FENDER® JAZZMASTER™ ULTRALIGHT LOUDSPEAKER ENCLOSURE
Your new Jazzmaster™ Ultralight loudspeaker features a Jensen®
SPECIFICATIONS
12" (30.5 cm) speaker with a neodymium magnet, handling up to 250
watts of power. Designed to complement the Fender® Jazzmaster
PART NUMBER
SPEAKER
2277700000
Ultralight amplifier, the Ultralight speaker cabinet is constructed from
quality Italian poplar plywood. Please read these instructions and your
amplifier manual before making connections.
One 12" (30.5 cm) steel frame driver
2" (5.1 cm) voice coil
Neodymium magnet
Ultralight Connections
CABINET
5/8" (1.6 cm) Italian Poplar plywood
98.5 dB, 1 Watt - 1 Meter
250 Watts
To connect the Jazzmaster™
Ultralight speaker to an Ultralight
amplifier, use the Speakon® cable
included with the amplifier. Rotate
the Speakon® connector to align it
with the input slots, then fully insert
the connector.
SENSITIVITY
POWER HANDLING
IMPEDANCE
2 ohms
Rotate the connector clockwise until it
locks into place.
CONNECTIONS
4-Pole Speakon® Connector
using Pins 1+ and 1–
Disconnecting
ENCLOSURE VOLUME
VB = 0.8 ft3 (38.7 L)
Slide the locking tab back on the
connector while rotating the connector
counter-clockwise. Pull the connector out
from the input socket.
DIMENSIONS
Height:
15 1/4 in
15 1/4 in
10 1/4 in
(38.7 cm)
(38.7 cm)
(26.0 cm)
Width:
Depth:
Non-Speakon® Connections
WEIGHT
16 lb (7.3 kg)
If your amplifier does not have a
Speakon® speaker output, you will need
the appropriate speaker cable or adapter
to connect the Jazzmaster™ Ultralight
loudspeaker. Speaker cable should be
2-conductor, 16–gauge minimum with
the Speakon® connector wired:
Product specifications are subject to change without notice.
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA USA
Fender® and Jazzmaster™ are trademarks of FMIC.
Other trademarks are property of their respective owners.
© 2005 FMIC. All rights reserved.
��������������
1+ pin = Positive
1– pin = Negative
P/N 069332 REV A
|