CONTENTS
1
2
3
4
5
6
7
8
Introduction
Operation Notes
Features
Panel Layout
Panel Descriptions
Connecting And Operating The Gefen TV CR Speaker
Specifications
Warranty
INTRODUCTION
Congratulations on your purchase of the Gefen TV CR Speaker. Your complete
satisfaction is very important to us.
Gefen TV
Gefen TV is a unique product line catering to the growing needs for innovative
home theater solutions. We specialize in total integration for your home theater,
while also focusing on going above and beyond customer expectations to ensure
you get the most from your hardware. We invite you to explore our distinct
product line and hope you find your solutions. Don’t see what you are looking for
here? Please call us so we can better assist you with your particular needs.
The Gefen TV CR Speaker
The Gefen TV CR speaker system consists of exquisitely designed and tuned
speakers which perfectly compliment the small confines of a bedroom or
conference room. The CR speakers have been designed for high-quality audio
fidelity rather than booming bass and high volume output. These wall-mountable
speakers feature a handsome exterior construction and will fit stylishly in a
variety of decors.
The Gefen CR speakers are perfectly suited to work with any audio amplifier,
especially the Gefen TV Audio Processor, for which they were designed.
How It Works
Simply connect the Gefen CR speakers to your amplifier. The CR speakers are
equipped with 5-way binding posts having connectors as follows: bare wire,
spade lug connectors, pin connectors, and two types of banana plugs (single and
dual).
Once all of your AV system connections are established, set the amplifier’s
volume to a low level, turn on all connected AV equipment, and then increase
speaker output volume to a comfortable level.
1
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE GEFEN TV CR SPEAKER
•
•
Gefen TV CR Speaker are rated for a maximum power handling of 50 Watts
RMS.
The Gefen TV CR Speaker was designed to be placed within 8 inches of
a wall. For this reason the Gefen TV CR Speaker comes ready to be wall
mounted.
•
•
Gefen TV recommends the GTV-MB-CRSP for use with these speaker as a
mounting bracket.
The Gefen TV CR Speaker weighs approximately 6.4 pounds and
appropriate caution should be taken when mounting and using a wall
mounting bracket.
•
For additional bass response the Gefen TV CR Speakers should be paired
with a subwoofer. In this scenario, the speaker setting in the amplifier/
receiver should be set to small. The recommended crossover should also be
set to 80Hz.
2
FEATURES
Features
•
•
•
•
Carefully designed and tuned speakers
Incredibly pristine sound from a compact design
Designed to fill small rooms with high-quality sound
Speaker baffle naturally tilts upward on flat surfaces
Package Includes
GTV-CR-2SP
(1) CR-2SP Set of 2 Speakers
(1) User’s Manual
GTV-CR-3SP
(1) CR-3SP Set of 3 Speakers
(1) User’s Manual
GTV-CR-5SP
(1) CR-5SP Set of 5 Speakers
(1) User’s Manual
3
PANEL LAYOUT
Front View
1
Back View
2
3
4
4
PANEL DESCRIPTIONS
1
2
Gefen TV CR Speaker Grille
This removable grille will protect the speaker divers from getting damaged and
will provide a stylish look to your speaker.
Speaker Mounting Bracket
This bracket was designed to work with the GTV-MB-CRSP speaker bracket.
Additional aftermarket brackets can be used. Please ensure that the minimum
weight capacity of any aftermarket speaker bracket exceeds 6.4 lbs.
3
4
Positive Speaker Terminal
This terminal is a 5-way binding post that will accept multiple connection types.
For a complete listing of these types, please see page 6. This terminal should be
connected to the positive terminal on an amplifier.
Negative Speaker Terminal
This terminal is a 5-way binding post that will accept multiple connection types.
For a complete listing of these types, please see page 6. This terminal should be
connected to the negative terminal on an amplifier.
5
CONNECTING AND OPERATING THE GEFEN TV CR SPEAKER
How to Connect the Gefen TV CR Speaker
1. Connection options for the Gefen TV CR Speaker:
NOTE: These are 5-Way binding posts. In addition to the connectors above,
this speaker will also accept Dual Banana Plug connectors.
To connect all types of connectors-except for the Banana Plug connectors-
unscrew the binding post in a counter-clockwise motion. Insert the speaker wire/
connector into the post and re-tighten the binding post. These connector only
need to have good contact and should only be hand tightened.
Banana Plug connectors can simply be inserted into the opening on the end of each
binding post.
6
SPECIFICATIONS
System:
Low Frequency Driver
Low Frequency Driver 1 x 100mm
with 25mm voice coil & Ferrite mo-
tor & Cone Pulp paper coating black
& Surround NBR rubber
High Frequency Driver
1 x 25mm with Neodymium motor &
Silk dome
Frequency Response (-3dB)
Frequency Response (-10dB)
System Sensitivity (2.83V@1m)
Nominal Impedance
Maximum Output SPL
Average
75Hz -- 18kHz
60Hz – 20kHz
85dB
4 Ohms
99dB
Peak
105dB
Long term power (W)
Weight (Ibs / kg)
30W
6.4lbs / 2.9kg
Enclosure:
Enclosure Type
Enclosure Material
Finish
2-Way Reflex
Medium Density Fibreboard
Matte White
Dimensions (H x W x D):
mm
256 x 145 x 184
10 x 5.7 x 7.2
Inches
7
WARRANTY
Gefen warrants the equipment it manufactures to be free from defects in material
and workmanship.
If equipment fails because of such defects and Gefen is notified within two (2)
years from the date of shipment, Gefen will, at its option, repair or replace the
equipment, provided that the equipment has not been subjected to mechanical,
electrical, or other abuse or modifications. Equipment that fails under conditions
other than those covered will be repaired at the current price of parts and labor in
effect at the time of repair. Such repairs are warranted for ninety (90) days from
the day of reshipment to the Buyer.
This warranty is in lieu of all other warranties expressed or implied, including
without limitation, any implied warranty or merchantability or fitness for any
particular purpose, all of which are expressly disclaimed.
1. Proof of sale may be required in order to claim warranty.
2. Customers outside the US are responsible for shipping charges to and from
Gefen.
3. Copper cables are limited to a 30 day warranty and cables must be in their
original condition.
The information in this manual has been carefully checked and is believed to
be accurate. However, Gefen assumes no responsibility for any inaccuracies
that may be contained in this manual. In no event will Gefen be liable for
direct, indirect, special, incidental, or consequential damages resulting from
any defect or omission in this manual, even if advised of the possibility of such
damages. The technical information contained herein regarding the features and
specifications is subject to change without notice.
For the latest warranty coverage information, please visit Gefen’s Warranty web
PRODUCT REGISTRATION
Please register your product online by visiting Gefen’s web site at
8
Rev A
20600 Nordhoff St., Chatsworth CA 91311
1-800-545-6900 818-772-9100 fax: 818-772-9120
Pb
|