TIPS
Back
The supplied clamps can be attached to the stand rods and shelf board
bar to hold the cables.
Clamp position
Clamp
Operation Manual
TROLLEY STAND PN-ZS701
Specifications
Applicable models (as of September 2011) LCD MONITOR PN-L702B
(Available models differ according to region.)
Units: mm (inch)
Model
PN-ZS701
(Note that the values shown are approximate values.)
Height
4 positions
●
Thank you for purchasing a SHARP product.
adjustment
Center height of the screen
Approx. 1310 mm (51-9/16 inch) [A],
approx. 1210 mm (47-5/8 inch) [B],
approx. 1110 mm (43-11/16 inch) [C],
approx. 1010 mm (39-3/4 inch) [D]
(Depends on the position of the mounting
brackets attached in Step 1-(4).)
See the diagram at right
Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section “To
ensure safe and correct use”. After reading the manual, keep it in a convenient location where it can be accessed at any time.
TIPS
- This product was shipped after strict quality control and inspection; however, if breakage or a malfunction should be found,
contact your SHARP dealer or your nearest customer contact.
- Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a
third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is
recognized under law.
Dimensions
Weight
Approx. 48 kg (105.8 lbs.)
- This product and its accessories may be upgraded without advance notice.
As a part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes
for product improvement without prior notice. The
performance specification figures indicated are nominal
values of production units.
To ensure safe and correct use
This operation manual and the product use various displays and labels to ensure safe use. Ignoring these displays and labels
and incorrectly using the product could have results as classified below.
There may be some deviations from these values in individual
units.
Please read the following warning symbol information before reading the rest of this section, and be sure to strictly observe all
instructions.
Not following these instructions could result
in death or serious injury.
Not following these instructions could result
in injury or property damage.
Warning:
Caution:
1980 (77-15/16)
• The installation must be performed by qualified service
personnel.
• Do not climb onto or lean on the stand and monitor.
Toppling may occur, causing injury.
Improper installation work may cause the monitor to fall or
topple over, resulting in injury.
• If deformation or cracks are discovered, stop using the
stand.
• Do not place the stand on an unstable surface.
Do not subject to intense shock or vibration.
Toppling or falling may occur, causing injury.
Using the stand without repairing the problem may cause
the monitor to fall or the stand to topple, resulting in injury.
• Take suitable preventative measures to reduce the risk
of this product falling or toppling due to an earthquake
or other circumstances.
• Only use this product with specified models. Do not
modify the stand or the accessories.
Otherwise, the monitor may fall or the stand may topple
over, resulting in injury.
The equipment for preventing falling and toppling will not
be effective if the wall or table to which the equipment is
attached is not sufficiently strong. Reinforce the wall or
table sufficiently. These measures to prevent falling and
toppling are intended to reduce the risk of injury and other
harm, however, their effectiveness is not guaranteed in all
earthquakes.
• Lock the casters when using the stand.
Toppling may occur, causing injury.
• Do not transport the stand with a monitor attached.
If the monitor mounting attachments become broken or
damaged, the monitor may fall or the stand may break or
topple, resulting in injury.
• Use the supplied screws. Tighten all screws firmly.
Insufficient tightening may cause the monitor to fall or the
stand to topple over, resulting in injury.
Printed in China
TINSE1212MPZZ(1)
– 4 –
– 1 –
|