Application Note
LSP 500 PRO
AN IS-1004 v1.0
WLAN Router Reference
To control the LSP 500 PRO via an iPad, a wireless network (WLAN) is required. In order to setup a WLAN for wirelessly controlling the
LSP 500 PRO, you need a router which meets certain requirements. That is why we advise using only tested and recommended routers.
A stable and reliable wireless control of the LSP 500 PRO is not possible with routers which are not compatible.
For more information, please refer to the following sections of the LSP 500 PRO manual “Operating the LSP 500 PRO via a tablet” and
“The operating menu / WLAN”.
Router Specifications
802.11 b/g compatible 2.4GHz WLAN Router, DHCP functionality, UDP multicast support, open or WPA2 protected WLAN
Recommended routers
These two models have been tested thorougly by us and have achieved the best performance regarding range, stability and reliability.
We expressly recommend using one of these two models. Furthermore, it is important to perform the initial configuration recommended
by the manufacturer. For further information refer to the instruction manual of the router or the website of the manufacturer.
Initial configuration
Brand
Apple
Model
Tested Firmware
with an iPad possible?
Comments
Airport Extreme
A1521
yes, first time OK then
Airport config App
required
Buffalo
WHR-HP-G300N
DD-WRT v24SP2
yes
DD-WRTas standard firmware!
Compatible routers
Initial configuration
Brand
Allnet
Model
Tested Firmware
1.0 Release 04
with an iPad possible?
Comments
ALL02761
yes
slow recognition of LSPs
Apple
Airport Express
A1264
yes, first time OK then
Airport config App
required
old plug model
new desk model
Apple
Airport Express
A1392
yes, first time OK then
Airport config App
required
Asus
RT-N13U
DIR-826L
2.0.2.0
1.01
Popup on iPad - connection on WAN-
Port needed
D-Link
no
Multicasting must be enabled
over menu (Network->Advanced-
>Advanced Network->Enable IPv4
Multicasting)
Linksys
Netgear
E1200
2.0.04
yes (manual configuration)
yes
WNDR3700v4
1.0.1.32
iPad shows hotspot screen on first
connect but then works
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
AN IS-1004 v1.0 | 1/1
|