MG25 DuraGate
FOR OPENINGS 26.5” (67cm) - 41.5” (105cm) • Average installed height 29.5” (75cm)
ASSEMBLY INSTRUCTIONS
A
F
B
D
C
OPTION
ONE-WAY
STOP BRACKET
*
2
3
1
C or D
F
F
2X
4X
3. Loosen width adjustment
set screws at top and
bottom of gate with allen
wrench (F) slightly to
allow gate to expand.
Keep plastic shipping
tabs in place.
CARDINAL GATES
1 ”
2. Level gate by
adjusting
telescoping tube
attached to upper
gate with allen
wrench (F).
1. Place gate on top of carton to establish height.
Use short screws (C) for doorframes or longer
screws (D) into drywall to reach a stud.
A
A
4
5
C or D
2X
5. Separate bracket from rod and mount as marked.
FOR ONE-WAY OPERATION: Read STEP SEVEN
and install safety bracket on bottom hole.
4. Attach latch bracket (A) to latch rod with
bracket snug against bottom of eye bolt.
Expand gate so that latch bracket (A) is against
mounting surface. Mark holes.
OPTION
STOP BRACKET
6
7
ONE-WAY
B
F
6. Use Allen wrench (F) to tighten adjustment set
7. Install one-way stop bracket (B) on one side of
latch if you wish to have gate open in only one
direction.
screws after removing plastic shipping tabs.
GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.
|