Sony Clock Radio ICF C414 User Manual

For customers who purchased this product in the  
USA  
Important Safety  
Instructions  
Precautions  
Specifications  
Please register this product on line at  
Proper registration will enable us to send you  
periodic mailings about new products, services,  
and other important announcements. Registering  
your product will also allow us to contact you in  
the unlikely event that the product needs  
adjustment or modification. Thank you.  
Play the unit on the power source specified in  
“Specifications.  
Time display  
1) Read these instructions.  
12-hour System  
Frequency range  
Band  
2) Keep these instructions.  
To disconnect the AC power cord (mains lead),  
pull it out by the plug, not the cord.  
The unit is not disconnected from the AC  
power source (mains) as long as it is connected  
to the wall outlet, even if the unit itself has been  
turned off.  
The nameplate and important information  
concerning safety are located on the bottom  
exterior.  
Do not leave the unit in a location near a heat  
source such as a radiator or airduct, or in a  
place subject to direct sunlight, excessive dust,  
mechanical vibration, or shock.  
3) Heed all warnings.  
4) Follow all instructions.  
Frequency  
5) Do not use this apparatus near water.  
6) Clean only with dry cloth.  
FM  
87.5 – 108 MHz  
530 – 1 710 kHz  
7) Do not block any ventilation openings.  
Install in accordance with the manufacturers  
instructions.  
WARNING  
To reduce the risk of fire or electric shock, do  
not expose this apparatus to rain or  
moisture.  
To reduce the risk of fire, do not cover the  
ventilation of the apparatus with newspapers,  
tablecloths, curtains, etc. And do not place lighted  
candles on the apparatus.  
To reduce the risk of fire or electric shock, do not  
expose this apparatus to dripping or splashing,  
and do not place objects filled with liquids, such  
as vases, on the apparatus.  
AM  
Speaker  
8) Do not install near any heat sources such as  
radiators, heat registers, stoves, or other  
apparatus (including amplifiers) that produce  
heat.  
9) Do not defeat the safety purpose of the  
polarized or grounding-type plug. A polarized  
plug has two blades with one wider than the  
other. A grounding type plug has two blades  
and a third grounding prong. The wide blade  
or the third prong are provided for your safety.  
If the provided plug does not fit into your  
outlet, consult an electrician for replacement  
of the obsolete outlet.  
10)Protect the power cord from being walked on  
or pinched particularly at plugs, convenience  
receptacles, and the point where they exit  
from the apparatus.  
11)Only use attachments/accessories specified by  
the manufacturer.  
Approx. 6.6 cm (2 5/8 inches) dia., 8 Ω  
Power output  
180 mW (at 10% harmonic distortion)  
Power requirements  
120 V AC, 60 Hz  
Allow adequate air circulation to prevent  
internal heat build-up. Do not place the unit on  
a surface (a rug, a blanket, etc.) or near  
materials (a curtain) which might block the  
ventilation holes.  
Should any solid object or liquid fall into the  
unit, unplug the unit and have it checked by  
qualified personnel before operating it any  
further.  
To clean the casing, use a soft cloth dampened  
with a mild detergent solution.  
For power backup: 3 V DC, one CR2032 battery  
Dimensions  
Approx. 178.9 × 121.8 × 88.5 mm (w/h/d)  
(71/8 × 47/8 × 31/2 inches) incl. projecting parts and  
controls  
Do not install the appliance in a confined space,  
such as a bookcase or built-in cabinet.  
Mass  
Approx. 638 g (1 lb 6.5 oz) incl. CR2032 battery  
Do not expose the batteries (battery pack or  
batteries installed) to excessive heat such as  
sunshine, fire or the like for a long time.  
Design and specifications are subject to change  
without notice.  
As the main plug is used to disconnect the unit  
from the mains, connect the unit to an easily  
accessible AC outlet. Should you notice an  
abnormality in the unit, disconnect the main plug  
from the AC outlet immediately.  
NOTES ON LITHIUM BATTERY  
Wipe the battery with a dry cloth to assure a  
good contact.  
12)Use only with the cart, stand, tripod, bracket,  
or table specified by the manufacturer, or sold  
with the apparatus. When a cart is used, use  
caution when moving the cart/apparatus  
combination to avoid injury from tip-over.  
Be sure to observe the correct polarity when  
installing the battery.  
