IDC Icemaker Adaptor Kit Installation Instructions
INSTALLATION INSTRUCTIONS
IDC ICEMAKER ADAPTOR KIT FOR P/N 629088733
1.
2.
3.
4.
5.
Place ice slide into ice drop opening in
bin (see FIGURE 2).
Place bar into first set of pockets inside
the ice bin.
Icemaker
Adaptor
Kit
Place Icemaker Adaptor Kit on top of
unit.
Place icemaker on top of kit. DO NOT
slide icemaker into position on the lid.
Apply continuous bead of NSF
international (NSF) listed silastic
sealant (Dow 732 or equivalent),
supplied in kit, to seal the icemaker to
the top of the adapter kit. All excess
sealant must be wiped away
immediately.
Bar
6.
Drill 9/64” diameter holes, using one of
the two supplied brackets as a
template, into the rear of the icemaker
and the rear of the icemaker adapter
kit. USE EXTREME CARE NOT TO
DRILL INTO ANY ICEMAKER
COMPONENTS!!! Secure the icemaker
to the adapter using the screws and
brackets provided.
7.
For optimal performance, do not fill ice
bin more than 2/3 capacity (maximum
fill is 4” below top of bin). Applies to IDC
255 models only.
FIGURE 1
Ice Slide
FIGURE 2. Ice Slide Assembly
Revision Date: May 4, 2006
© 2006, IMI Cornelius Inc.
Revision: A
- 1 -
Publication Number: 629088733INS
|