3-264-412-11(1)
Installing the satellite speakers
(See fig. A)
Troubleshooting
Should you encounter a problem with your speaker
system, check the following list and take the indicated
measures. If the problem persists, consult your nearest
Sony dealer.
C
PC, CD or MD
Walkman, etc.
Use the supplied screws to attach the base to the
satellite speaker. The satellite speaker can be used either
placed on a desk or attached to a wall.
There is no sound from the speaker system.
Act ive Sp e a ke r Syst e m
•
•
•
•
Make sure all the connections have been correctly
made.
Make sure the VOLUME dial and the each speaker’s
volume dial on the control box.
Make sure the connected component has been turned
up properly.
When you use the satellite speaker on a desk
(See fig. A-A)
By attaching the base to the satellite speaker, it can be
placed on a desk.
Operating Instructions
Manual de instrucciones
1
Match the hole of the base and the
Check if headphones are connected. If they are,
disconnect them.
bottom hole of the satellite speaker.
Attach the base with the anchor holes facing
forward.
The sound is distorted.
•
Turn down the volume level on the connected
component. Or, if the connected component has a
BASS BOOST function, set it to off.
Rotate BASS on this unit to reduce the bass volume.
Turn VOLUME on this unit down to reduce the
volume.
The base allows you to adjust the satellite speaker
to the desired angle.
SRS-D2100
•
•
2
Ensure the screw s are tight.
Tighten the screw with your finger. If it is difficult,
use a screwdriver to secure the screw.
Subwoofer
2004 Sony Corporation
Printed in China
There is hum or noise in the speaker output.
•
Front speaker (Left)
Control box
Make sure all the connections have been correctly
made.
Make sure none of the audio components are
positioned too close to the TV set.
When you use the satellite speaker attached
to a w all (See fig. A-B)
By attaching the base to the satellite speaker, it can be
attached to a wall. Follow the Notes (below) to install
safely. Improper installation may result in the speaker
falling and causing bodily injury or damage to the
speaker or other object.
Owner’s Record
•
The model number and the serial number are located on the rear of the
subwoofer.
Record the model number and the serial number in the space provided below.
Refer to them whenever you call upon your Sony dealer regarding this product.
Front speaker (Right)
The sound has suddenly stopped.
Make sure all the connections have been correctly made.
The brightness of the POWER indicator is
unstable.
The brightness of the POWER indicator may become
unstable when the volume is turned up. This is not a
malfunction.
Model No. SRS-D2100
Serial No.
1
Align the hole in the base w ith the hole
at the rear of the satellite speaker.
Attach the base with the anchor holes uppermost.
The base allows you to adjust the satellite speaker
to the desired angle.
D
POWER
PHONES
Package Contents
2
3
Ensure the screw s are tight.
Tighten the screw with your finger. If it is difficult,
use a screwdriver to secure the screw.
Specifications
ON
OFF
POWER
PHONE
Control box
MIN
MAX
Speaker section
Satellite speaker
Speaker system
Speaker units
Enclosure type
Impedance
VOLUME
BASS
Secure the hollow w all anchor in the w all
— refer to the illustration.
Full range, magnetically shielded
5.6 cm, cone type
Closed type
6 Ω
3 m
VOLUME
Notes
•
Confirm wall thickness is sufficient. A
minimum thickness of 9.5 mm is recommended
for plasterboard.
Cord length
Subw oofer
Speaker system
Speaker units
Enclosure type
Impedance
Subwoofer (1)
Control box (1)
Connecting Cable (1)
Woofer
VOLUME: Controls total volume level.
•
•
•
•
Use the specified clamp (hollow wall anchor,
not supplied) when attaching to plasterboard.
Refer to the supplied operating instructions
using a hollow wall anchor.
Use wall anchors of at least 20 kg hanging
capacity.
16 cm, cone type
Bass reflex
6 Ω
BASS: Adjusts bass level (Subwoofer)
PHONE: Connect to headphones for personal listening
Amplifier section
Rated output
12 W (10% T.H.D., 1 kHz, 6 Ω)
(Satellite speaker)
Refer to the instruction supplied with hollow
wall anchor.
80 W (10% T.H.D., 100 Hz, 6 Ω)
(Subwoofer)
Satellite speaker (2)
Base (2)
Screw (2)
•
•
Requires ø 4 mm hollow wall anchor.
Set up the head of a hollow wall anchor 5 mm
from the wall.
On operation
Input
Stereo mini jack × 1 (INPUT 1)
Stereo mini jack × 1 (INPUT 2)
4.7 kΩ (at 1 kHz)
En g lish
•
Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
Input impedance
Output
Stereo mini jack × 1 (PHONES)
•
Apply a bond (anaerobic threadlocking
material) to the hollow wall anchor to prevent
the screw loosening.
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
A
A
•
Before connecting, turn off the speaker system, the
PC and audio component to avoid damaging the
speaker system.
The volume level should not be turned up to the
point of distortion.
Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards
or floppy disks using magnetic coding in front of the
system for an extended period of time.
General
Dimensions (w/ h/ d) Approx. 130 × 40 × 73 mm
(5 1
Approx. 95 × 135 × 150 mm
(3 3 × 5 3
× 6 in.) (Satellite speaker,
on a desk)
Approx. 95 × 100 × 180 mm
(3 3
in.) (Satellite speaker,
/
8
× 1 5
/
8
× 2 7
/
8
in.) (Control box)
Base
4
Attach the satellite speaker to the w all.
Insert both wall anchors in the anchor holes of the
satellite speaker base.
