Sony Cassette Player CFD G505BLACK User Manual

CAUTION  
Music discs encoded with  
Basic Operations  
The use of optical instruments with this product will  
increase eye hazard.  
2-663-603-11(1)  
copyright protection technologies  
This product is designed to playback discs that  
conform to the Compact Disc (CD) standard. Recently,  
various music discs encoded with copyright protection  
technologies are marketed by some record companies.  
Please be aware that among those discs, there are some  
that do not conform to the CD standard and may not be  
playable by this product.  
Tips  
To  
Press  
• Adjusting the volume or the audio emphasis will not affect the  
recording level.  
• For the best results, use the AC power as a power source for  
recording.  
Information  
For customers in the USA  
Pause playback  
on the unit (on the remote)  
. To resume play, press it again.  
CD Radio  
This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant  
to Part 15 of the FCC Rules. These limits are designed  
to provide reasonable protection against harmful  
interference in a residential installation. This equipment  
generates, uses, and can radiate radio frequency energy  
and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that  
interference will not occur in a particular installation. If  
this equipment does cause harmful interference to radio  
or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged  
to try to correct the interference by one or more of the  
following measures:  
• To erase a recording, proceed as follows:  
1 Insert the tape whose recording you want to erase.  
2 Make sure that “TAPE” is displayed. (If “TAPE” is not displayed,  
Stop playback  
.  
Cassette-Corder  
Operating Instructions  
Go to the next  
track  
.  
press  
on the unit or press FUNCTION  
on the remote  
until it appears in the display.)  
US  
Go back to the  
previous track  
.  
For customers in the USA  
Please register this product on line at  
3 Press   
on the unit.  
Locate a point  
while listening to  
the sound  
(forward) or (backward)  
while playing and hold it until  
you find the point.  
Proper registration will enable us to send you periodic  
mailings about new product, services and other  
important announcements. Registering your product  
will also allow us to contact you in the unlikely event  
that the product needs adjustment or modification.  
Thank you.  
Owner’s Record  
The model number is located at the bottom and the serial number is located in the battery compartment.  
Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer  
regarding this product.  
Locate a point  
while observing  
the display  
(forward) or (backward)  
in pause and hold it until you  
find the point.  
Model No.  
Serial No.  
Locate a specific  
track directly  
The number button of the track  
on the remote.  
— Reorient or relocate the receiving antenna.  
— Increase the separation between the equipment and  
receiver.  
— Connect the equipment into an outlet on a circuit  
different from that to which the receiver is connected.  
Remove the CD  
PUSH OPEN/CLOSE .  
Printed on 100% recycled paper  
using VOC (Volatile Organic  
Compound)-free vegetable oil  
based ink.  
Tip  
CFD-G505  
© 2006 Sony Corporation  
When you locate a track numbered over 10, press >10  
on the  
remote first, then the corresponding number buttons  
Example: To play track number 23, press >10 first, then 2 and 3.  
on the remote.  
Printed in China  
— Consult the dealer or an experienced radio/TV  
technician for help.  
Note  
You cannot locate a specific track if “SHUF” or “PGM” is lit in the  
This device complies with Part 15 of the FCC rules.  
Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference, and  
(2) this device must accept any interference received,  
including interference that may cause undesired  
operation.  
display. Turn off the indication by pressing  
.
WARNING  
Listening to the radio  
To reduce the risk of fire or electric  
shock, do not expose this apparatus to  
rain or moisture.  
1 Press RADIO BAND•AUTO PRESET  
on the  
You are cautioned that any changes or modifications  
not expressly approved in this manual could void your  
authority to operate this equipment.  
unit (BAND  
on the remote) repeatedly.  
*VOL + , ,   
and 5  
on the remote have a tactile  
Each time you press the button, the indication changes  
as follows:  
dot.  
To reduce the risk of fire, do not cover the ventilation of  
the apparatus with newspapers, tablecloths, curtains, etc.  
And do not place lighted candles on the apparatus.  
