Quick Setup Guide
TM
WARNING: Do not use the controller if you have respiratory, heart or
other physical ailments that limit your physical activity. If
you have any doubts, consult with a doctor.
WARNING: This guitar is not intended for small children. This guitar
may contain small pieces that should be kept away from
small children as they may pose a choking hazard.
WARNING: Do not plug the guitar controller's cable into two game
consoles at the same time, or into other game consoles or
ports that are not supported by this guitar.
Wired 4-in-1 Grinder Guitar
TM
TM
for PS2 and PS3
TM
Designed for use with RockBand and Guitar Hero® games.
Model: BH1101
PlayStation®2 and PlayStation®3 are registered trademarks of Sony Computer Entertainment Inc.
This product is not sponsored, endorsed or approved by Sony.
1
PS2 & PS3 Guitar Hero
3
Check the Light Indicators
1
Choose game
LED
GH
RB
G H
R B
G H
R B
Guitar Front
When your guitar connects with the console successfully, one of
the four indicators will be illuminated to indicate the controller
number.
Guitar Front
Switch to "GH"
4
Removing Faceplate
2
Connect
G H
R B
Faceplate
Release Button
USB
DONGLE
Knob of the
Effects Switch
Grasp the little white knob on the top of the Effects Switch then
gently pull outwards and be careful not to lose it. Now grasp the
faceplate Release Button and squeeze both buttons together
while lifting upwards.
Insert PS2 gameport plug into PS2 if playing PS2 and insert USB
plug into PS3 if playing PS3. Then power on your game console.
Note: Do not insert USB and Gameport plugs at the same time!
If you are experiencing technical difficulties, please repeat steps 1 to 3 to ensure
you are doing things properly.
Tips：
If it still isn't working, please double check another Guitar controller on your
console to make sure the console is working OK.
2
3
PS2 & PS3 Rock Band
3
Check the Light Indicators
1
Choose game
LED
GH
RB
G H
R B
G H
R B
Guitar Front
When your guitar connects with the console successfully, one of
the four indicators will be illuminated to indicate the controller
number.
Guitar Front
Switch to "RB"
4
Removing Faceplate
2
Connect
G H
R B
Faceplate
Release Button
USB
Knob of the
DONGLE
Effects Switch
Grasp the little white knob on the top of the Effects Switch then
gently pull outwards and be careful not to lose it. Now grasp the
faceplate Release Button and squeeze both buttons together
while lifting upwards.
Insert the USB plug into PS2 or PS3.
Note: Do not insert USB and Gameport plugs at the same time!
If you are experiencing technical difficulties, please repeat steps 1 to 3 to ensure
you are doing things properly.
Tips：
If it still isn't working, please double check another Guitar controller on your
console to make sure the console is working OK.
4
5
WARRANTY AND TECHNICAL SUPPORT
Button Configuration
Every Blockhead branded product comes with a 90 day warranty (U.S. Only). Blockhead will
replace, repair or refund any defective products or components at no charge to you within 90
days of the purchase date. This warranty does not apply if the Blockhead branded product has
been damaged by misuse, neglect, or reasons unrelated to defective materials or assembly.
Blockhead is not responsible or liable for loss of data or loss of equipment use. You must retain
a copy of your original receipt for warranty support.
Start
LED
D-Pad
Select
PS Button
GH/RB
Switch
For support on Blockhead products, contact us by visiting www.blockheadgaming.com or call
us at 727-431-0650.
G H
R B
For general questions, comments, information or grammar tips, email us at
FCC INFORMATION
Fret Buttons
Whammy Strum
Bar
Bar
Effects
Switch
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instru
-ctions, may cause harmful interference to radio communications.However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Guitar Front
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Detachable Neck
Button System
Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate equipment.
Guitar Back
6
7
|