•
•
WARNING
/
4
/
8
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
Do not place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
Screw
Note
,
/
4
× 4 × 7 1
/
8
Ensure that the satellite speaker is securely
attached to the wall before use.
attached to a wall)
Satellite speaker
Approx. 285 × 285 × 462 mm
(11 1
/
4
× 11 1
/
4
× 18 1
/
4
in.)
The speaker angle can
be changed by
If the TV picture or monitor display is
magnetically distorted
(Subwoofer)
Mass
Approx. 200 g (7 oz.) (Control box)
Approx. 490 g (1 lb. 1 oz.)
(Satellite speaker)
attaching the base
back to front.
Hooking up the system
(See fig. B)
Attach the base with the
anchor holes facing forward
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/ personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/ personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures,
such as data storage, before turning it off.
When there seems to be no improvement, locate the
system farther away from the TV set/ personal
computer. Furthermore, be sure not to place objects in
which magnets are attached or used near the TV set/
personal computer, such as audio racks, TV stands, toys
etc. These may cause magnetic distortion to the picture
due to their interaction with the system.
Approx. 8.2 kg (18 lb. 1 oz.)
(Subwoofer)
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Attach the base with the
anchor holes uppermost
Cord length
2 m (Control box to subwoofer)
2 m (Power cord)
1
2
Connect the cord of the control box to
the 8-pin Din jack of the subw oofer w ith
their respective arrow s aligned.
B
Anchor holes
CAUTION
Power consumptions
31 W
Hollow wall anchors
(ø 4 mm, not supplied)
You are cautioned that any changes or modification not
expressly approved in this manual could void your
authority to operate this equipment.
Supplied accessories
Connecting Cable
Connect the satellite speakers to the
subw oofer.
Confirm the location of the satellite speakers, and
then connect to their respective jacks.
NOTICE FOR THE CUSTOMERS IN THE USA
Optional accessories
Connecting cord RK-G136, RK-G138
Plug adaptor PC-236MS
,
Satellite speaker
Design and specifications are subject to change without
notice.
3
Connect the control box to the source
equipment.
On placement
Screw
Base
40 mm
•
•
Do not set the speakers in an inclined position.
Do not leave the system in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, moisture, rain or mechanical shock.
Do not install the satellite speaker anywhere other
than on a wall.
– PC, etc.:
Connect the INPUT1 jacks of the control box and
the LINE OUT or headphones jack of a PC, etc.
with the supplied connecting cord. For details,
refer to the operating instructions of the PC.
Note
First, be sure to apply a bond (anaerobic
threadlocking material) to the hollow wall
anchor to prevent the screw loosening.
•
•
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
– CD/MD Walkman, etc.:
Do not hang on the satellite speaker or hang anything
on it.
Connect the INPUT2 jack of the control box and
the LINE OUT or headphones jack of a CD/ MD
Walkman, etc. The connecting cord is not supplied
with this system.
5 mm
On cleaning
Do not use alcohol, benzene, or thinner to clean the
cabinet.
7 mm
Note
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
To switch INPUT1 and INPUT2, use ON/ OFF of
the device connected to the control box.
ø 4 mm
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony
dealer.
4
5
Connect the subw oofer to the w all
outlet.
Note
Do not hang on the satellite speaker or hang
anything on it.
9.5 mm or more
Precautions
Position the speakers. (See fig. C)
On safety
The nameplate indicating operating voltage, power
consumption, etc., is located on the rear exterior.
B
•
Before operating the system, be sure that the
operating voltage of the system is identical with that
of your local power supply.
Listening to the sound (See fig. D)
First, turn down the volume on the control box. The
volume should be set to minimum before you begin
playing the programme source.
Connecting cord
(not supplied)
to LINE OUT or
headphones jack
CD/MD
Walkman*, etc
(stereo mini-jack)
to INPUT2 jack
Where purchased
U.S.A./ Canada
Operating voltage
120 V AC, 60 Hz
1
Set the POWER sw itch to ON on the
control box.
The POWER indicator lights up.
European countries 220 – 230 V AC, 50 Hz
Control Box
(rear)
Other countries
• 110 – 120 V AC, 50/ 60 Hz
• 220 – 230 V AC, 50 Hz
to INPUT1 jack
to 8-pin Din jack
•
•
The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To disconnect
the cord, pull the cord by grasping the plug. Never
pull the cord itself.
Should any liquid or solid object fall into the system,
unplug the system’s power cord and have the system
checked by qualified personnel before operating it
any further.
The AC power cord should be changed only at a
qualified service shop.
For efficient heat dissipation, ensure there is sufficient
space to the rear of the subwoofer. Also, avoid
placing objects on the unit.
2
Adjust the VOLUME control on the
control box.
You can adjust the volume of the subwoofer and
each satellite speaker.
When connecting to the headphone output, also
adjust the volume of the connected component.
After listening, set the POWER switch to OFF.
The POWER indicator goes off.
Connecting
Cable
(supplied)
to LINE OUT or
headphones jack
•
Satellite speaker
(rear)
PC, etc.
3
Using headphones/earphones.
Connect headphones/ earphones to the PHONES
jack on the control box.
•
•
Note
Turn off the MEGA BASS or BASS BOOST
(Walkman, etc.) function as it may cause audible
distortion.
to Front R jack
to Front L jack
Subwoofer (rear)
•
Do not insert your hand or any objects into the hole of
the subwoofer.
*
“WALKMAN” is a registered
trademark of Sony Corporation to
represent Headphone Stereo products.
to wall outlet
|