Do not hold the battery with metallic tweezers,  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate this  
equipment.  
otherwise a short-circuit may occur.  
If you have any questions or problems concerning  
your unit, please consult your nearest Sony dealer.  
CAUTION  
Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or  
equivalent type.  
13)Unplug this apparatus during lightning storms  
or when unused for long periods of time.  
14)Refer all servicing to qualified service  
personnel. Servicing is required when the  
apparatus has been damaged in any way, such  
as power-supply cord or plug is damaged,  
liquid has been spilled or objects have fallen  
into the apparatus, the apparatus has been  
exposed to rain or moisture, does not operate  
normally, or has been dropped.  
For the state of california, USA only  
Perchlorate Material –special handling may apply, See  
Perchlorate Material: Lithium battery contains  
perchlorate  
Troubleshooting  
Should any problem occur with the unit, make  
the following simple checks to determine whether  
or not servicing is required.  
If the problem persists, consult your nearest Sony  
dealer.  
This symbol is intended to alert the user to  
the presence of uninsulated “dangerous  
voltage” within the product’s enclosure that  
may be of sufficient magnitude to constitute  
a risk of electric shock to persons.  
The clock flashes “AM 12:00.  
A power interruption occurred and the backup  
battery is low. Replace the battery. Remove the  
old battery and install a new one.  
This symbol is intended to alert the user to  
the presence of important operating and  
maintenance (servicing) instructions in the  
literature accompanying the appliance.  
The buzzer, radio or melody alarm does not  
sound at the preset alarm time.  
Check that the buzzer, radio or melody alarm is  
activated (the ALARM A (or B) indicator lights  
up).  
INFORMATION  
The radio alarm is activated but does not  
sound at the preset alarm time.  
This equipment has been tested and found to  
comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection  
against harmful interference in a residential  
installation. This equipment generates, uses and  
can radiate radio frequency energy and, if not  
installed and used in accordance with the  
Features  
Large, easy to-see, 1.4 inch green LED.  
Dual alarm FM/AM Clock radio.  
Various types of alarms — buzzer, radio and  
melody.  
Automatic time set — When you plug the clock  
in for the first time, the current time will be  
shown in the display.  
Automatic Daylight Saving Time/Summer time  
adjustment.  
Check that the volume is not set to minimum.  
When daylight saving time begins, the clock  
does not employ the daylight saving time  
automatically.  
Make sure the clock is set correctly.  
Press and hold DST for at least 3 seconds to  
activate the automatic DST/summer time  
adjustment.  
instructions, may cause harmful interference to  
radio communications. However, there is no  
guarantee that interference will not occur in a  
particular installation. If this equipment does  
cause harmful interference to radio or television  
reception, which can be determined by turning  
the equipment off and on, the user is encouraged  
to try to correct the interference by one or more  
Date button to display month, day and year.  
Brightness control (High/Middle/Low).  
No Power No Problem™ alarm system to keep  
the clock and the alarm operating during a  
power interruption with a CR2032 battery  
installed.  
Extendable snooze — Snooze time can be  
extended from 10 up to 60 minutes.  
Progressive Alarm Speed (buzzer only).  
of the following measures:  
— Reorient or relocate the receiving antenna.  
— Increase the separation between the equipment  
and receiver.  
— Connect the equipment into an outlet on a circuit  
different from that to which the receiver is  
connected.  
— Consult the dealer or an experienced radio/TV  
technician for help.  
WARNING  
Replace the battery for the clock backup with a  
Sony CR2032 lithium battery. Use of another  
battery may present a risk of fire or explosion.  
Battery may explode if mistreated. Do not  
recharge, disassemble or dispose of in fire.  
Dispose of used battery promptly. Keep away  
from children.  
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset  
to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.  
 

Sentry Industries Calculator CA656 User Manual
Sharp Computer Monitor LL T15S1 User Manual
Sigma Projector projetor User Manual
Sony Computer Monitor LMD 170WS User Manual
Sony Printer DPPFP75 User Manual
Sony Stereo Receiver 3 755 967 111 User Manual
SpectraLink Cordless Telephone 72 1065 01 User Manual
Sylvania Flat Panel Television LC320SL1 User Manual
Sylvania TV VCR Combo SRC2213E User Manual
T+A Elektroakustik Stereo Receiver K1 AV User Manual