Using the Carpet Glider
The amazing Carpet Glider accessory allows you to
freshen and deodorize all your carpets and rugs with
the sanitizing power of steam!
To use:
1. Attach the mop head to the micro-fiber cleaning
pad.
2. Place the mop head, with cleaning pad
attached, on top of the carpet glider.
3. Plug the power cord into a 120-volt electrical
outlet.
4. Begin freshening your carpet or rug by pushing
the mop and glider in a forward and backward
motion, releasing steam as you go.
5. When you have finished freshening your carpet
or rug, unplug the steam mop and remove the
mop from the carpet or rug.
PLEASE NOTE: Move the mop and carpet glider
along the carpet or rug in a continuous motion until
you are finished. Please note, this product is not
intended to be a carpet cleaner, only a carpet
freshener. DO NOT leave the mop in one stationary
position.
Mop Head
Micro-Fiber
Cleaning Pad
Carpet Glider
IMPORTANT
ALWAYS vacuum carpet thoroughly before using the steam
mop.
DO NOT use without the following:
•
•
•
The carpet glider under the mop head
Micro-fiber cleaning pad attached to the mop head
Water in the water tank.
ALWAYS insure that the unit is “UNPLUGGED” from the
electrical socket prior to filling with water and attaching the
micro-fiber cleaning pad to the bottom of the mop head.
PLEASE NOTE: When using for the first time, water in the tank
must make its way through the pump to the heater. In order to
initiate this process, you may be required to pump the handle a
few times release the steam.
Read owners manuals for complete instructions on use and
care of Shark Steam Mop.
If you have questions, please contact EURO-PRO customer
service at 1 (800) 798-7398.
Copyright EURO-PRO Operating LLC 2007
Model S3101
Rev. 08/07
|