“FM” “AM”  
Notes on DualDiscs  
until the frequency  
A DualDisc is a two sided disc product which mates  
DVD recorded material on one side with digital  
audio material on the other side. However, since the  
audio material side does not conform to the Compact  
Disc (CD) standard, playback on this product is not  
guaranteed.  
2 Hold down TUNE + or –  
digits begin to change in the display.  
To reduce the risk of fire or electric shock, do not  
place objects filled with liquids, such as vases, on the  
apparatus.  
Before using the unit  
This symbol is intended to alert the  
user to the presence of uninsulated  
“dangerous voltage” within the product’s  
enclosure that may be of sufficient  
magnitude to constitute a risk of electric  
shock to persons.  
The unit automatically scans the radio frequencies  
and stops when it finds a clear station.  
If you cannot tune in a station, press TUNE + or –  
repeatedly to change the frequency step by step.  
When an FM stereo broadcast is received, “ST”  
appears.  
To turn on/off the power  
Press POWER  
Connect the apparatus to an easily accessible AC  
outlet. Should you notice an abnormality in the  
apparatus, disconnect the main plug from the AC outlet  
immediately.  
.
To adjust the volume  
Press VOL +, –  
.
This symbol is intended to alert the user  
to the presence of important operating  
and maintenance (servicing) instructions  
in the literature accompanying the  
appliance.  
Do not install the appliance in a confined space, such as  
a bookcase or built-in cabinet.  
Tip  
If the FM broadcast is noisy, press MODE  
To listen through headphones  
Connect the headphones to the (headphones) jack .  
until “Mono” appears  
in the display and the radio will play in monaural.  
To select the sound characteristic  
Press SOUND  
repeatedly to select the audio  
emphasis you want.  
Playing a tape  
Use buttons on the unit for the operation.  
Choose  
To get  
1 Press   
on the unit, and insert the tape into  
Powerful, clean sounds, emphasizing  
low and high range audio  
the tape compartment with the side you want to  
play facing upward. Use TYPE I (normal) tape  
only. Close the compartment.  
Light, bright sounds emphasizing high  
and middle range audio  
Power sources  
Specifications  
Make sure there is no slack in the tape to avoid  
damaging the tape or the unit.  
Percussive sounds, emphasizing bass  
audio  
Battery life  
For CD radio cassette-corder:  
AUDIO POWER SPECIFICATIONS  
The presence of vocals, stressing  
middle range audio  
POWER OUTPUT AND TOTAL HARMONIC DISTORTION  
With 3.2-ohm loads, both channels driven from 150 - 10 000 Hz; rated 3 W  
per channel-minimum RMS power, with no more than 10 % total harmonic  
distortion in AC operation.  
FM recording  
The whole dynamic range for music  
such as classical music  
Sony R20P: approx. 6 h  
Sony alkaline LR20: approx. 18 h  
Tape playback  
Woofer with 4-ohm loads, driven at 50 - 150 Hz; rated 6 W minimum RMS  
power, with no more than 10 % total harmonic distortion in AC operation.  
Other specifications  
Sony R20P: approx. 1.5 h  
Sony alkaline LR20: approx. 6 h  
CD playback  
Sony R20P: approx. 1 h  
Sony alkaline LR20: approx. 4 h  
To reinforce the bass sound  
Press POWER DRIVE WOOFER (WOOFER on  
CD player section  
System  
Compact disc digital audio system  
Laser diode properties  
Emission duration: Continuous  
Laser output: Less than 44.6 µW  
(This output is the value measured at a distance of  
about 200 mm from the objective lens surface on the  
optical pick-up block with 7 mm aperture.)  
Number of channels  
the remote)  
the display.  
to select  
or  
on  
2 Press   
on the unit.  
is more effective. When the  
2 to a wall outlet  
WOOFER function works, the ring on the front panel  
lights up.  
To return to normal sound, press the button repeatedly  
until the indication disappears from the display.  
The unit starts playing.  
1 to AC IN  
Dimensions  
To  
Press  
Approx. 530 × 241 × 369 mm (w/h/d)  
(20 7  
Mass  
/8  
× 9 1 × 14 5  
/2 /8 inches) (incl. projecting parts)  
Pause playback  
on the unit. To resume play,  
press it again.  
