ATLINKS Communications Canada, Inc.
c/o Thomson multimedia Ltd.
6200 Edwards Boulevard
Mississauga, Ontario
separate circuit outlets.The user may also
wish to consult a qualified radio/television
technician for additional suggestions.This
equipment has been fully tested and
complies with all limits for Class B
35809
ADJUSTING KEYPAD BEEPS
DISPLAY
BELT CLIP INSTALLATION
AND REMOVAL
IMPORTANT BATTERY
INFORMATION
14-Channel Family
Your radio emits a beep each time while
the buttons are pressed.To turn this sound
OFF, press PAGE while turning the radio
on.To turn this sound ON again, press
PAGE while turning the radio on.
1. Battery icon — Indicates the battery level. When the
batteries are nearly drained, the icon will start to blink
and the unit beeps periodically.
4
2
Radio System
User's Guide
Canada L5T 2V7
•
To install the belt clip, line up the
grooves on the clip with the grooves on
the back of the unit. Push downward
until it snaps into place.
•
Alkaline batteries are recommended for
longer play. Carbon-zinc or nickel
cadmium rechargeable batteries can
substantially reduce play time.
1
5
RX
TX
computing devices pursuant to part 15 FCC
Rules and Regulations.This device
3
The provisions of this written warranty are
in addition to and not a modification of or
subtraction from the statutory warranties
and other rights and remedies contained in
any applicable legislation, and to the
extent that any such provisions purport to
disclaim, exclude or limit any such
statutory warranties and other rights and
remedies, such provisions shall be deemed
to be amended to the extent necessary to
comply therewith.
2. RX icon — Indicates when the unit is receiving a
transmission.
complies with RSS-210 of Industry Canada.
Operation is subject to the following two
conditions: (1)This device may not cause
interference, and (2)This device must
accept any interference, including
CALL
3. TX icon — Indicates when the unit is transmitting.
4. Channel number — Shows the current channel (1-14).
5. CALL icon — Indicates when the unit is paging.
DISPLAY BACKLIGHT
The display automatically lights up with
any key press.The LCD display illuminates
for 12 seconds before turning off.
•
To remove the belt clip, release the
snap with your finger or a tool while
firmly pushing the clip upward.
•
If you’re not going to use your radio for
a month or more, be sure to remove
batteries because they can leak and
damage the unit.
interference that may cause undesired
operation of the device.
BUTTONS AND CONTROLS
•
•
Dispose of batteries in the proper
manner, according to federal, state, and
local regulations.
USING YOUR FAMILY RADIO
1. Turn on power.
AUTO SQUELCH
1. ON/OFF/VOLUME -Turn
SERVICE
counterclockwise to power ON and
increase listening volume. Rotate
clockwise to decrease volume and turn
power OFF.
Your radio is equipped with an automatic
squelch system which automatically
shuts off weak transmissions and
unwanted noise due to terrain conditions
and range limitations.
2. Check the battery condition on the display.
3. Set to desired channel.
Any battery may leak electrolyte if
mixed with a different battery type, if
inserted incorrectly, if all batteries are
not replaced at the same time, if
disposed of in fire, or if an attempt is
made to charge a battery not intended
to be recharged.
ATLINKS Communications Canada, Inc.,
warrants to the purchaser or gift recipient
that if any manufacturing defect becomes
apparent in this product within 1 year
from the original date of purchase, it will
be replaced free of charge, including
return transportation.
If you are unable to find a qualified
servicer for out of warranty service, you
may write to:
8
4. Adjust volume to comfortable level.
ATLINKS Communications
Canada, Inc.
c/oThomson multimedia Inc.
P.O. Box 0944
Indianapolis, Indiana, U.S.A., 46206-
0944
2. PTT (Push toTalk) - press to transmit,
release to receive.
