BMW Automobile Parts X5 User Manual

Parts and Accessories  
Installation Instructions  
F 53 0408 2W  
Retrofit running-board side skirt  
BMW X5 (E53)  
Only for use within the BMW dealer organisation.  
Installation time approx. 2 hours.  
The installation time may vary depending on the condition of the car and the equipment in it.  
Retrofit / Installation kit No. 51 71 0 017 315  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
Issue date 01.2001  
 
Important information  
Installation instructions  
All work is shown on the left-hand side of the car. Proceed in exactly the same way on the right-  
hand side.  
Target group  
The target group for these installation instructions is staff trained on BMW cars with specialist  
knowledge of vehicle electrical systems.  
Work:  
All servicing, repair and installation work on BMW cars is conducted at your own risk.  
All work is to be completed using the current BMW  
- Repair manuals  
- Circuit diagrams  
in a rational order using the prescribed tools (special tools) and in compliance with current health  
and safety regulations.  
Tools and equipment required  
Set of flat screwdrivers  
Set of 1/2 inch sockets  
1/2 inch torque wrench  
Blind rivet pliers  
2 mm centrepunch  
Hammer  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/3  
Issue date 01.2001  
 
1.  
Preparations  
0
0
0
0
0
Drive out the expanding rivets (1) and remove the  
side skirt trim (2) upwards.  
2
1
3
F 53 0410 2W  
0
0
0
Drive out the expanding rivets (1) and blind rivets  
(2) and remove the rear wheel arch trim (3).  
1
2
1
F 53 0411 2W  
Drive out the expanding rivets (1) and blind rivets  
(2) and remove the front wheel arch trim (3).  
3
1
2
1
F 53 0412 2W  
Undo the hexagonal screws (1) and remove the  
mounting for the side skirt trim (2).  
2
1
F 53 0413 2W  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/4  
Issue date 01.2001  
 
2. Component overview  
0
2
3
4
5
1
11  
7
8
10  
6
9
F 53 0409 2W  
0
0
1
2
3
4
5
6
7
8
9
Wheel arch trim, front right  
Side skirt trim, right  
Running-board, right  
Running-board trim, right  
Wheel arch trim, rear right  
Wheel arch trim, rear left  
Running-board trim, left  
Running-board, left  
Side skirt trim, left  
10 Wheel arch trim, front left  
11 Small parts  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/5  
Issue date 01.2001  
 
3. To install the running-board side skirt  
0
0
Position the running-board side skirt (1) and turn  
the enclosed hexagonal screws (2) in two or three  
turns.  
The running-board side skirt (1) must still be  
movable in the oval holes."  
1
2
F 53 0414 2W  
F 53 0415 2W  
F 53 0417 2W  
F 53 0418 2W  
0
0
0
0
0
0
Insert the trim for the rear wheel arch (1) into the  
running-board side skirt (2).  
2
1
Secure the trim for the rear wheel arch (1) to the  
wheel arch using the enclosed blind rivets (2).  
2
1
Secure the trim for the rear wheel arch (1) to the  
side skirt using the enclosed blind rivet (2) and  
expanding rivet (3).  
1
3
2
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/6  
Issue date 01.2001  
 
3. To install the running-board side skirt  
0
0
0
0
0
Insert the trim for the front wheel arch (1) into the  
running-board side skirt (2).  
1
2
F 53 0416 2W  
0
Secure the trim for the front wheel arch (1) to the  
wheel arch using the enclosed blind rivets (2).  
1
2
F 53 0420 2W  
0
Secure the trim for the front wheel arch (1) to the  
side skirt using the enclosed blind rivet (2) and  
expanding rivet (3).  
1
2
3
F 53 0419 2W  
0
Align the running-board side skirt (1) centrally and  
tighten the screws (2) with a torque of 24 Nm.  
1
2
F 53 0421 2W  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/7  
Issue date 01.2001  
 
3. To install the running-board side skirt  
0
0
Attach the trim for the side skirt (1) to the top of the  
running-board side skirt (2) and clip it into the front  
and rear wheel arch trims at the sides.  
Secure it to the side skirt at the bottom using the  
enclosed expanding rivets (3).  
2
1
F 53 0422 2W  
3
0
0
Clip the trim for the running-board (1) into the  
running-board side skirt (2).  
1
2
F 53 0423 2W  
Retrofit / Installation kit No. 51 71 0 017 315  
Installation instructions No. 01 29 0 134 596  
EN/8  
Issue date 01.2001  
 

Beko Washer WMA 510 S User Manual
Bissell Carpet Cleaner 90Y5 User Manual
Black Decker Hot Beverage Maker MDG550 User Manual
Blue Rhino Charcoal Grill GBC976W User Manual
Bostitch Air Compressor 175869REVA User Manual
Brother Computer Drive HL 1650 1670N User Manual
Canon Photo Printer CP 10 User Manual
Carrier Thermostat 33CS400 01 User Manual
Casio Cash Register V R100 User Manual
Chicago Electric Work Light 66439 User Manual