Powermate Battery Charger VTE4000 User Manual

AA/AAA Battery Charger Owner’s Manual  
Model No.: VTE4000  
5.  
Unplug the charger and remove the batteries from the  
charger when not in use.  
Begin against step 1 to charge the next set of  
batteries.  
30 minutes--Worldwide Use--U-Smart Charger  
Your AA/AAA Battery Charger is designed to charge  
Vapex’Tech NiMH rechargeable REGULAR batteries rated to  
2700mAh(AA) or 1000mAh (AAA). The batteries will be  
fully-charged by Microprocessor-Control System in 30  
MINUTES for AA/AAA batteries. You can change 1/2/3/4  
AA/AAA NiMH batteries simultaneously.  
6.  
Bad Cell Detection:  
When charge process is started, the charger detects  
the health status of each of the cells in the battery  
compartment. If any battery is unsuitable for charging  
the status LED will flash.  
This charger is designed to charge Nickel-Metal- Hydride AA,  
AAA size rechargeable batteries. Please note that this  
charger must not be used for Alkaline, Carbon Zinc, Lithium  
or any kind of battery other than Nickel Metal Hydride.  
Charging time :  
Size  
Charging  
current  
Nickel Metal Hydride  
SAVE THESE INSTRUCTIONS  
AA  
AA  
AA  
AA  
AA  
2000mAh 30 minutes  
2100mAh 32 minutes  
2200mAh 33 minutes  
2300mAh 35 minutes  
2400mAh 36 minutes  
2500mAh 38 minutes  
2700mAh 41 minutes  
650mAh 25 minutes  
750mAh 29 minutes  
850mAh 32 minutes  
900mAh 34 minutes  
1000mAh 38 minutes  
CHARGER FEATURES INCLUDE:  
4A  
z
Recharges 1 piece to 4 pieces of AA & AAA  
Ni-MH batteries at a time.  
AA  
AA  
z
Powered by the supplied AC Adaptor when  
using at home or by the supplied DC Car Adaptor when  
using in a vehicle.  
AAA  
AAA  
AAA  
AAA  
AAA  
z
z
z
z
BS(UK) & VDE(EU) interchangeable plugs can be added  
on the US plug  
Microprocessor Controlled – Batteries life well protected  
by –dV detection and timer protection.  
Automatic charging current selection for size AA and  
AAA.  
1.7A  
*Charge time will vary depending upon the brand, capacity  
and condition of batteries being charged.  
LED display for rapid charge/trickle charge/bad cell  
detection  
Specifications:  
Power supply :  
Red LED – rapid charge ;  
Green LED – trickle charge ;  
Flashing Red LED – Cells are not suitable for charging  
i.e. Short circuit or wrong polarity.  
100-240VAC, 50/60 Hz  
International Compatible  
AA size - 4A  
Charge rate :  
AAA size – 1.7A  
Safety features :  
z
z
z
z
z
-dV cut-off function  
Safety timer to prevent over charge  
Thermal cut off  
Reverse-polarity protection  
Bad cell Detection  
Important Safety Instructions  
1.  
2.  
Before charging, read instruction.  
This power unit is intended to be correctly orientated in  
a vertical or floor mount position  
3.  
This  
charger  
is  
intended  
for  
use  
with  
Nickel-metal-hydride rechargeable batteries only.  
Attempting to charge other types of batteries may  
cause personal injury and damage to the charger.  
Do not expose charger to rain or moisture. For indoor  
use only.  
OPERATION INSTRUCTIONS : -  
1.  
2.  
3.  
Insert 1 to 4 pieces of AA/AAA rechargeable Ni-MH  
batteries into the battery compartment.  
Make correct contact for polarity ( + and – ) ; according  
to the sign in the battery compartment.  
4.  
5.  
6.  
Remove from mains when not in use.  
Never use an extension cord or any attachment not  
recommended by manufacturer, otherwise this may  
result in a risk of fire, electric shock or injury to  
persons.  
Do not operate the charger if it has been subjected to  
shock or damage. Take it to a qualified serviceman for  
repair.  
Do not disassemble the charger. Incorrect reassemble  
may result in a risk of electric shock or fire.  
Unplug the charger from outlet before attempting any  
maintenance of cleaning.  
When using at home  
Connect the supplied AC adaptor ‘s barrel plug into  
the jack on the back of the charger. Plug the AC  
adaptor into any available 100-240VAC outlet. The  
switching power supply will adjust automatically, when  
using overseas a plug adaptor may be required.  
Caution: The supplied AC adaptor supplies 12VDC  
and delivers 3.3A, and its plug fits into the charger’s  
DC input jack. Using an adaptor that does not meet  
these specifications could damage the charger or the  
adaptor.  
7.  
8.  
9.  
10. The appliance is not intended for use by young  
children or infirm persons without supervision. Young  
children should be supervised to ensure that they do  
not play with the appliance.  
11. Before scrapping your charger, remove the  
batteries from the unit and they are disposed of  
safety.  
When using in a vehicle  
Connect the supplied DC car adaptor’s barrel plug into  
the charger’s DC input jack. Plug the large end of the  
cord into the 12V car lighter power port.  
4.  
The Red LED will glow to indicate the proper charging.  
After the batteries are fully charged, the red LED will  
turn off and the green LED will light up indicating the  
trickle charge is on. The charged batteries are ready  
for use.  
 

Pentax Film Camera PZ 20 User Manual
Philips Automobile Accessories CRV 1997 2003 User Manual
Philips Battery Charger LR03EB8A User Manual
Philips Stereo Receiver C50 User Manual
Planet Technology Network Router WAP 1966 User Manual
Poulan Lawn Mower PR185H42STG User Manual
Poulan Lawn Mower PR185H42STH User Manual
Poulan Trimmer 545137279 User Manual
Poulan Trimmer PPWT60022X User Manual
ProForm Hot Tub PFHS60070 User Manual