MTP 15HD A Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission
systems.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
Step 2 — Transmitter Inputs
AUDIO
INPUT
•
•
•
Connect a computer (VGA) video source to the Input connector.
Connect a VGA monitor to the Monitor connector.
Plug a 3.5 mm stereo audio plug into the audio jack.
MONITOR
Step 3 — TP Cables Between Units
•
Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and
the receiver’s Input port.
T568A
Pin Wire color
T568B
Pins:
12345678
Wire color
1
White-green
Green
White-orange
Orange
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.
2
3
4
5
White-orange White-green
•
For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered Output port
and a daisy-chained receiver’s Input port.
Blue
Blue
White-blue
White-blue
6
7
8
Orange
Green
Step 4 — Receiver Outputs
Insert Twisted
Pair Wires
White-brown
Brown
White-brown
Brown
•
•
Connect a VGA monitor to the Output connector.
Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown
below.
NOTE: If you are using Enhanced Skew-Free™ AV
cable, use the TIA/EIA T568A standard only.
MONO AUDIO
ATTENTION: Connect the sleeves to ground (Gnd).
1
2
Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.
Mono output 1+
Mono output 1-
Sleeve(s)
Mono output 2+
Mono output 2-
Mono output 1
NO GROUND.
Sleeve(s)
Mono output 2
NO GROUND.
OUTPUT
Do not tin the wires!
Balanced Output
Unbalanced Output
Step 5 — Receiver DIP Switches
•
•
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
Composite Sync, (SOG), and Video switches — Set these switches as shown in the table below to
output the indicated format.
ON
1
2
3
4
5
6
Output Format
RGBHV
C Sync
SOG
Video
RGBS
RGsB
Component*
S-Video*
Composite*
NOTE: * Input video format must match.
•
End Unit switch — Set this switches up if either of the following is true:
•
•
The receiver being configured is the only receiver connected to the transmitter.
The receiver being configured is the last receiver in a daisy-chained system.
|