Protecting the environment
Unpack the appliance and dispose of its packaging in such a
way that no damage is caused to the environment.
Energy-saving advice
■ Always place the correct lid on cookware. Cooking with an
uncovered pan will result in a four-fold increase in energy
use. Use a glass lid to provide visibility and avoid having to
lift the lid.
Environmentally-friendly disposal of waste
products
■ Use cookware equipped with a solid, flat bottom. Curved pan
bases increase energy consumption.
This appliance conforms to the Waste Electrical and
Electronic Equipment Directive WEEE 2002/96/EC.
This directive defines the framework for recycling used
appliances within European territory
■ The diameter of the pan base must match the size of the
hotplate. If not, energy may be wasted. Note: The
manufacturer normally indicates the pan's upper diameter.
This is normally greater than the diameter of the pan's base.
■ Choose cookware of a size suited to the amount of food you
are going to cook. A large pan that is only half full will use a
lot of energy.
■ Use a small amount of water when cooking. This saves
energy, and vegetables retain their vitamins and minerals.
■ Select a lower power level.
Induction cooking
Other suitable cookware for induction
Advantages of induction cooking
Induction cooking represents a radical change from the
traditional method of heating; the heat is generated directly in
the pan. It therefore offers a number of advantages:
There are other types of cookware especially made for
induction whose base is not entirely ferromagnetic.
When using large cookware on a
smaller ferromagnetic zone, only
the ferromagnetic zone heats up,
so heat might not be uniformly
distributed.
■ Time savings for cooking and frying; since the pan is heated
directly.
■ Energy is saved.
■ Care and cleaning are simpler. Foods that have spilt do not
burn as quickly.
Cookware with aluminium on the
base reduce the ferromagnetic
zone, so less heat may be sup-
plied or be difficult to detect.
■ Heat and safety control; the hob supplies or cuts off power
immediately when the control knob is turned on. The
induction hotplate stops supplying heat if the pan is removed
without having previously switched it off.
For good cooking results, the
diameter of the cookware's ferro-
magnetic area should match the
size of the hotplate. If cookware
is not detected on a hotplate, try
it on the next smaller hotplate
down.
Suitable pans
Ferromagnetic pans
Only ferromagnetic pans are suitable for induction cooking,
these may be made from:
■ enamelled steel
Unsuitable pans
■ cast iron
Never use pans made from:
■ special cutlery for stainless steel induction pan
■ common thin steel
■ glass
To determine whether a pan is suitable, check to see if a
magnet will stick to it.
■ earthenware
■ copper
■ aluminium
Characteristics of the pan base
The characteristics of the pan base may affect the uniformity of
the cooking results. Pans made from materials which help
diffuse heat, such as stainless steel sandwich pans, distribute
heat uniformly, saving time and energy.
Absence of pan or unsuitable size
If no pan is placed on the selected hotplate, or if it is made of
unsuitable material or is not the correct size, the power level
displayed on the hotplate indicator will flash. Place a suitable
pan on the hotplate to stop the flashing. If this takes more than
90 seconds, the hotplate will switch off automatically.
5
