTION
Transmitter power
indicator does not light
Turn the transmitter“ON”.
Make sure that any light switches that control power flow to
the wall outlet are“ON”.
Make sure house fuses and circuit breakers are“ON”.
AC adaptor not properly connected
AC adaptor problem
Check AC adaptor jack-to-socket and plug-to-outlet connections.
Test the transmitter using the other AC adaptor included with this
product. If the transmitter works with the other AC adaptor, call
Fisher-Price® at 1-800-432-KIDS to replace the broken AC adaptor.
Receiver power
indicator does not light
Receiver not turned“ON”
Power is turned“OFF”
Turn the receiver“ON”.
Make sure that any light switches that control power flow to the
wall outlet are“ON”.
Make sure house fuses and circuit breakers are“ON”.
AC adaptor not properly connected
AC adaptor problem
Check AC adaptor jack-to-socket and plug-to-outlet connections.
Test the receiver using the other AC adaptor included with this
product. If the receiver works with the other AC adaptor, call
Fisher-Price® at 1-800-432-KIDS to replace the broken AC adaptor.
Weak or dead battery
Replace the battery in the receiver with a fresh 9v alkaline
battery or use the AC adaptor.
No sound
Channel switches not on same setting
Set channel switch on transmitter and receiver to the same
channel.
Signal interference due to other nursery
monitors, cordless telephones, etc.
Change the channel setting on both the transmitter and the
receiver.
Identify and eliminate the source of interference.
Test reception by moving the transmitter and/or receiver to
different locations throughout the house. Relocate the
transmitter and/or receiver.
Out of range or insufficient signal
Test reception by moving the transmitter and/or receiver to
different locations throughout the house. Relocate the
transmitter and/or receiver.
Volume not turned up
Adjust volume control on receiver.
Improper antenna position
Make sure the antenna on the transmitter and receiver are
pointing upward.
Weak or dead battery in receiver
AC adaptor not properly connected
Replace the battery in the receiver with a fresh 9v alkaline
battery or use the AC adaptor.
Check AC adaptor jack-to-socket and plug-to-outlet connections.
7
PROBLEM
PROBABLE CAUSE
SOLUTION
Weak reception
Out of range or insufficient signal
Test reception by moving the transmitter and/or receiver to
different locations throughout the house. Relocate the transmitter
and/or receiver.
AC adaptor cord(s) not fully extended
Improper antenna position
Fully extend AC adaptor cord(s).
Make sure antennas are pointing upward.
Receiver moving light
display does not light
Weak or dead battery in receiver
Replace the battery in the receiver with a fresh 9v alkaline
battery or use the AC adaptor.
Interference
(buzzing, static, etc.)
Signal interference due to other
nursery monitors or cordless
telephones, etc.
Change channel switch on both transmitter and receiver to the
other channel.
Identify and eliminate source of interference. Do not use more
than one receiver or transmitter at the same time in the same
house.
Channel switches not on
same setting
Check channel switch on transmitter and receiver to be sure
they are on the same channel.
Feedback
(squealing or whistling)
Receiver is too close to the
transmitter
Move receiver further away from transmitter.
Volume is set too high
Lower volume on the receiver.
All five bars on the
receiver moving light
display light
Receiver power is“ON”but
transmitter power is“OFF”
Turn the transmitter power“ON”.
Out of range or insufficient signal
Move the receiver closer to the transmitter.
Channel switches not on same
setting
Check channel switches on transmitter and receiver to be sure
they are on the same channel.
AC adaptor not properly connected
to transmitter
Check AC adaptor jack-to-socket and plug-to-outlet connections.
If you have any questions about this product:
In Canada, call 1-800-567-7724, or write to:
Mattel/Fisher-Price, 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
In Great Britain, telephone 01734 770488.
In Australia, call the Fisher-Price Australian Consumer Advisory Service toll-free at 1-800-800-812, or write to:
Fisher-Price, Mattel Pty. Limited, 461 Plummer Street, Port Melbourne,Victoria 3207.
8
|