®
POWERSHRED 460Ms
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
2
4
3
Continuous operation:
Up to 8-minutes maximum
or
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
8-minutes will trigger
Plug in and
turn ON (I)
Feed paper straight into
paper entry and release
Hold CD/card at edge,
feed right side of entry
and release
When finished
shredding set to
OFF (O)
20-minute cool down period.
ADVANCED PRODUCT FEATURES
Patented SafeSense® Technology
Stops shredding immediately when
hands touch the paper opening.
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions.
SAFESENSE® TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
3
®
Turn the shredder ON
Touch test area and
look for the SafeSense
indicator to illuminate
SafeSense is active and
working properly
®
®
(I) to activate SafeSense
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
CLEANING AUTO-START INFRARED SENSORS
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry).
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
TO CLEAN THE SENSORS
1
2
1
4
2
3
Press and hold forward
*Apply oil across entry
Turn OFF (O) and
unplug shredder
Locate Auto-start
infared sensor
Dip cotton swab in
rubbing alcohol
Using cotton swab, wipe
away any contamination
from the paper sensors
(
) 2-3 seconds
*Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding.
®
POWERSHRED 460Ms
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of additional costs incurred by Fellowes to provide parts or services outside of the country where the
defects in material and workmanship and provides service and support for 1 year from the date shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
be free from defects in material and workmanship for 7 years from the date of purchase by the TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
original consumer. If any part is found to be defective during the warranty period, your sole and for any consequential or incidental damages attributable to this product. This warranty gives you
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product except where different limitations, restrictions, or conditions may be required by local law. For
usage standards, shredder operation using an improper power supply (other than listed on more details or to obtain service under this warranty, please contact us or your dealer.
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Questions or Concerns?
Customer Service & Support
Troubleshooting
Troubleshooting
Registration
Replacement parts
General questions
Manuals
Canada
Mexico
+1-800-665-4339
+001-800-514-9057
+1-800-955-0959
United States
©2012 Fellowes, Inc. Part No. 407323 Rev C
|