1450 Lakeside Dr., Waukegan, IL 60085 USA
330-677-4424 • 800-321-6699 • Fax: 330-667-4471
OWNER’S MANUAL
OPERATION INSTRUCTIONS
January 2006
ETA’s line of Conditioned
Power Distribution units are designed to extensive damage or destruction of
cause premature failure, or result in
refer trouble-shooting to a qualified
electronic technician or contact ETA
Customer Service for assistance.
prevent electrical damage to sensitive
electronic equipment from high ampli-
tude/short duration spikes, random
surges, and EMI/RFI noise, which is
inherent in utility power lines. Power
line sources which are not precondi-
tioned or filtered can affect reliable
operation of sensitive audio, computer, indicates the power conditioning cir-
and other electronic equipment, and
may cause premature failure, expensive outlets are powered. Maximum total
electronic equipment.
ETA Conditioned Power Dis-
tribution units feature a master power
switch, conveniently located on the
front control panel, that switches the
rear panel AC outlets ON and OFF. An
LED next to the master power switch
EASY INSTALLATION
The PD9L is easily mounted
into a standard 19-inch rack or placed
into a free-standing position. With the
cuitry is working and the rear panel AC master power switch in the OFF posi-
tion, plug the line cord into a conven-
ient AC receptacle. Place the unit’s
power switch into the ON position and
check that the front panel LED is lit.
repairs, or unanticipated replacement
from non-repairable damage.
wattage input is 1800 watts and the 8
power output receptacles, located on
As inherent problems in utility back panel and one on front panel, are
AC power lines increase for various
reasons, and the need for noise-free,
conditioned power increases, ETA is
protected with a 15-amp (total unit) re- The lit LED indicates conditioned and
settable circuit breaker. filtered AC power is connected. Then,
Note: The front panel LED is with their master power switches in the
there with the units to protect your valu- normally lit when the power switch is in OFF position, plug the equipment to be
able electronic equipment. With present the ON position. If the power switch is protected into the PD's rear panel AC
demands on the power utilities, voltage ON and the LED is not lit, power may
receptacles. Turn on the power switches
spikes, power surges, electrical noise,
and power failures are commonplace.
This "garbage" in the power delivered
still be present on the output AC recep- of the equipment plugged into the
tacles, but the power conditioning cir-
cuitry is not working. Do not continue
PD9L..
NOTE: The PD9L is UL recognized
can reduce the fidelity of audio systems, use of the power conditioning unit and and has a one-year limited warranty.
All designs and specifications are subject to change without notice. Copyright © 2004 ETA Systems.
|