I N S T A L L A T I O N I N S T R U C T I O N S
DISPLAY COVER ACCESSORY
DGP32, 42, 50
Installation Instructions
DGP32, 42, 50
DIMENSIONS
DGP42
Measurements in: inches [millimeters]
DGP50
Measurements in: inches [millimeters]
3
DGP32, 42, 50
Installation Instructions
LEGEND
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
TOOLS REQUIRED FOR INSTALLATION
7/16" (11.11 mm)
PARTS
(A)
A (1) - Display Cover with support brackets
B (8) - Bolt assemblies
C (4) - Clamp bracket
(C)
D (8) - Flange nuts
(B)
(D)
4
Installation Instructions
DGP32, 42, 50
Top of Cover:
Base of bolts
engaged in
Assembly And Installation
slot notches
CAUTION: Overheating may cause damage or display
failure. Use correct size display cover to allow air circulation
around and behind display to prevent overheating.
NOTE: Access to back of display is necessary for installation
Sides/Bottom of Cover:
Base of bolts parallel
to slots
of DGP display cover.
Adjusting Display Cover Size
1. Measure height and width of display.
2. Loosen and remove flange nuts (D) and padded tubes on
bolt assemblies (B). (See Figure 1)
(B)
Figure 2
4. Position bolts and tighten the flange nuts securely against
the padded tubes. (See Figure 1)
5. Place cover on display.
NOTE: Sponge bumpers and padded bolts may be used to
prevent scratches on display.
Slot
6. Check display alignment and adjust as necessary.
7. Install clamp brackets (C) over the bolt ends (B). (See
Figure 3)
(D)
Padded
Tube
(B)
(D) x 4
Figure 1
(C)
3. Adjust and position bolts (B) into the slots which provide the
correct spacing.
NOTE: Engage base of bolts at top of cover in the slot notches.
Base of bolts on sides and bottom of cover should be
parallel to the slots. (See Figure 2)
Figure 3
8. Secure with flange nuts (D).
NOTE: Clamps may be rotated to best fit cover to display.
5
DGP32, 42, 50
Installation Instructions
USA/International
Europe
A
P
F
A
P
F
8401 Eagle Creek Parkway, Savage, MN 55378
800.582.6480 / 952.894.6280
877.894.6918 / 952.894.6918
Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
+31 (0)40 2668620
+31 (0)40 2668615
Asia Pacific
A
Room 30I, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA. Post Code: 518112
8831-000014
¤2007 Chief Manufacturing
03/07
P
F
+86-755-8996 9226 ; 8996 9236 ; 8996 9220
+86-755-8996 9217
|