TO TRANSMIT
AUTOMATIC POWER SAVE
Your radio has a unique circuit designed to
dramatically extend the life of the
batteries. If there is no transmission within
5 seconds, your radio switches to the
power save mode.The radio still receives
transmissions in this mode.
3. PAGE - Press to send a call tone to
Press the PTT (PUSH-TO-TALK) button.
Speak slowly and clearly 2-3 inches from
the microphone.To avoid cutting off the
first part of your transmission, pause
slightly after pressing the PTT button
before you start talking.The transmit icon
displays while the unit transmits.
other radios tuned to the same channel.
•
Discard leaky batteries immediately.
Leaking batteries can cause skin burns
or other personal injury.
This warranty does not include damage to
the product resulting from accidents, misuse
or leaking batteries.
1
4. CHANNEL ꢀ - Press to change the
channel to the next higher frequency. If
the current frequency is at 14 (the highest)
the channel will change to 1 when the
CHANNEL ꢀ button is pressed.
5. CHANNEL ꢁ - Press to change the
channel to the next lower frequency. If
current frequency is at 1 (the lowest),
the channel will turn to 14 after
pressing the CHANNEL ꢁ.
Attach your sales receipt to this booklet for
future reference.This information is
required if service is needed during the
warranty period.
2
3
Should your product not perform
properly during the warranty period,
either:
4
INTERFERENCE INFORMATION
This equipment generates and uses radio
frequency energy which may interfere with
residential radio and television reception if
not properly installed and used in
accordance with instructions contained in
this manual. Reasonable protection against
such interference is ensured, although
there is no guarantee this will not occur in
a given installation. If interference is
suspected and verified by switching this
equipment on and off, the user is
encouraged to try to correct the
interference by one or more of the
following measures: Reorient the radio/
television receiver’s antenna, relocate the
equipment with respect to the receiver,
plug the equipment and receiver into
CHANNEL
PAGE
6
We bring good things to life.
1. Return it to the selling dealer with
proof of purchase for replacement,
PURCHASE DATE
_____________________________________________________________________
FREQUENCIES
TO RECEIVE
When you are finished talking, release the
PTT (PUSH-TO-TALK) button to listen to
the incoming transmission.
5
Ch. No
Frequency MHZ
OR
NAME OF STORE
_____________________________________________________________________
7
1
462.5625
2. Remove the batteries (where
applicable), and pack product complete
with accessories in the original carton
(or equivalent).
2
462.5875
6. MIC - Built-in microphone
7. Speaker - Built-in speaker
8. Antenna
3462.6125
TRANSMITTING A CALL
ALERT TONE
Press the PAGE button to initiate an Alert
tone transmission.The Alert tone will
automatically be transmitted for a fixed
length of time.
4
462.6375
462.6625
462.6875
462.7125
467.5625
467.5875
467.6125
467.6375
467.6625
— Mail prepaid (with proof of purchase)
and insured to:
5
BATTERY INSTALLATION
Your radio uses three AA alkaline batteries for power. To install
the batteries:
6
7
8
1. Remove the battery compartment door by sliding it down
from the unit.
9
CHANGING CHANNELS
10
2. Install 3 AA-size alkaline batteries (not included) into the
battery compartment. Make sure to follow the + and - symbols
in the compartment. Installing the batteries incorrectly may
prevent the unit from operating or can damage the unit.
Press the CHANNEL ꢀ or ꢁ buttons to
change channels.The channel may only be
changed during receive mode and cannot
be changed during Call Alert or PTT
transmit mode.
11
12
13467.6875
14
CAUTION: To reduce the risk of fire or personal injury, use
only the battery listed in the instruction book.
467.7125
Model 35809
15845800 (Rev. 4 E/F)
02-24
Printed in China
ATLINKS Communications Canada Inc.
(An Alcatel /Thomson Multimedia Joint Venture)
© 2002 ATLINKS Communications Canada, Inc.
Trademark(s) ® Registered
Marque(s) ® déposée(s)
|