WPD Series Wallplates • Installation Guide
The Extron WPD Series (WPD 110 A, WPD 120 A, WPD 130 A and WPD 140 A) are single
gang pass-through wallplates with HDMI, DisplayPort, DVI or VGA front connectors and
pigtail mounted rear connectors. All models can be installed in single gang junction boxes,
and include a Decora®-style trim plate. The models are as follows:
DVI
DISPLAYPORT
COMPUTER
A
B
C
A
B
C
A
B
C
A
B
C
e
e
e
e
Side View
WPD 130 A
WPD 140 A
WPD 120 A
WPD 110 A
z
z
z
z
WPD 110 A — HDMI, stereo audio, and control
о
о
о
HDMI female to HDMI female connector on a pigtail
3.5 mm stereo audio jack with 3-pole captive screw connector
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
WPD 120 A — DisplayPort, stereo audio, and control
о
о
о
DisplayPort female to DisplayPort female connector on a pigtail
3.5 mm stereo audio jack with 3-pole captive screw connector
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
WPD 130 A — DVI, stereo audio, and control
о
о
о
DVI-I female to DVI-I female connector on a pigtail
3.5 mm stereo audio jack with 3-pole captive screw connector
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
WPD 140 A — VGA, stereo audio, and control
о
о
о
15-pin VGA female connector on a pigtail
3.5 mm stereo audio jack with 3-pole captive screw connector
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
Install the wallplate directly into the wall using the supplied mud ring or a UL-listed 1-gang
junction box (not supplied). Follow the steps in the “Installation” section on page 2.
Planning — Check the Proposed Installation Location
Before starting the installation it is important that you do the following:
CAUTION: Risk of Personal Injury. Failure to check the items listed below may result in
personal injury.
ATTENTION: Failure to check the items listed below may result in property damage.
Ensure there are no utility cables or pipes at the intended location that might be
damaged or cause injury when you are installing the device.
Check that the installation meets the local and state regulatory requirements, including
building, electrical, and safety codes, and UL and ADA accessibility requirements.
c
c
CONTINUED ON PAGE 2
|