Connect the AC power cord or insert eight R20 (size D) batteries (not supplied) into the battery compartment .  
Approx. 8.0 kg (17 lb. 10 oz) (incl. batteries)  
Supplied accessories  
AC power cord (1)  
2
Notes  
Frequency response  
20 - 20 000 Hz +1/–2 dB  
Wow and flutter  
• While the sleeping timer is on, the ring does not light, even if the  
WOOFER function is used.  
• When you use the headphones, the WOOFER function does not  
work.  
Notes  
Stop playback  
on the unit.  
  
Remote control (1)  
• Replace the batteries when the OPR/BATT indicator dims or when the unit stops operating.  
Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the unit.  
• To use the unit on batteries, disconnect the AC power cord from the unit.  
• When you operate the unit on batteries, you cannot turn on the unit using the remote.  
Fast-forward or  
rewind  
or (fast forward or  
rewind) on the unit.  
Below measurable limit  
Design and specifications are subject to change without notice.  
Radio section  
Frequency range  
FM: 87.5 - 108 MHz  
AM: 530 - 1 710 kHz  
Antennas  
Optional accessories  
Sony MDR headphones series  
Eject the cassette  
on the unit.  
  
Playing a CD  
FM: Telescopic antenna  
AM: Built-in ferrite bar antenna  
1 Press PUSH OPEN/CLOSE  
on the unit,  
Recording on a tape  
Cassette-corder section  
Recording system  
4-track 2 channel stereo  
Preparing the remote  
and place a disc with the label side up on the CD  
compartment.  
Use buttons on the unit for the operation.  
Insert two R03 (size AAA) batteries (not supplied).  
Fast winding time  
Approx. 120 s (sec.) with Sony cassette C-60  
Frequency response  
To close the CD compartment, press PUSH OPEN/  
on the unit to open the tape  
compartment and insert a blank tape with the side  
you want to record on facing upward. Use TYPE I  
(normal) tape only. Close the compartment.  
1
Press   
CLOSE  
on the unit.  
TYPE I (normal): 70 - 13 000 Hz  
General  
Speaker  
2 Select the program source you want to record.  
Full range: 10 cm (4 in.) dia., 3.2 , cone type (2)  
Woofer: 10 cm (4 in.) dia., 4 , cone type (1)  
Input  
LINE IN jack (stereo minijack): Minimum input level 330 mV  
Outputs  
Headphones jack (stereo minijack)  
For 16 - 68 impedance headphones  
Power output  
4 W + 4 W (at 3.2 , 10% harmonic distortion)  
Woofer:  
To record from the CD player, press   
and place a CD.  
on the unit  
Replacing batteries  
To record from the radio, tune in the station you want  
(see “Listening to the radio”).  
With normal use, the batteries should last for about six months. When the remote no longer operates the unit, replace all  
the batteries with new ones.  
3 Press   
on the unit to start recording (is  
depressed automatically).  
12 W (at 4 , 10% harmonic distortion)  
Power requirements  
For CD radio cassette-corder:  
120 V AC, 60 Hz  
.
2 Press  
The unit plays all the tracks once.  
on the unit (  
on the remote)  
To  
Press  
Pause recording  
on the unit.  
Press the button again to  
resume recording.  
12 V DC, 8 R20 (size D) batteries  
For remote control:  
3 V DC, 2 R03 (size AAA) batteries  
Power consumption  
AC 30 W  
Stop recording  
 on the unit.  
Track  
number  
Playing  
time  
 

Sharp Microwave Oven R 22AM User Manual
Silex technology Network Card SX 5000U2 User Manual
Singer Sewing Machine AG Series User Manual
Sony GPS Receiver NV U44 User Manual
Sony Universal Remote RM X302 User Manual
Sound Dynamics Speaker FS 25B User Manual
Speco Technologies Security Camera HT 7816DNV User Manual
Stanley Black Decker Automobile Parts TJ10 User Manual
Star Manufacturing Waffle Iron SWB7R1E User Manual
Stovax Stove 705088 User Manual