™
Shower Radio
OWNER’S MANUAL
MODELS: WT50BL, WT50OR,
WT50PL, WT50RD, WT50GY, WT50PB
™
USING THE WET TUNES STAND
™
TO ATTACH: Lower Wet Tunes Shower Radio onto Stand pressing
it downward against the Spring Loaded Bar. Match the Slot on the
Radio with the Hooked Tab on the Stand, pushing unit backward
and into Slot, then lifting up slightly until it clicks into place.
TO RELEASE: Push downward on the Radio and pull it forward
and off of the Stand.
*Color reference: BL, OR, PL, RD, GY, PB.
Slot
Hooked
Tab
Stand
P/N 10043*
Spring Loaded Bar
2
WALL MOUNTING WITH ADHESIVE
1. Select a spot on the wall that is as smooth as possible, such as a
smooth ceramic tile. Thoroughly clean the spot of all soap, oil or
other films using a household cleaning solvent such as Acetone or
nail polish remover. DO NOT use the tile cleaner or other wax-
based substances. Allow area to dry completely. Room
temperature should be at 60 to 70ºF.
2. For best results, hold adhesive tube (supplied) at a 45-degree angle
and apply sealant to Mounting Plate, approximately 1/8” bead and
1/4” from edges. Use entire contents. If additional adhesive is
required, use silicone caulking compound or you may order extra
adhesive packets. (P/N 01005)
3. Place Mounting Plate against clean wall surface using enough
pressure to displace air, but not adhesive.
4. Allow adhesive to cure for 24 hours.
5. Slide the Radio onto the secured Mounting Plate.
WALL MOUNTING WITH ADHESIVE
WALL MOUNTING WITH SCREWS
Mounting
Plate
Adhesive
Bead
(10040*)
Earphone
Jack
Mounting
Plate
(10040*)
Wall
Wall
Earphone
Jack
4 Screw 4 Mounting
Sockets
Screws
WALL MOUNTING WITH SCREWS
1. Place Mounting Plate against a clean wall surface and mark the
spots on the wall where you will be drilling. Remove the Mounting
Plate from the wall.
2. Drill 4 holes in the wall that match the placement of the holes in the
Mounting Plate.
3. Insert a Screw Socket into each of the 4 holes.
4. Place Mounting Plate against the wall in the correct position and
drill in the 4 Screws.
5. Slide the Radio onto the secured Mounting Plate.
*Color reference: BL, OR, PL, RD, GY, PB.
3
SET AND MODE FUNCTIONS
To Set the Month/Day: Press SET to arrive at Month position. Press
or hold the MODE Button until the correct Month appears. Press SET
again to arrive at Day position. Press or hold the MODE Button until
the correct Day appears.
To Set the Hour/Minutes: Press SET to arrive at Hour position with
A=AM or P=PM to the right. Press or hold the MODE Button until the
correct Hour appears. Press SET to arrive at Minutes position. Press
or hold the MODE Button until the correct Minutes appear. Press SET
then MODE to return to the Normal Display (Hour : Minutes) with the
flashing colon.
To View Month/Day and Seconds: From the Normal Display (Hour:
Minutes), press MODE once to view Month/Day. Press MODE twice
to view Seconds.
Alternating Mode: From the Normal Display (Hour : Minutes), press
SET once to alternate viewing the Hour/Minutes and Month/Day.
4
ONE-YEAR LIMITED WARRANTY
This Salton, Inc. product warranty extends to the original consumer purchaser of the product.
Warranty Duration: This product is warranted to the original consumer purchaser for a
period of one (1) year from the original purchase date.
Warranty Coverage: This product is warranted against defective materials or
workmanship. This warranty is void if the product has been damaged by accident, in
shipment, unreasonable use, misuse, neglect, improper service, commercial use, repairs
by unauthorized personnel or other causes not arising out of defects in materials or
workmanship. This warranty is effective only if the product is purchased and operated in
the USA, and does not extend to any units which have been used in violation of written
instructions furnished by Salton, Inc., or to units which have been altered or modified or
to damage to products or parts thereof which have had the serial number removed,
altered, defaced or rendered illegible.
Warranty Disclaimers: This warranty is in lieu of all warranties expressed or implied and
no representative or person is authorized to assume for Salton, Inc. any other liability in
connection with the sale of our products. There shall be no claims for defects or failure of
performance or product failure under any theory of tort, contract or commercial law including,
but not limited to, negligence, gross negligence, strict liability, breach of warranty and breach of
contract. Some states do not allow the exclusion or limitations of implied warranties or
consequential damages, so the above limitations or exclusions may not apply to you.
Salton, Inc. is not responsible or liable for indirect, special or consequential damages arising out
of or in connections with the use or performance of the product or other damages with respect
to loss of property, or loss of revenues or profit.
Legal Remedies: This warranty gives you specific legal rights, and you may also have other
rights that vary from state to state.
Warranty Performance: During the above one-year warranty period, a product with a
defect will be either repaired or replaced with a reconditioned comparable unit (at Salton,
Inc.’s option) when the product is returned to the Salton, Inc. facility listed below. The
repaired or replacement product will be in warranty for the balance of the one-year
warranty period and an additional one-month period. No charge will be made for such
repair or replacement.
Service and Repair
If service is required, you should first call toll-free 1-800-233-9054 between the hours of
8:00 am and 5:00 pm Central Standard Time and ask for CONSUMER SERVICE. Please refer
to Model WT50 when you call.
In-Warranty Service for a product covered under the warranty period, no charge is made
for service and return postage. Please return the product insured, packaged with
sufficient protection, and postage and insurance prepaid to the address listed below. Call
for return authorization.
Out-of- Warranty Service: There will be charges rendered for repairs made to the product
after the expiration of the aforesaid one (1) year warranty period, after purchaser is
advised appropriately. Include $6.00 (U.S.) for return shipping and handling.
Salton, Inc. cannot assume responsibility for loss or damage during incoming shipment.
For your protection, carefully package the product for shipment and insure it with the
carrier. Be sure to enclose the following items with your unit: any accessories related to
your problem; your full return address and daytime phone number; a note describing the
problem you experienced; a copy of your sales receipt or other proof of purchase to
determine warranty status. C.O.D. shipments cannot be accepted.
Return the appliance to: ATTN: Repair Department, Salton, Inc.
708 South Missouri St. Macon MO, 63552
For more information on Salton, Inc. products, visit our website:
Printed in China
©2001 Salton, Inc.
P/N 60623A
|