RocketFish Switch RF 30HUB7 User Guide

Thank you for purchasing the Rocketfish SuperSpeed 7-port USB 3.0  
Hub.  
Installing your hub  
FCC Part 15  
Note: Make sure that the driver for your existing USB 3.0 controller  
has been installed on the computer. When you connect your hub  
to a computer, the computer detects your hub and automatically  
installs it.  
This equipment has been tested and found to comply with the  
limits for a Class B digital device, pursuant to Part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy  
and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of the  
following measure:  
Features  
• Adds seven USB 3.0 ports to your USB 3.0 enabled computer.  
1 Slide open the cable compartment cover on the back side of  
your hub, pull out the USB cable, then plug the cable into any  
available USB 3.0 port of the computer.  
Note: You can purchase a USB 3.0 cable (A male to A female) to  
extend the length of cable.  
• Supports ultra-fast data transfer rates of up to 5 Gb/s (10 times  
faster than USB 2.0).  
• Is backward compatible with USB 2.0 and USB 1.1 devices.  
• Supports Microsoft® Windows® 7, Windows Vista®, and Windows®  
XP operating systems .  
• Supports MAC OS X version 10.4 or higher operating system (USB  
2.0 only).  
• Works with high-bandwidth SuperSpeed USB 3.0 devices, such as  
external hard disks, high resolution webcams, camcorders, video  
surveillance cameras, digital video cameras, multi-channel audio,  
and more.  
SuperSpeed 7-port USB 3.0 Hub  
RF-30HUB7  
– Reorient or relocate the receiving antenna.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on a circuit different from  
that to which the receiver is connected.  
USB 3.0  
cable  
• Has hot swappable and Plug & Play capability.  
– Consult the dealer or an experienced radio/TV technician for  
help.  
• Has over-current protection built into each port to protect both  
connected devices and your hub from power surges.  
• Complies with Universal Serial Bus 3.0 Specification, Revision 1.0.  
2 Plug the AC power adapter into your hub’s DC jack and into a  
power outlet. The driver installs automatically and the power  
LED lights. Your hub is ready for use.  
Caution: Only use the AC power adapter specified by the  
manufacturer.  
SAFETY: General Power Safety  
Caution:  
Package contents  
• SuperSpeed 7-port USB 3.0 HUB  
• AC power adapter  
• Check the voltage rating before you connect the equipment to  
an electrical outlet to ensure that the required voltage and  
frequency match the available power source.  
• Place the AC adapter in a ventilated area, such as a desk top or  
on the floor. Do not cover the AC adapter with papers or other  
items that will reduce cooling.  
• AC adapters can become very hot and could cause burns or fire  
hazards. Make sure to use them properly.  
• Do not use an AC adapter with frayed or exposed wires.  
• AC adapter can cause a fire or chemical hazard if not used  
properly. Do not disassemble.  
Quick Setup Guide  
Specifications  
Interface  
1 upstream USB port:  
Components  
USB 3.0 A plug (with cable)  
7 downstream USB ports:  
USB 3.0 A receptacle  
DC jack  
Dimension (W × H × D)  
4.35 × 4.17 × 1.42 in.  
(11.05 × 10.6 × 3.6 cm)  
• If you use an extension cord, ensure that the total ampere rating  
of the products plugged in to the extension cord does not  
exceed the ampere rating of the extension cord.  
Weight  
140 g  
Interface to PC  
Interface to Device  
Data transfer rate  
USB 3.0  
USB 3.0  
FCC Part 15  
USB 3.0 : 5.0 Gb/sec  
USB 2.0 : 480 Mb/sec  
Changes or modications not expressly approved by the party  
responsible for compliance could void the user’s authority to  
operate the equipment.  
Indicator  
Power LED indicator  
AC Power Adapter 12V/3A  
DC+5V  
USB 3.0  
ports  
USB 3.0  
ports  
Power source  
Output voltage per-port  
Output current per-port  
System support  
One-year limited warranty  
900mA (Max)  
Windows XP  
Windows Vista  
Windows 7  
MAC OS X version 10.4 or higher  
Contact Rocketfish:  
For customer service, call 1-800-620-2790  
Operating temperature  
Operating humidity  
Certification  
32° ~ 104°F (0° ~ 40°C)  
20 % ~ 80 % RH  
USB 3.0 ports  
© 2011 BBY Solutions, Inc., All Rights Reserved.  
FCC Class B, ICES-003, CE  
Distributed by Best Buy Purchasing, LLC  
7601 Penn Avenue South, Richfield, MN USA 55423-3645  
ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and  
brand names are trademarks of their respective owners.  
System requirements  
• PC or Macintosh computer with an available USB 3.0 port. (You  
can connect to a USB 2.0 port, but your hub will only run at USB  
2.0 speeds.)  
QUICK SETUP GUIDE  
ENGLISH 11-0325  
 

RCA Stereo System RS2127iH User Guide
Reliable Sewing Machine MSK 1341B User Guide
ResMed Network Card 608140 20611 User Guide
Ricoh Window GLD0 0025 01 User Guide
Rinnai Water Heater MSB C2 User Guide
Roland Music Pedal FC 300 User Guide
Rotel Turntable RP 860 User Guide
Samsung Flat Panel Television 570VTFT User Guide
Sanyo Microwave Oven EM S1000 User Guide
Sanyo Projector PLC XW50 User Guide