Thank you for choosing this Philips telephone. Your Skip 100 is a
telephone with the facility to store 13 telephone numbers. It can be used as a
main telephone or as an extension telephone.
USER MANUAL
Items supplied:
• Base unit
• Handset with coiled cord
• Line cord
™
• This user manual
• Wall mount bracket/Desk stand
Location of Buttons, Controls and Connectors
1. Wall mount hook
2. Memo card
8
7
6
3. Memo button
4. Memories button
M1, M2, M3
5. Dialling keypad
6. Store button
7. R button
R
2
5
8
1
5
2
M1
M2
M3
3
6
9
1
4
7
1
2
3
4
5
6
7
8
9
0
3
4
0
8. Redial button
M1
M2
M3
skip 100
9
10
•
Convenient Access to
13 Memories
9. Ringer volume switch
10. Recall Switch TBR/ELR
11. Tone/Pulse switch
12. Recess for fixing the
wall mount bracket
11
12
•
•
Cable Management
Easy Wallmount
3140 025 20890
Installation
Connect the handset coiled cord.
Connect the telephone line cord
5. Slide the bracket onto the nails
6. Hang back the set
Wall Mounting
5mm
8.5cm
8.
The telephone can also be used on desk
7.
Setting the dialling mode
1. Drill 2 holes according to the dimension
of the wall mounting bracket and place 2
nails into the wall
2. Insert the wall mount bracket into the
recess as shown
ꢀ
ꢀ
Set the tone/pulse switch to "TONE"
mode or "PULSE"
depending on
which dialling system is used in your exchange. If you are in doubt the dialling
system used, set the telephone to the "TONE"-dialling mode and attempt to
make a call. If the dialling-tone does not cease, then reset the telephone to
"PULSE"-dialling mode. It should then be possible to make a call.
Setting the ringer volume
Adjust the ringer volume to Hi or low by setting the Ringer Hi/Low switch
according to need.
Setting recall mode
3. Take off the handset.
4. Pull out the wall mount hook and turn
it 180 degrees and snap the wall mount
hook back into place
Set the Recall mode switch to T (Flash recall) or E (Earth recall) according
to the specification of your exchange. If in doubt, contact your network operator.
|