™
SPS Removal / Installation
Instructions
1
2
G512 Part List:
1. Speaker Gasket
2. SPS Assembly
3. G5 Basket Assembly
4. Top Screw x 8
3
4
5. Bottom Screw x 10
G510 Part List:
1. Speaker Gasket
2. SPS Assembly
3. G5 Basket Assembly
4. Top Screw x 8
5
5. Bottom Screw x 8
™
™
SPS Assembly Installation Instructions
SPS Assembly Removal Instructions
1. Install the SPS assemblyvinto the basketw. The basket and frame
1. Remove the integral gasketu.
™
™
are notched to prevent the SPS assembly from being installed
2. Remove the top screws that secure the SPS assemblyvto the bas-
™
™
incorrectly. Make sure the SPS assembly mounts firmly into the
ketw. Eight top screwsxsecure the SPS assembly to the top of the
™
frame with the speaker terminals located in the correct location.
frame (mounting flange) and 10 bottom screwsy (G512) and 8 bot-
y
2. Install the top screws that secure the SPS assemblyvto the basket.
tom screws (G510) secure the SPS assembly to the frame (top
plate/spider).
™
™
Eight top screwsxsecure the SPS assembly to the top of the frame
™
(mounting flange) and 10 bottom screwsy (G512) and 8 bottom
screws y(G510) secure the SPS assembly to the frame (top plate/spi-
3. Once all the screws are removed, the SPS assembly will slide out of
™
™
™
der).
the basket. Use care when removing the SPS assembly from the
basket.
3. Install the integral gasketu.
Boston Acoustics, Inc. 300 Jubilee Drive, Peabody, MA 01960 USA
T: 978.538.5000 F: 978.538.5100 W: bostonacoustics.com
Warning: If disassembling the G5 for customization; where the
SPS, is a trademark and Boston, Boston Acoustics, and the Boston Acoustics logo
are registered trademarks of Boston Acoustics, Inc. Specifications are subject to
change without notice.
™
™
SPS will be reused, store the SPS assembly in a safe location
with the voice coil facing up and protected; damage to the voice
™
All rights reserved. Covered by patents issued and/or pending.
coil, even minor damage, can ruin the SPS assembly.
© 2004 Boston Acoustics, Inc.
042-002216-0
|