Thank you for purchasing this high quality
Rocketfish product. Your Bluetooth speaker
represents the state-of-the-art in iPad®
accessories and is designed to integrate
easily into your iPad’s Smart Cover.
Turning on and pairing your
devices
Installing the speaker unit into
the Smart Cover
Turn on the speakers by pushing in on the
side with the power on icon. This should
turn on the unit and automatically put it in
pairing mode. (Repeat the action on the
opposite side to pop out the other speaker
for better audio quality.)
Place the highlighted areas of the speaker
unit and the Smart Cover together in the
orientation illustrated in Step 1, then
proceed with the rest of the steps.
Charging your speakers fully for
the first time
Bluetooth Speaker
for iPad 2
Speaker unit
RF-TRSPIPAD
Smart Cover
Plug the small end of the included USB cable
into the speakers and the other end into an
available USB port on your computer. It
takes approximately four to five hours to
fully charge your speakers.
Note: You can charge your speakers and
listen to audio at the same time.
Established
connection
(Green LED)
To pair with your iPad:
From the Home screen, choose Settings >
General > Bluetooth and turn Bluetooth on.
iPad searches for nearby Bluetooth
accessories.
Choose and Accept the Bluetooth accessory.
This device is identified as RF-TRSPIPAD.
If needed, please refer to your iPad manual
for additional pairing information.
LED is Constant Green if connection is
established with iPad 2.
Charging in
Progress indicator (Constant green LED)
(Red blinking LED)
Full Charge indicator
Note: Speakers will work with
most Bluetooth audio devices.
QUICK SETUP GUIDE
|